Fisher & Paykel HT90GHB2 Wiring diagram

Tilted wall cooker hood
HT90GHB2 model
GB IE
INSTALLATION INSTRUCTIONS
USER GUIDE

1
CONTENTS
Introduction 3
Safety and warnings 4
Installation instructions 8
About your cooker hood – Energy efficiency 18
Operating instructions 19
Cleaning and maintenance 20
Parts and accessories 22
Manufacturer’s Warranty 23
Customer Care 24
ImpORTANT!
SAVE THESE INSTRUCTIONS
The models shown in this user guide may
not be available in all markets and are
subject to change at any time. For current
details about model and specification
availability in your country, please go to
our website www.fisherpaykel.com or
contact your local Fisher & Paykel dealer.
Registration
Register your product with us so we can
provide you with the best service possible.
To register your product visit our website:
www.fisherpaykel.com

3
INTRODUCTION
Thank you for purchasing a Fisher & Paykel product.
Thousands of hours go into the design, engineering, testing and perfecting of each
Fisher & Paykel appliance. The care and attention given to creating these beautiful
products doesn’t stop once it has found its home with you.
This use and care manual will answer most of your questions about the set-up, use and
on-going maintenance of your Fisher & Paykel product; however if you require further
information about your product and its use please consult our website for solutions
and further contact information to discuss with a service representative.
To ensure you receive all relevant product updates and the best service possible,
please register your Fisher & Paykel products through our website.

4
SAFETY AND WARNINGS
!WARNING!
34.5 kg
Weight Hazard
The cooker hood is heavy. Please ensure
adequate care is taken when installing the
cooker hood to prevent personal injury. The
cooker hood must be installed onto a solid
wall, stud, beam or truss. Weight of the
product is 34.5 kg.
!WARNING!
Electric Shock Hazard
Always disconnect the appliance from the
mains power supply before carrying out any
maintenance or repairs. Alterations to the
domestic wiring system must only be made
by a qualified electrician. Failure to follow this
advice may result in electrical shock or death.
IMPORTANT SAFETY INSTRUCTIONS
WARNING!
When using this appliance always exercise basic
safety precautions including the following:
• To avoid hazard, please read the entire set of
instructions before installing or using this appliance.
• Please make this information available to the person
installing the appliance – doing so could reduce your
installation costs.
• This appliance must be installed and connected to
the mains power supply only by a suitably qualified
person according to these installation instructions

5
SAFETY AND WARNINGS
and in compliance with any applicable local building
and electricity regulations. Failure to install the
appliance correctly could invalidate any warranty
orliability claims.
• If the power supply cable is damaged, it must be
replaced by the manufacturer, its service agent or
similarly qualified person in order to avoid a hazard.
• To comply with electrical safety regulations, this
cooker hood must be connected to a socket near
theappliance. The socket must be accessible, or
have an accessible isolating switch, to enable the
end user to isolate the cooker hood from the power
for the purpose of internal cleaning or maintenance.
• A power outlet should be within 750 mm of the
motor assembly and can be either on the wall,
behind the chimney or in the ceiling.
• Always switch the power off prior to installation,
servicing or cleaning the cooker hood.
• Ducting accessories are not supplied. All ducting must
comply with local requirements and building codes.
• Before connecting any pipes, consult municipal
ordinances to ensure that any applicable regulations
concerning the discharge of exhaust air are adhered
to and request permission from the person in charge
of the building.
• Exhaust air must not be discharged into an
existing flue that is used for exhausting fumes from
appliances burning gas or other fuels. There shall be
adequate ventilation of the room when the cooker
hood is used at the same time as appliances burning
gas or other fuels.

6
SAFETY AND WARNINGS
• When the cooker hood is turned on at the same time
as other appliances powered by energy other than
electricity, the air outlet must not be greater than
4Pa (4x10-5 bar).
• The minimum distance between the hob surface
andthe base of the cooker hood shall be 400mm
or650mm if installed over a gas hob.
• Stainless steel is very easily damaged during
installation if abraded or knocked by tools. It is
recommended to protect the top of the cooker hood
with cardboard or polystyrene during the installation
to minimise the risk of damage occurring.
• This appliance can be used by children aged from
8years or above and persons with reduced physical,
sensory or metal capabilities or lack of experience
or knowledge if they have been given supervision
orinstruction concerning use of the appliance in
a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning
and user maintenance shall not be made by children
without supervision.
• You must read the details concerning the method
and frequency of cleaning.
• There is a fire risk if cleaning is not carried out in
accordance with the instructions.
• Never leave frying food unattended since grease
can overheat and catch fire. The risk of fire is even
greater in the case of used oil.
• Do not flambé under the cooker hood.
• Never use the cooker hood without the filters inplace.

