Enable-IT 865W PRO User manual

All Rights Reserved © 1997 - 2015 Enable-IT™, Inc.
Enable-IT 865W PRO Weatherproof
Professional Grade PoE Extender Kit
Quickstart Guide

All Rights Reserved © 1997 - 2015 Enable-IT™, Inc. Page 2 of 5
INSTALLING THE 865W PRO OUTDOOR KIT
The Enable-IT 865W PRO Weatherproof Ethernet Extenders have a distance restriction of
6,000ft (1,829m) over 2-pair of Category 2, up to 4-pair CAT5e / CAT7, wiring from device
extension to device extension. Therefore a site survey of the wiring and installation planning
are highly recommended. For highest performance use CAT5e rated or higher spec for
interlink wiring.
The Overview Diagram: This diagram shows the contents of the product box inside the rectangle. Devices
outside the rectangle above are your equipment that can be attached.
We highly recommend that you perform a quick out of the box test to ensure the working order of
your Enable-IT 865W PRO Outdoor Ethernet Extender units prior to installing. This will also serve
to familiarize you with how easy the process should be. Follow the steps below to perform the Out
Of the Box Test.
Step 1 - Using a Ethernet patch cord, attach one end to the Data & Power out RJ45 port on the 360 PoE
Injector and the other end to the left side waterproof LAN input on the 865W PRO CO unit.
Step 2 - Next using another Ethernet patch cord, connect both 865W PRO interlink ports. The 865 W
PRO CO unit has the interlink port on the right side and the 865W PRO CPE unit has it’s interlink
on the left side. Power up the 360 PoE Injector. All the units should show a Power LED indicating
the units are receiving power. The LED indicators on the 865W PRO LAN ports will provide
visual| operational status.
LED indicators will provide visual operational status of the 865W PRO Weatherproof units.
Mode – Yellow Solid LED
Off = CO unit
On = CPE unit
Sync – Green slow to fast flicker LED on power up – indicates negotiation of a link
– Green solid LED indicates link established and rapid pulse is traffic
Act – Yellow LED
Off = No device attached or detected
On = Solid, indicates the presence of local LAN
On = Blinking, indicates the presence of local LAN traffic
Power – Green Solid LED indicates the unit is receiving PoE power

All Rights Reserved © 1997 - 2015 Enable-IT™, Inc. Page 3 of 5
The Green Sync LEDs will start flickering slowly and then fast as the units talk to each other. After a
few seconds you should see a solid Green Interlink Sync LED on each unit to confirm a link is
established. This confirms basic proper operation of the units.
Step 3 - Next for a more detailed test and to confirm your LAN Equipment works with the 865W PRO,
connect your Ethernet LAN to the 865W PRO CO unit LAN ports and the remote device/s to the
865W PRO CPE LAN ports and test connectivity. The Green Interlink Sync LED will pulse rapidly
as it detects traffic.
Performing the On-Site Installation
After removing the Enable-IT 865W PRO Weatherproof Ethernet Extender Kit from the box,
and performing the Out Of The Box Testing (OOTBT), all that remains to install the unit on-
site is to mount the unit, build the interconnect wiring and attach the LAN device cabling with
Ethernet Patch cords.
Mounting the Enable-IT 865W PRO Weatherproof Ethernet Extender Units
The Enable-IT 865W PRO Weatherproof extended Ethernet solution is designed for quick wall
mounting. Choose a location to mount each of the Enable-IT 865W PRO Weatherproof’s
where the maximum distance does not exceed 6,000ft (1,829m) total between devices to be
connected. When wall-mounting the Enable-IT 865W PRO The waterproof ports come with a
sealant to be used once the RJ-45 cables are inserted through the compression nut and into
the 865W PRO ports. Category rated twisted pair cable is optimized for high throughput
frequencies isolated from cross-talk noise. Insert the completed RJ-45 ends into the 865W
PRO Weatherproof Interlink port on each 865W PRO Weatherproof unit.
Cabling Devices to The Enable-IT 865W PRO Weatherproof Extended Ethernet Kit
Attach your remote LAN device to the 865W PRO Weatherproof CPE unit LAN ports with
Ethernet patch cord provided. Attach your local LAN to the 865W PRO Weatherproof CO
LAN ports with Ethernet patch cord provided. Attach the power adapters to both 865W PRO
Weatherproof units.
Attach your local Interlink cabling end to the 865W PRO Weatherproof CO unit Interlink port –
Then do the same for the remote end and plug into the 865W PRO Weatherproof CPE unit
Interlink port. The Sync LED’s will flicker in a sequence talking to each other until they go
solid. Your equipment should now be powered up and functioning.
865W PRO CPE Unit
865W PRO CO unit
Pins 1 & 2 for VDSL2
Pins 1,2,4,5 Positive PoE power
Pins 3,6,7,8 Negative PoE power
RJ-45 Interlink Cabling up to 6,000 feet

