Felton WILLO II W2HSKCSRBN User manual

For technical assistance please ring: 0800 743 358 or [phone]
Felton Industries Limited www.felton.co.nz8 Farmhouse Lane, St Johns, Auckland 1072 New Zealand
300321HM
Warranty, Maintenance and Care YOUR COPY TO KEEP
Felton Industries Limited guarantees these products to be free from defects in materials and workmanship for a period of five (5) years from the date of purchase.
This warranty is eective for 5 years from the date of purchase and covers supply of replacement parts only, not including installation. You must retain proof of purchase of the product
(such as an invoice or receipt) and provide this to Felton on request. This warranty is for manufacturing defects only and does not cover any damage to product due to abuse,
negligence or improper installation. This warranty is given on the understanding that the product is installed and operated according to Felton’s installation guide and the
Australian/New Zealand standard AS/NZS3500. This warranty is provided to persons who are a “consumer” under the Consumer Guarantees Act 1993 only and for use in
domestic/residential dwellings only (not for commercial use).
At no stage should plated surfaces be cleaned with cleaning agents that contain a corrosive acid or a scouring additive. Plated surfaces should be cleaned with liquid
detergent or soap and water. Any damage caused through the use of an unsuitable cleaner will not be covered by warranty.
This warranty is subject to any other rights or remedies that you may have under the Consumer Guarantees Act 1993 (or any other applicable legislation) and to Felton’s
Terms of Trade.
Please fill in the details below, attach your receipt to this installation guide and keep as your proof of purchase.
Purchased at: ...............................................................................................................................................................................................................................................................................................
Date of purchase: .......................................................................................................................................................................................................................................................................................
Installed by: ...................................................................................................................................................................................................................................................................................................
INSTALLATION GUIDE
WILLO II SINGLE SPRAY SLIDE SHOWER
BRUSHED NICKEL W2HSKCSRBN
WHAT IS IN THE PACK
1 x Rail & Slider
2 x Wall Anchors
1 x Flow Restrictor
& Sleeve
(Pre-fitted to handpiece)
1 x Hose
2 x Wall Screws
1 x Elbow
1 x Soap Dish
2 x End Posts and
Mounting Brackets
1 x Single Spray
Handpiece

Secure brackets with bracket screws and caps
provided.
Screw the elbow into the water outlet (wingback). Sealant is required on the
wingback thread to achieve a water tight seal.
For Mains Pressure install handpiece as supplied. For Unequal / Low Pressure,
remove the flow restrictor from handpiece first.
Screw the hose onto the elbow and handpiece and attach the handpiece slider
on the rail.
1. 3. 4.2.
HOW TO INSTALL
INSTALLING INTO STUD/NOG...(RECOMMENDED)
Unscrew and separate
the mounting bracket
from the end post.
Mount the mounting brackets into position
(731mm centre to centre).
It is recommended that silicone sealant be used to
seal the fixing brackets.
Fit soap dish onto the
rail from the bottom
then fit both end
posts.
Mount the rail onto the
mounting brackets in
place.
5. 6.
INSTALLING INTO CONCRETE/BRICK WALL...
Pre-drill holes to 731 centre - centre
and fit the wall anchors then follow
the above instruction.
1
2
End post
Mounting
bracket
731mm c-c
731mm c-c