Firegear ADP10-OUT User manual

Adapter
Extension Wire
Models:
ADP10-OUT
ADP70-OUT
Description: This is an outdoor approved adapter suited for wet, damp dry locations.
It plugs into 120VAC outlet and converts it to 6-volts DC to operate Firegear Outdoor
electronic systems. Each model comes with an adapter and 5-foot power cord.
The ADP10-OUT includes the adapter and a 10-foot extension wire.
The ADP70-OUT includes the adapter and a 70-foot extension wire.
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS
DO NOT ATTEMPT TO INSTALL OR OPERATE THIS PRODUCT
REV. 7-24-18
Firegear Outdoors ADP10/70-OUT Adapters

INSTALLATION
CAUTION: Carefully plan the path of the wire for maximum potential of the 10 or 70-foot wires. Know where you will
access a 120VAC power outlet and where to feed the wires to the control module. Follow all local and state codes when
running wire long distances.
Step 1: Remove contents from box and insert the 2-pin connector from the extension wire into the adapter. Once
inserted, then screw the threaded cap over the 2-pin connector to secure it into the adapter. See Fig. 1.
Learn Button
AUX
POWER
MODULE
Step 2: Feed the two ¼” terminals into the control module and connect to the POWER terminals as shown in Fig. 2.
Fig. 2 Shows location of control module’s two ¼” terminals (labeled POWER)
to attach adapter.
Fig. 1 Attaching extention wire to adapter.
Step 3: Installation is complete. Insert adapter plug into a 120VAC power source to use appliance.
Note:
• Do not cut, add, or splice additional wires to either of these adapter models. It can affect overall voltage causing
problematic issues with operation of appliance.
• If wire is too long carefully fold it together and use a zip tie to secure into place.
FOR TECHNICAL SERVICE, CALL:
Firegear Outdoors
9230 Conservation Way
Fort Wayne, IN 46809
For Sales: [phone]
WEB SITE: www.regearoutdoors.com
[phone]
REV. 7-24-18
Firegear Outdoors ADP10/70-OUT Adapters