All Rights Reserved © 1997 - 2015 Enable-IT™, Inc. Page 4 of 5
TECHNICAL SUPPORT
Enable-IT, Inc.’s Customer Care Team support is available directly to customers and distributors.
All support requests are processed through the online support portal. This allows us to provide
assigned support ticket numbers in order to bring closure to any technical issues.
Online Technical Services
The Enable-IT Support Portal is available 24/7 to open a ticket or check the status of one. Please
use this support website as your first source for help as it contains an on-line knowledge base of
articles, documentation, FAQ's and other problem-solving resources. This web-based support
resource provides the quickest solution to the most common technical support issues.
World Wide Web Site
http://support.enableit.com
Returning Products for Warranty Repair
Enable-IT, Inc. warrants to the original purchaser of the Product ("you" or the "End User") that, for
the four (4) year period commencing on the date the Product was purchased (the "Warranty
Period"), the Product will be substantially free from defects in materials and workmanship under
normal use and conditions. Electrical or water damage is not covered under this warranty,
extended warranties or Advanced Replacement Program (AREP).
In order to obtain an authorized RMA approval, the End User must complete the required
information online located at http://support.enableit.com. If you have questions or difficulty
completing this information you may contact the Customer Care Team at 888-309-0910 between
the hours of 8:00 a.m. and 5:00 p.m. PT.
Please ship Authorized RMAs to:
RMA Warranty Repair Processing Facility
16600 Harbor Blvd, Suites H & I
Fountain Valley, CA 92708-1363
Returning Products for Refund
Enable-IT, Inc. offers a generous 45-Day refund on a single Ethernet Extender Kit only, and is
subject to a 15% Restocking Fee. Shipments without a valid or authorized RMA number, or
sent to our corporate Las Vegas address, can be refused and / or billed for additional shipping.

All Rights Reserved © 1997 - 2015 Enable-IT™, Inc. Page 5 of 5
ENABLE-IT, INC. LIMITED WARRANTY
Enable-IT, Inc. warrants the Enable-IT 865W PRO Weatherproof Ethernet Extender Kit solely
pursuant to the following terms and conditions.
1. ENABLE-IT PRODUCT WARRANTY.
a. Express Warranty.
Enable-IT warrants to the original purchaser of the Product ("you" or the "End User") that,
for the four (4) year period commencing on the date the Product was purchased (the
"Warranty Period"), the Product will be substantially free from defects in materials and
workmanship under normal use and conditions. This warranty does not apply to Products,
which are resold as used, repaired or reconditioned, or consumables (such as batteries)
supplied with the Product. Electrical or water damage are not covered under this
warranty, extended warranties or Advanced Replacement Program (AREP).
Enable-IT does not make any warranty with respect to any third party product, software or
accessory supplied with or used in connection with the Product and such third party
products, software and accessories, if any, are provided "AS IS." Warranty claims related
to such third party products, software and accessories must be made to the applicable third
party manufacturer.
CONTACT US
Sales and Customer Care:
Toll Free US and Canada 888 309-0910
866 389-8605 Fax
Other International [phone]
[phone] Fax
E Mail [e-mail]
[e-mail]
RMA Support:
http://support.enableit.com