Epoch Design Peyton PN-FU-XB-ES User manual

Peyton Storage Drawer
5149: PN-FU-XB-ES
Congratulations on the purchase of your Peyton Storage Drawer. This storage drawer has been crafted to the
highest standards of quality and safety and will give you many years of enjoyment and practical use.
Because this storage drawer is composed of wood there will be variations in color and grain, and minor checking
may occur. This is normal and does not compromise the integrity of your trundle.
On this insert you will nd a list of hardware and parts necessary for assembly, as well as detailed instructions.
Assembly is quite simple and requires only a Phillips Head screwdriver. The use of a power drill with
the torque setting on low and a Phillips Head attachment is helpful but not necessary. Assembly will be most easily
accomplished if you take the time to carefully sort the hardware and familiarize yourself with the function of each piece.
If you need assistance with assembly, part replacement or any other matter, contact the Toll-Free Epoch Design
Service Center from anywhere in the Continental United States, Monday through Friday, 9AM - 5PM Pacic Standard Time
at 1-800-589-7990. You may also fax your request or comments to 425-284-0885 or email [e-mail]
and a service representative will respond.
Thank you and Enjoy
E POCH D ESIGN, LLC
01-Oct-20181/2
8x 35mm Bolt
Used to attach front,
back and end panels
1x 4mm Allen Wrench
2x Storage Drawer
End Panel
2x Plank Brace
2x Bottom Planks 2x Drawer Divider
4x Wheels
38x 20mm Screws
Used to attach attach
wheels and bottom plank
6x 30mm Wood Screws
Used to attach plank braces
1x Middle Plank Brace
HARDWARE LIST
DRAWER PARTS
HAVE QUESTIONS OR CONCERNS? CALL US FIRST: 1-800-589-7990
Copyright © 2018 Epoch Design™ All rights reserved
1x Storage Drawer
Back Panel
1x Storage Drawer
Front Panel
4x Wire Retainers4x Wooden Dowels
mm 10 20 30 40

B
OPTIONAL COMPARTMENTALIZED STORAGE
Lay the bottom planks into the trundle.
The top side of the planks will have countersunk
holes for the 20mm wood screws.
Insert and tighten
the 20mm wood screws.
Attach the two plank braces and middle plank brace
to the trundle with 30mm wood screws.
Attach both storage drawer end panels to the front and back
panels with wooden dowels. (See Diagram A)Then insert 35mm
bolts and tighten with a 4mm Allen Wrench (Diagram B).
The braces should lay ush with the surrounding ledge.
M
I
D
D
L
E
P
L
A
N
K
Note: Do not tighten any of the bolts until all of
them have been threaded at least part way.
1
3
2
5
4
Have a question? Need a part ASAP? Please call 1-800-589-7990 (Monday through Friday 9am to 5pm PST).
A
To compartmentalize the storage drawer, simply add the wire retainers and the wooden
dividers as you wish in order to achieve your desired size storage area (See Diagram D).
Congratulations, you
are now ready to enjoy
your Storage Drawer.
Carefully ip storage drawer over and attach
wheels with four 20 mm wood screws per
wheel as shown (See Diagram C).
Note: This step should be
done on a soft surface such as
carpet or a blanket to prevent
scratching on your new drawer.
C
D
01-Oct-20182/2