Epson PowerLite 450W Parts list manual

INSTALLATION HANDBOOK
Lamp and Status Information
Epson PowerLite 450W / 460
1
Replacing the Lamp
The life span of the projection lamp is about 2500 hours if Power
Consumption in the Settings menu is Normal (default), and 3500
hours if this setting is ECO.
It is time to replace the lamp when:
The projected image gets darker or starts to deteriorate.
The message Replace the lamp appears on the screen and the
Lamp light ashes orange. To maintain projector brightness
and image quality, replace the lamp as soon as possible.
You may also need to replace the lamp if the Lamp light ashes
red.
Contact your dealer or call Epson at 800-GO-EPSON
(800-463-7766). Request part number V13H010L57.
note
Turn o this product when
not in use to prolong the life
of the projector.

INSTALLATION HANDBOOK
Lamp and Status Information
Epson PowerLite 450W / 460
2
Follow these steps to replace the lamp:
1. Turn o the projector and unplug the power cord.
2. Let the projector cool for at least an hour (if it has been on). The
lamp is extremely hot immediately after use.
3. Loosen the lamp cover screw (you cannot remove it). Then slide
the lamp cover o.
4. Loosen the two screws holding the lamp in place (you can’t
remove them).
warning
Let the lamp cool fully
before replacing it.
In the unlikely event that
the lamp has broken, small
glass fragments may be
present and should be
removed carefully to avoid
injury. If the projector has
been installed on the ceiling,
you should stand to the side
of the lamp cover, not
underneath it.
If the lamp is used after the
replacement period has
passed, the possibility that
the lamp may break
increases. When a lamp
replacement message
appears, replace the lamp
with a new one as soon as
possible, even if it is still
working.
Loosen, but don’t
remove these screws

INSTALLATION HANDBOOK
Lamp and Status Information
Epson PowerLite 450W / 460
3
5. Grasp the lamp handle as shown and pull it straight out.
6. Gently insert the new lamp along the guide rail, then push it in
place.
note
The lamp(s) in this
product contain mercury.
Please consult your state and
local regulations regarding
disposal or recycling. Do not
put in the trash.
7. Tighten its screws, then press it in by the handle until it clicks
into place.
note
Tighten the lamp cover
securely so you do not receive
a lamp cover error when you
turn the projector back on.

INSTALLATION HANDBOOK
Lamp and Status Information
Epson PowerLite 450W / 460
4
8. Replace the lamp cover, then tighten its screw.
9. Reset the lamp timer as described in the next section.
Resetting the Lamp Timer
After you replace the lamp, you need to reset the lamp timer using the
projector’s menu system.
1. Press the Menu button on the remote control or on the
projector’s control panel. You see the main menu.
2. Select the Reset menu and press Enter. You see this screen:
3. Select Reset Lamp Hours and press Enter.
4. When you see the prompt, select Yes and press Enter.
5. When you’re nished, press Menu to exit.