Epson ET-2750 series User guide

Call Us: a [phone] • www.inkjetbiz.com
SUPPORT
INKJETBIZ TB-ET2750
103-19
2. Unpacking the ink bottles (Follow the Instructions)
3. Filling the ink tanks.
a. Open the ink tank cover, then open the cap for the ink tank you are
going to fill.
ET-2750 Start up Guide
How to load Dye Sublimation Ink on 4 Colors Epson Ecotank Printer
This guide describes the procedure on how to load Dye Sublimation Ink into the printer.
*ET 2750 pictures below but this instructions will work for other 4 Color ET units.
Menus may vary but selections remain the same.
1. Unpack and remove all protective materials from the product.
c. Put the lower part of the cap
back on the bottle and load the inks
as shown.
b. Unscrew the entire Cap. Break or
remove the Aluminum Seal
a. Take the bottle out of the poly bag
and remove the Black Tape

Call Us: a [phone] • www.inkjetbiz.com
SUPPORT
INKJETBIZ TB-ET2750
103-19
b. Position the top of the ink bottle along the slot in
front of the filling port, then slowly stand the bottle up
to insert it. Wait for ink to fill the tank.
Do not squeeze the bottle. Ink flows into the tank and
stop automatically when the ink tank is full.
c. Remove the ink bottle once the ink tank is full and
securely close the ink tank cap.
Repeat steps 3a-3c to fill the rest of the ink tanks, close the ink tank cover when finish.
4. Connect the power cord to the back of the product and to an electrical outlet. Raise the con-
trol panel, then press the power button to turn on the product. (Do not connect to the computer
yet)
5. Press up or down arrows to select your language on the LCD
screen. Next, press the OK button. When the message “Start
Here” appears on the LCD screen, press the OK button. On the
next screen, press and hold the OK button for 3 seconds.
When the message to “Start Initialization” appears on
the LCD screen, press the start button to start charg-
ing the ink. Ink charging takes approximately 7 min-
utes. A message will appear when ink charging is com-
plete.
6. Connect the printer to the PC, install your printer driver and
ICC. Load the media and you are ready to print.