Elite Screens Saker Series Guide

Updated 3/8/2017 1 www.elitescreens.com
Circuit Board Replacement Instructions
for Saker / Saker Tension Series
For technical support or further assistance, call 877-511-1211 x604
ATTENTION: Please make sure the version number and the Voltage of the circuit board matches the
version number and the Voltage of the screen. Elite Screens does not recommend making unnecessary
adjustments to the screen, as improper adjustments will damage the unit and void your warranty.
1. Remove the screws on the left end cap (facing the screen) with a Phillips screwdriver, then remove
the end cap.
2. After removing the end cap, press in the clip on the white terminal, then pull out to remove the
two white terminals.
Two white terminals
clip

Updated 3/8/2017 2 www.elitescreens.com
3. Remove the three screws that secure the circuit board with a Phillips head screwdriver. Set the
screws aside to later secure the new circuit board.
4. Utilize the saved screws to secure the new circuit board in same location of the previous.
Two white terminals removed
Three screws

Updated 3/8/2017 3 www.elitescreens.com
5. Insert the two sets of white terminals into the new circuit board.
6. Replace and secure the end cap with screws removed in step 1.
For a local Elite Screens contact or Technical Support, please visit
www.elitescreens.com
Finished assembly.