Epson EpiqVision Ultra LS500 User manual

SALAMANDER DESIGNS 503-237 [8.20] 1 of 2
EPSON LS500 PROJECTOR CABINET
MODEL # X3/EPS2/237S
1. Place shelf on the rear shelf peg with
the front of the shelf resting on the base.
2. Continuing holding the back end of shelf
while a 2nd person sets the projector,
centering it on the width of the shelf front
with the rear of the projector 1.5” (38mm)
 infromtheshelfedgeasshowningure1.
3. Continuing holding the back end of shelf,
while a 2nd person lifts the shelf up and
slightly forward until the projetor lens
housing goes through the opening in the
top and the shelf can be rested on the front
 shelfpegasshowningure2.
WARNING
Installation requires two people.
REAR FRONT
Lens Housing
Figure 1
Figure 2
LIMITED WARRANTY
Salamander is proud to stand behind our products with industry-leading warranties. Should you ever encounter any problem with your
Salamander product, let us know. We are here to make it right. 1.800.535.5659 - 860.761.9500
Full warranty including limitations and warranty claim information may be found at http://www.salamanderdesigns.com/customerservice/warranty

SALAMANDER DESIGNS 503-237 [8.20] 2 of 2
Hinge Base
Left Post
Right Post
Reverse Door (Speaker Grill to Bottom of Door)
Remove the four screws from the Hinge Base as shown below.
Leaving the hinges and base attached to the door, remove the four screws from the hinge base
as shown below, starting from the bottom and working up.
Note the location of the hole positions used as removing.
Flip the door and attach to the Right Post as it was removed from the Left Post.
Minor door alignment may be necessary, please follow cabinet instruction steps to make
these adjustments.