ETEKCITY EK7090 User manual

1
Digital
Kitchen Scale
Model: EK7090
User Manual
Questions or Concerns?
Mon–Fri, 9:00 am–5:00 pm PST/PDT
[email protected] • [phone]

2
If you have any questions or concerns, please reach out to our
helpful Customer Support Team at [email protected].
We hope you enjoy your new kitchen scale!
Exclusive deals, giveaways, and product registration.
Better products for better living.
Find us here: etekcity.com
Thank you for purchasing the Digital
Kitchen Scale by Etekcity.
Become an Etekcitizen

3
Table of Contents
Specications
Important Safety Information
Function Diagram
Before First Use
Using Your Scale
• General Operation
• Unit Conversion
• Automatic Power Off
• Manual Power Off
• Zero / Tare Function
Replacing the Batteries
Troubleshooting
Warranty Information
Customer Support
4
5
6
7
8
8
8
8
9
9
10
11
12
14

4
Specications
Weight Capacity 176 oz / 11 lb / 5000 g / 5000 mL
Units oz / lb:oz /  oz (water/milk) / g / mL (water/milk)
Increments 0.05 oz / 1 g / 1 mL
Auto-Off 3 minutes
Battery 3 x 1.5V AAA batteries
Dimensions 7.9 x 5.6 x 0.5 in / 200 x 141 x 12.5 mm

5
To avoid damage to this scale, please read and follow all instructions
and safety guidelines in this manual.
Scale
• Do not exceed the 11 lb / 5000 g weight capacity as it will damage the
scale. An error indicator will appear on the LED display if the limit is
exceeded.
• Do not immerse the scale in water or any liquid. If liquid is spilled on
the digital display or buttons, immediately wipe the scale clean with a
soft cloth to avoid internal damage.
• Handle with care. This scale is not intended for commercial or heavy-
duty use.
• Keep the scale in a cool, dry place. Avoid exposure to damp
environments or extreme temperatures.
• Household use only.
Batteries
• Do not mix new and old batteries.
• If the low battery indicator (“Lo”) appears on the display, replace the
batteries.
• If the scale is not in use for an extended period of time, remove the
batteries to conserve battery life and extend the lifetime of the scale.
Important Safety Information
SAVE THESE
INSTRUCTIONS

6
Function Diagram
A. LED Display
B. Unit Selection Button
C. Power/Tare Button
D. Anti-Skid Pads
E. Battery Compartment
Top
B DC EA
Bottom

7
Before First Use
The batteries are pre-installed in the scale.
1. Turn the scale over and open the battery compartment.
2. Remove the plastic strip from the battery compartment.
[Figure 1.1]
3. Replace the battery compartment cover.
4. Turn the scale over again and place on a hard, dry, at surface.
5. Tap to turn on the scale.
Figure 1.1

8
Using Your Scale
Note:
• For accurate results, always place the scale on a hard, dry, flat surface,
and keep the scale away from dirt, dust, vibrations, wind, air currents, and
electromagnetic interference.
• When you turn on the scale, choose units, or use the tare function, wait for
the scale to read “ ” again before measuring.
General Operation
1. Place the scale on a hard, at, level surface for measurement.
2. Tap to turn on the scale. Make sure the scale shows “ ”.
Tap to select your desired measuring unit, which will show
on the right of the display.
3. Place your item on the scale.
4. Wait for the reading on the display to stabilize.
Unit Conversion
To change the unit of measurement, tap until the display shows
the desired unit of measurement.
Automatic Power Off
To save battery power, the scale will automatically power off after 180
seconds of inactivity.

9
Zero / Tare Function
Whenever you measure items inside a container, you can use the tare
function to remove the container’s weight from the nal measurement.
1. Tap to turn on the scale. Make sure the scale shows “ ”.
If the screen does not display “ ” automatically, tap to
auto-adjust to zero.
2. Place the container on the center of the scale.
3. Wait for the reading on display to stabilize. The screen will display
the container’s weight.
4. Tap to tare the weight of the container. The screen should
now display “ ”.
5. Place the item in the container. The scale will measure the liquid
or items, without including the weight of the bowl. [Figure 2.1]
6. When you’re done, reset the scale by removing all weight and
tapping again.
Manual Power Off
Press and hold for 2 seconds to turn off the scale.
Figure 2.1

10
Replacing the Batteries
1. Turn the scale over and open the battery compartment.
2. Take out the used batteries and replace them with 3 new 1.5V
AAA batteries.
3. Replace the battery compartment cover.