Felton Halo User manual

Ensure that the plastic regulator is removed from the brass nipple. Remove the “aerator” fitting from
the mixer outlet and replace it with the flow straightener provided.
Equal Low Pressure
MAXIMUM STATIC PRESSURE
Maximum static pressure 1500kPa. If the water pressure exceeds or is likely to exceed 1500kPa, an
approved pressure limiting valve must be fitted.
MINIMUM STATIC PRESSURE
HOT COLD
Mains Pressure 150kPa 150kPa
Unequal Pressure 36kPa 150kPa
Equal Low Pressure 36kPa 36kPa
System Requirements
To ensure the optimum performance and customer satisfaction please adhere to the following:
•Flush out all pipework prior to installation.
• Maximum hot water temperature: 60°C. If the water temperature exceeds 60°C an approved tempering
valve must be fitted.
•Installation should comply with relevant local authority requirements.
•In accordance with good plumbing practice, filters should be fitted to supply lines to eliminate damage
to the ceramic cartridge from suspended solids.
Mains Pressure
Fit without flow controller.
INSTALLATION GUIDE
Halo Basin Mixer 40mm
HBMC (Watermark)
1 x basin mixer 1 x brass M&F nipple 1 x flow regulator
2 x supply hoses 1 x flow straightener 1 x basin fixing kit
Contents of Pack
Unequal Pressure
Ensure that the plastic regulator supplied is fitted to the brass nipple and
fitted to the cold supply hose. Remove the “aerator” fitting from the mixer
outlet and replace it with the flow straightener provided.

1. Cut a mounting hole 35mm in diameter. There must be a minimum 12mm width of flat around the hole.
2. Fit benchtop seal to base of mixer
3. Screw the two threaded studs into mixer base.
4.
5.
6.
Lower the fitted hoses, one hose at a time, into mounting hole.
7.
From UNDERNEATH the bench, fit ‘C’ rubber washer and ‘C’ metal washer around both hoses and over
the threaded studs.
8.
Screw on the two hex nuts and tighten with fingers.
9.
Check the mixer and the benchtop seal are correctly aligned on the bench. Secure with spanner.
10.
Flush the supply pipes to remove debris.
Connect the water supply and check all the fittings are tight.
Turn on water supply and check for leaks.
Mixer Installation
Maximum bend for flexible hose is 35mm radius. The nipples on the hoses must be
connected to fittings which have machined end faces, not “sawn off” threaded tube.
-
Warranty, Maintenance & Care: Halo Basin Mixer (HBMC)
For technical assistance please ring: 0800 743 358 or [phone]
Felton Industries Limited - 8 Farmhouse Lane Glen Innes Auckland 1730 New Zealand www.felton.co.nz
V2300913KG
Felton Industries Limited guarantees these mixers to be free from defects in materials and workmanship for a period of
ten (10) years from the date of purchase.
This warranty is effective for 10 years from the date of purchase and covers supply of the (“mixer”) replacement parts
only and 5 years of plumbers labour from the date of purchase, provided the product is installed by a registered plumber.
This warranty does not cover any damage to product due to abuse, negligence or improper installation.
This warranty is given on the understanding that the product is installed by a registered plumber and operated according
to Felton’s installation guide and the Australian/New Zealand standard AS/NZS3500.
At no stage should plated surfaces be cleaned with cleaning agents that contain a corrosive acid
or a scouring additive. Plated surfaces should be cleaned with liquid detergent or soap and water.
Any damage caused through the use of an unsuitable cleaner will not be covered by warranty.
Purchased at:
Date of purchase:
Installed by: