Epoch Design AM-5D-DR-BA User manual

Congratulations on the purchase of your Amore 5 drawer dresser. This dresser has been crafted to
the highest standards of quality and safety and will give you many years of enjoyment and practical use.
Since this dresser is a natural bamboo product there will be variations in color and grain, and minor
wood grain checking may occur. This is normal and does not compromise the integrity of your dresser.
variation in the character of this piece is integral to its beauty and distinguishes it from lower quality
composite materials.
Assembly is quite simple and requires only a Phillips head screwdriver. The use of a power drill with
Phillips head attachment is helpful but not necessary. Assembly will be most easily accomplished if you take
the time to carefully sort the hardware and familiarize yourself with the function of each piece.
If you should require assistance with assembly, part replacement or any other matter, contact the
toll-free Epoch Design Service Center from anywhere in the Continental United States, Monday through
Friday, 9 AM – 5 PM Pacic Standard Time at 1-800-589-7990. You may also email your request or comments
to [e-mail] and a service representative will respond.
Thank you and Enjoy
EPOCH DESIGN , LLC AMORE 5 DRAWER DRESSER
5406: AM-5D-DR-BA
15-Aug-20191/2
HARDWARE LIST
PARTS
HAVE QUESTIONS OR CONCERNS? CALL US FIRST: 1-800-589-7990
COPYRIGHT © 2019 EPOCH DESIGN™ ALL RIGHTS RESERVED
1x Allen Wrench
Used to tighten bolts
16x 15mm Bolts
Used to attach
legs to dresser
5x Drawer handles
Used to open
drawers
4x 25mm Wood Screws
Used to attach
valance to dresser
1x Valance
B
A
4x Legs
1x 5 Drawer Dresser
10x 35mm Machine Screws
Used to attach drawer handles
mm 10 20 30

Underside of drawer
TRACK
TAB
TRACK
TAB
Carefully lay the dresser on it’s back on a clean
soft surface. Once in the correct position, install
the four legs (A) onto the bottom of the dresser
using four 15mm bolts per leg, tighten using the
Allen wrench provided.
*NOTE: Each leg bottom should point outward
towards it’s nearest outer corner as illustrated.
15-Aug-20192/2
HAVE QUESTIONS OR CONCERNS? CALL US FIRST: 1-800-589-7990
COPYRIGHT © 2019 EPOCH DESIGN™ ALL RIGHTS RESERVED
1
Place the handle on the outside
of the drawer, insert the 35 mm
machine screws through the
pre-drilled holes located on the
inside of the drawer and tighten
using a Phillips head screwdriver.
(Diagram I).
*NOTE: Do not turn the handle to tighten or loosen the screws.
Doing so will cause the handle to scratch the front of the drawer.
If you nd you need to remove a
drawer, push and hold the track
tabs outward and pull the drawer
the rest of the way out of it’s
drawer slide.
*NOTE: Each drawer is
manufactured specically for
its original location, if you remove more than one drawer at a
time make sure that they are all returned to their proper place
in their original order.
3
Install the valance (B) on the bottom of the
dresser using the four 25mm wood screws
and a phillips head screw driver or a power
drill with the clutch set to low, then return
the dresser to it’s upright position.
2
A
AA
A
B
B
I