EnGenius EOC1650 User manual

* Theoretical wireless signal rate based on IEEE standard of 802.11b, g chipset used. Actual throughput may vary.
Network conditions and environmental factors lower actual throughput rate.
** All specifications are subject to change without notice. 12/4/2008
Wireless Access Point / Client Bridge / Client Router
EOC1650
2.4GHz
54Mbps
802.11b/ g
Superior Performance
EOC1650 is a revolutionary product consists of conciseness, quality, and
flexibility. It comes with 7dBi internal antenna and upgradable SMA interface
provides a customizable interface for enhanced network coverage. Attached
suction cup allows quick installation on window or smooth surface.
Operation mode provides Access Point / Client Bridge /Client Router and high
bandwidth up to 54Mbps. It features high transmitted output power and high
receivable sensitivity. High output power and high sensitivity extends range and
coverage to reduce the roaming between Access Points to ensure a stable
wireless connection and reduce the expense of equipment.
It supports distance control ranges from 1km to 30km and RSSI indicator which
enables the best transmitted and received signals for traffic communication.
User can choose a suitable antenna for flexible application. This product comes
with PoE injector for building in outdoor environment easily.
To protect wireless connectivity, EOC1650 encrypt wireless transmissions
through 64/128-bit WEP data encryption and also supports WPA/WPA2. The
MAC address filter lets you select exactly which stations should have access to
your network. In addition, the User Isolation function can protect the private
network between client users.
The attractive design, high performance, and array of features make EOC1650
an optimal wireless solution choice for your residence and office.
Package Content
→1 x 802.11b/g Long range AP/CB (EOC1650)
→1 x PoE Injector (EPE-1212) with 24V/0.6 Power Adapter
→1 x CD with User’s Manual
→1 x QIG
→1 x Metal strap
→1 x Special screw set
→1 x 5dBi SMA Antenna

* Theoretical wireless signal rate based on IEEE standard of 802.11b, g chipset used. Actual throughput may vary.
Network conditions and environmental factors lower actual throughput rate.
** All specifications are subject to change without notice. 12/4/2008
Features
Wireless
- 2.4GHz It works in 2.4GHz frequency spectrum
- High output power Transmit output power programmable for different country selections
- High Data Rate High speed transmitting rate up to 54Mbps, support large payload such as MEPG video
streaming
- Multifunction application Access Point / Client Bridge / Client Router
- Long range transmitting Transmit power control and distance control (ACK timeout)
- Signal Strength LED indicators have the best transmit and receive signal for traffic communication
Networking
- Public wireless solution An AP interface that is especially useful in public areas such as hotspots and
enterprise
- Signal Strength Display RF signal strength status shown LEDs of 3 colors, making network build-up
easier
- QoS(WMM) Enhance performance and density
- PPPoE Point-to-Point Protocol over Ethernet at Client Router mode. This function will keep trying when
failed or disconnected
- BSSID Basic Service Set ID, supports 4 MAC address
Security
- 802.11i WEP, WPA, WPA2 (Encryption support TKIP/AES)
- MAC address functions MAC address filter (AP mode)
- 802.1x IEEE802.1x Authenticator
- L2 isolation
- Station isolation
Management
- Firmware Upgrade Upgrading firmware via web browser, setting are reserved after upgrade
- Reset & Backup Reset to factory default. User can export all setting into a file via WEB
- MIB MIB I, MIB II(RFC1213)
- SNMP V1, V2c

