EnGenius ENS202EXT User manual

Quick Installation Guide
EnGenius Europe | Veldzigt 28, 3454 PW De Meern,
Netherlands | 0900-WIFIABC | www.wiabc.com Disclaimer: Information may be subject to changes without prior notication. Follow us
https://www.linkedin.com/company/engeniuseurope
https://plus.google.com/+EngeniusEuropeBVDeMeern
https://www.youtube.com/user/engeniuseuropebv
https://twitter.com/engeniuseu
ENS202EXT - EZ Hotspot Edition
Hardware installatie
1. Remove the rear bottom panel.
2. Connect one end of the Ethernet cable to the ENS202EXT-EzHotspot. From
the back view, it is the Ethernet Port on the right, which is also marked as
LAN(PoE) on the label. Ensure it is properly secured with a click and replace the
removed rear bottom panel back. Connect the other end of the Ethernet cable to
the PoE injector’s PoE port.
3. Connect the power adapter DC inlet to the 24V DC IN of the PoE injector
and the power adapter to the electrical outlet.
Note: The device should ONLY be powered via the Ethernet cable connected to
the included PoE injector.
4. Once both connections are secure, verify the following:
a. One quick indication of the WLAN LED, followed by quick indication of the
PWR, LANs, LED and finally only the PWR LED.
b. After 1 minute, the WLAN LED starts to blinks intermittently and randomly.
5. On iOS or Android devices, click on ‘Settings’, ‘Wi-Fi’ and under ‘choose a
network’, you should select the SSID “EnGenius-EzHotspot-Extender”. Select and
enter the serial number of the device as the key.
6. Once connected, open you browser and type ezhotspot.eu.
Note: If you get intermittent or no response, you might have to reload the show.
Also make sure you are not re-connected to another SSID. Reason is when the
extender is scanning different channels in the background, you might get
disassociated and connect to another SSID. If this persists, click on ‘Forget the
precious network’.

Quick Installation Guide
EnGenius Europe | Veldzigt 28, 3454 PW De Meern,
Netherlands | 0900-WIFIABC | www.wiabc.com Disclaimer: Information may be subject to changes without prior notication. Follow us
https://www.linkedin.com/company/engeniuseurope
https://plus.google.com/+EngeniusEuropeBVDeMeern
https://www.youtube.com/user/engeniuseuropebv
https://twitter.com/engeniuseu
ENS202EXT - EZ Hotspot Edition
To start, click on the ‘Scan hotspots’-button on the left menu.
Select the Hotspot’s SSID that you want to connect to.
Tip 1: For example, a signal level of -50dBm is better than 80dBm.
Tip 2: A Hotspot or Wi-Fi service with -80dBm or higher may not be reliable.
Step 2: After selecting on the desired Hotspot, the SSID & BSSID values will be
filled automatically. Click ‘Accept Values’.
Next, Click on ‘Save Reload’ button on the left menu.
Final step: Click save, reload & get online!
!The device will reboot in one minute after which you should be online. You
can check on the status by clicking on the ‘connect status’ to check.
Extra Note:
- Warning! When you upgrade the firmware the EzHotspot-function is lost.
- The admin-password cannot contain more than 12 characters.
- When you make a connection with an encrypted access point, make sure that
you choose the right encryption. This you can find under ‘Properties’ on the
client device.