Fabtech FTS7006 User manual

Installation Instructions
FTS7006
2005-07 4wd Ford Super Duty Single Steering Stabilizer Kit
PARTS LIST-
Qty Part # Description
1 FT7006
Stabilizer
1 FT104
Tapered Sleeve
1 FT97150-6-106 3/8” Spacer
1 FT7006i Instruction Sheet
1 50133501052 ½”-13 x 3 ½” Hex Head Bolt
1 50130004152 ½ -13 C-Lock Washer
3 50000005152
½” SAE Flat Washer
TOOL LIST- (NOT INCLUDED)
•Assorted Metric & SAE Sockets & Wrenches
•Torque Wrench
READ ALL INSTRUCTIONS THOROUGHLY FROM START TO FINISH BEFORE BEGINNING
INSTALLATION! IF THESE INSTRUCTIONS ARE NOT PROPERLY FOLLOWED, SEVERE FRAME,
DRIVELINE AND / OR SUSPENSION DAMAGE MAY RESULT.
CHECK FOR FRAME AND SUSPENSION DAMAGE PRIOR TO INSTALLTION.
THIS KIT DOES NOT REQUIRE WELDING FOR INSTALLATION. DO NOT WELD ANY OF THESE
COMPONENTS.

INSTALLATION-
1. Disconnect the negative terminal on the battery. Position the front tires of the vehicle straight
ahead.
2. Remove the factory steering stabilizer from the truck and discard the stabilizer and the
hardware.
3. Attach the shaft end of the stabilizer with the provided flat rubber bushings and cup washers to
the original frame bracket and tighten until the rubber bushings swell.
4. Locate the supplied FT104 tapered sleeve, FT97150-6-106 spacer and ½” hardware. Extend
the stabilizer enough to meet the mounting hole in the factory draglink. The tapered sleeve will
need to be installed first from the top of the drag link with the smaller part of the taper going
into the draglink first. Then attach the stabilizer with the bolt, spacer, and washers as shown in
the diagram below. Torque the nut and bolt to 60 ft. lbs. SEE DIAGRAM BELOW
5. Recheck each nut and bolt for proper torque.
6. Check front-end alignment and set to factory specifications.