EnGenius ECB7510 User manual

ECB7510
Wireless Gigabit Dual Band Concurrent AP
Thank you for choosing EnGenius
Q
uick Guide
ECB7510
Power On
1. Please screw the two antennas provided firmly to the SMA
connectors on the device.
2. ECB7510 supports both IEEE 802.3at PoE (Power over Ethernet)
and regular power adapter. You should use either one as the
power source. Please do not apply both at the same time.
3. Push down the power button (labeled ) on the back panel to power on the device.
4. It takes about 20 seconds for the system to
complete its process. The system is ready
when WLAN 2.4GHz or 5GHz is on as shown
on the right.
Configure Setting
1. You can easily configure the device using a
web browser. The default device IP
address is 192.168.1.1.
2. It is recommended to setup the device
over Ethernet connection. You will need a
computer with a free Ethernet port.
3. Configure the Ethernet network interface
to IP address 192.168.1.10 with subnet
mask 255.255.255.0 (you can use any
other IP address as long as it is legal and
under the same 192.168.1.x domain).
Please leave default gateway and DNS
blank.
All manuals and user guides at all-guides.com
all-guides.com

ECB7510
Wireless Gigabit Dual Band Concurrent AP
Thank you for choosing EnGenius
Q
uick Guide
4. Open your web browser and enter http://192.168.1.1 into address bar then press enter.
5. Enter admin for Username and Password in the following login prompt.
6. You have successfully connected to the device administration page. You can now start
configuring your device. Please refer to the user manual on the CD for more details.
Note: ECB7510 is not a router and does not support DHCP server. It will not assign IP address to
its wireless clients or LAN side computers.
All manuals and user guides at all-guides.com