* Theoretical wireless signal rate based on IEEE standard of 802.11b, g chipset used. Actual throughput may vary.
Network conditions and environmental factors lower actual throughput rate.
** All specifications are subject to change without notice. 12/4/2008
Technical Specifications
Hardware Specification
MCU/RF
Atheros AR2315 Single chip
Memory
32MB SDRAM
Flash
8MB
Physical Interface
One 10/100 Fast Ethernet RJ-45
Reset Button
One SMA Connector
LED indicators
1 x Power/ Status
1 x LAN (10/100Mbps)
1 x WLAN (Wireless is up)
3 x Link Quality (Client Bridge mode)
•Green: Good Quality
•Yellow: Marginally Acceptable Quality
•Red: Bad Quality
Power Requirements
Active Ethernet (Power over Ethernet) Proprietary PoE design
Power Adapter 24V / 0.6A DC
Regulation Certifications
FCC Part 15C/15B, EN 300 328/EN 301 489-1/-17
RF Specification
Frequency Band
802.11b/g
2.412~2.472GHz
Modulation Technology
OFDM = BPSK, QPSK, 16-QAM, 64-QAM
DSSS = DBPSK, DQPSK, CCK
Operating Channels
802.11b/g
11 for North America, 14 for Japan, 13 for Europe
Receive Sensitivity (Typical)
802.11g
-92 dBm @ 6Mbps
-74 dBm @ 54Mbp
802.11b
-97 dBm @ 1Mbps
-89 dBm @ 11Mbps
Available transmit power
(Average power)
FCC
ETSI
Frequency
Power
Frequency
Power
2.412~2.462
GHz
IEEE802.11g
23dBm@6~24Mbps
23dBm@36Mbps
22dBm@48Mbps
22dBm@54Mbps
2.412~2.472
GHz
IEEE802.11g
23dBm@6~24Mbps
23dBm@36Mbps
22dBm@48Mbps
22dBm@54Mbps
2.412~2.462
GHz
IEEE802.11b
23dBm@1~11Mbps
2.412~2.472
GHz
IEEE802.11b
23dBm@1~11Mbps

* Theoretical wireless signal rate based on IEEE standard of 802.11b, g chipset used. Actual throughput may vary.
Network conditions and environmental factors lower actual throughput rate.
** All specifications are subject to change without notice. 12/4/2008
Tolerance
±1 dBm
Tolerance
±1 dBm
Internal Antenna
1 x 7dBi Internal Panel Antenna
External Antenna
1 x 5dBi SMA Antenna
Software Features
General
Topology
Infrastructure
Protocol / Standard
IEEE 802.3 (Ethernet)
IEEE 802.3u (Fast Ethernet)
IEEE 802.11b/g (2.4GHz WLAN)
Operation Mode
802.11 b/g
Access Point
Client Bridge
Client Router
LAN
DHCP Server
DHCP Client
VPN
VPN – Pass through
Wireless
Channel Selection (Setting varies by countries)
Transmission Rate
11 b/g：54, 48, 36, 24, 18, 12, 11, 9, 6, 5.5, 2, 1 Mbps
Long distance transmission : 1km to 30km
Transmit power table
Signal Strength indication using LEDs (3 colors)
PPPoE (CR mode)
Security
WEP Encryption-64/128/152 bit
WPA/WPA2 Personal (WPA-PSK using TKIP or AES)
WPA/WPA2 Enterprise (WPA-EAP using TKIP)
802.1x Authenticator
Hide SSID in beacons
MAC address filtering, up to 50 field
L2 isolation(AP mode)
Wireless STA (Client) connected list
QoS
WMM
Management
Configuration
Web-based configuration (HTTP)
Firmware Upgrade
- Upgrade firmware via web-browser
- Keep latest setting when f/w update
Administrator Setting
Administrator password change
Reset Setting
- Reboot (Press 1 second)
- Reset to Factory Default (Press 5 seconds)
System monitoring
Status, Event Log

* Theoretical wireless signal rate based on IEEE standard of 802.11b, g chipset used. Actual throughput may vary.
Network conditions and environmental factors lower actual throughput rate.
** All specifications are subject to change without notice. 12/4/2008
SNMP
V1, V2c
MIB
MIB I, MIB II (RFC1213)
Backup & Restore
Settings through Web
Time setting
NTP (Auto-setting of time)
Time setting manually
Environment & Mechanical
Temperature Range
Operating -20°C~70°C
Storage -30°C to 80°C
Humidity (non-condensing)
0%～90% typical
Dimensions
192mm (L) x 48mm (W) x 36.2mm (H)
Weight
250g
Product ID & Mounting Base
V1.0