Epoch Design VERONA 5415 User manual

1x Center Support Rail 2x Center Support Rail
1x Footboard 1x Footboard
1x Headboard 1x Headboard
Congratulations on the purchase of your Verona Platform Bed. This bed has been crafted to the highest standards of
quality and safety and will give you many years of enjoyment and practical use.
On this insert you will nd a list of the hardware and platform bed parts as well as detailed assembly instructions.
Assembly is quite simple and requires only a Phillips head screwdriver. The use of a power drill with Phillips head
attachment is helpful but not necessary. Assembly will be most easily accomplished if you take the time to carefully
sort the hardware and familiarize yourself with the function of each piece.
If you need assistance with assembly, part replacement or any other matter, please contact the toll-free Epoch Design
Customer Service Team from Monday through Friday, 9 AM-5 PM PST at 1 [phone]. You may also email your
request or comments to [e-mail] and a customer service representative will respond.
Thank you and Enjoy
EPOCH DESIGN , LLC
VERONA PLATFORM BED
5415: VA-KI-PB-SN, 5416: VA-QU-PB-SN,
5417: VA-FU-PB-SN
HARDWARE LIST
30 mm slat screws
Used to secure
slats to rails
36x FULL 39x QUEEN
52x KING
15 mm wood screws
Used to secure
center support
4x FULL 4x QUEEN
8x KING
1x Slat bundle
Rest on side rails and
supports mattress
(strap side down)
2x Side rails
Connect headboard
to footboard
KINGFULL/QUEEN
BED PARTS
mm 10 20 30
31-May-2018
1/2
HAVE QUESTIONS OR CONCERNS? CALL US FIRST: 1-800-589-7990
Copyright © 2018 Epoch Design™ All rights reserved

KingFull / Queen
3
2
Spread the slat bundle, strap side down, evenly across the side rails. Then use a Phillips head screwdriver
and the 30mm wood screws to secure the rst slat on one end of the bed and the last slat other end.
Finally, screw the remaining slats to the platform. *A power drill set to low torque with a Phillips head
extender may be useful in this step.
Attach the center support rail(s) to the center support brackets using the 15mm wood screws.
Make sure the platform for slat attachment
is facing the inside of the bed. Then slide
one side rail into the slots of the headboard.
Repeat this process with the other side rail.
Next do the same with
the other end of the side
rails into the footboard.
Gently tap the top of the rail ends with a rubber mallet
to make sure the connections are secure.
Have a question? Need a part ASAP? Call 1-800-589-7990 or email [email protected]
1
SLAT R
A
IL P
L
AT
F
O
RM
31-May-2018
2/2