Page 10 of 14 Ethernet Extension Experts
Performing the On-Site Installation
After removing the Enable-IT 865 PTZ & Extended Ethernet Kit from the box and
performing the out of the box testing all that remains to install the unit on-site is to mount
the unit, build the interconnect wiring, add voice lines if needed and attach the LAN
device cabling with the provided Ethernet Patch cords.
Mounting the Enable-IT 865 PTZ & Extended Ethernet Units
The Enable-IT 865 PTZ & Extended Ethernet Kit is designed for quick wall mounting.
Choose a location to mount each of the Enable-IT 865PTZ’s where the maximum
distance does not exceed 3,500ft or 1,067m total between devices to be connected.
When mounting the Enable-IT 865 PTZ & Extended Ethernet Kit it is recommended
that you use the appropriate anchors for your mounting surface. If mounting on
plywood use wood screws; if mounting onto drywall or sheetrock, use plastic drywall
anchors or Velcro can also be used as the units are very lightweight.
Building the 865PTZ Interlink wiring
The most important aspect of the install is the correct wiring of the Interlink cabling.
For CAT3 wiring (2-pair/6 wires) you will need to crimp a RJ-45 Male Head to each
end of the contiguous wire run and using the following pins(1,2,4,5,7 & 8) straight
through. This will deliver 1 Voice line, Ethernet Data and PoE+. Insert into the
Interlink Port on each 865PTZ unit.
For CAT5e or better wiring (4-pair/8 wires) you will need to crimp a RJ-45 Male Head
to each end of the contiguous wire run and using the following pins(1,2,3,4,5,6,7 & 8)
straight through. This will deliver Dual Voice lines, Ethernet Data and PoE. Insert into
the Interlink Port on each 865PTZ unit. This can be either T-568A or T-568B spec.
Attaching cabling and devices to the Enable-IT 865PTZ Extended Ethernet Kit.
Attach your remote PoE device to the 865PTZ CPE unit LAN/PoE ports with Ethernet
patch cord provided. Attach your local LAN to the 360 PoE injector Data IN port.
Attach the power adapter to the 865 CO unit. Attach the 360 PoE+ injector to the
865PTZ CO LAN1/PoE port with Ethernet patch cord provided. Apply power to the
360 PoE injector with the country power cord provided.Your equipment should now
be powered up and functioning properly.
The LED indicators will provide visual operational status of the 865PTZ units.
Sync - Slow to fast flicker on power up – indicates negotiation of a link.
Solid Green LED indicates link established and rapid pulse is traffic.
Pwr - Solid Green LED indicates that unit is receiving 5v power.
Mode - Solid Yellow LED on CPE unit only – No LED lit on CO
ACT - Yellow LEDs – Lit solid indicates the presence of local LAN
– Blinking indicates the presence of local LAN traffic
For troubleshooting, first examine the backbone wiring pair and make sure you have solid
connections. The Interlink Sync LED will be lit on each 865 unit to show proper
connection and pairing. If the Interlink Sync LED Link is flashing – (Not pulsing)
1) Make sure your wiring is straight through and not connected to any Telco punch
down blocks or a few as possible – they add interference. If your wiring is
spliced, use Telco butt clips or gel filled caps to bridge wire into a solid
connection. A flashing Interlink Sync LED indicated the units are trying to connect to
each other and are looking to synchronize frequencies.