7
SAFETY AND WARNINGS
• During climatic conditions causing electrical
interference, it is possible that the device may stop
working. By switching the device off and on the
device will resume normal operation safety.
• During an electrostatic discharge (ESD) it is possible
that the device will stop working. By switching the
device off and on the device will again work as
intended. There is no risk and no risk will appear.
• CAUTION: accessible parts may become hot when
used with cooking appliances.

8
INSTALLATION INSTRUCTIONS
1 2
3 4
5 6
Unpacking your cooker hood

9
INSTALLATION INSTRUCTIONS
Contents of packaging
Installation instructions
User guide manual
(1)
Tilted wall cooker hood
HT90GHB2 model
GB IE
INSTALLATION INSTRUCTIONS
USER GUIDE
Chimney
(1)
Chimney bracket
(1)
Upper chimney bracket
(1)
60mm screws
and wall plugs
(6)
30mm screws
and wall plugs
(4)
10mm screws
(4)
Upper chimney
(1)
Cooker hood
(1)

10
INSTALLATION INSTRUCTIONS
H
Power cord location
g
E
A
min
A
max
B
D
F
C
J
K
ØI
Product dimensions

11
INSTALLATION INSTRUCTIONS
HT90GHB2
PRODUCT DIMENSIONS mm
AOverall height of product 800 – 1140
BOverall width of product 900
COverall depth of product 380
DHeight of hood 520
EWidth of flue 320
FDepth of flue 290
GDistance from centre of ducting outlet to back of product 140
HDistance from centre of ducting outlet to side of flue 160
IDiameter of ducting outlet 150
JDistance between centre of lights 200
KDistance from centre of lights to back of product 45
Length of power cord 1800
ImpORTANT!
Actual product dimensions may vary by ± 2mm.

12
INSTALLATION INSTRUCTIONS
Height of cooker hood
M
L
MINIMUM CLEARANCES mm
LInstallation height
Ducted
Recirculation
min. 840 – max. 1140
min. 880 – max. 1140
MHeight top of hob to base of product
Electric hob
Gas hob
min. 400
min. 650

13
INSTALLATION INSTRUCTIONS
M
L
Venting options
Attention should be given to ensure that any applicable regulations concerning the
discharge of exhaust air are fulfilled.
The cooker hood can be installed to operate with the exhaust air ducted externally from
the kitchen, or installed to operate with the exhaust air recirculating within the kitchen.
Ducted
For ducted installation it is recommended that 150mm diameter, rigid or semi-rigid
ducting is used. This will require a 160mm (min) round hole in the ceiling or wall. Care
should be taken to position the hole correctly.
For optimal efficiency, use rigid or semi-rigid ducting for reduced noise and increased
airflow. Flexible ducting should only be used as a last resort (ie in difficult installations)
and if used, ensure that it is pulled tight.
Recirculating
To enable the product to operate with the air recirculating, please purchase a
recirculation diverter and carbon filters (refer to the ‘Parts and accessories’ section).
Therecirculation diverter is required to channel the air out the side vents at the top
ofthe flue and the carbon filters are required to remove odours.
Note: a ducting hole is not required in the wall or ceiling if the cooker hood is
installed to operate with exhaust air recirculating.

14
INSTALLATION INSTRUCTIONS
Installation
WARNING!
This product is heavy and requires two persons for installation.
WARNING!
Failure to install the screws or fixing device in accordance with these instructions may
result in electrical hazards.
The manufacturer is not liable for any damage caused by not following these instructions.
1Preparing for installation:
Before installing your cooker hood:
 Please read the instructions carefully.
 Unpack the hood and check all functions are working.
 Ensure the voltage (V) and the frequency (Hz) indicated on the serial plate match
thevoltage and frequency of the installation site.
 Check that the area behind the installation surface to be drilled is clear of any
electrical cables or pipes etc.
 The stainless steel and glass surfaces of the hood are very easily damaged during
installation if grazed or knocked by tools. Please take care to protect the surfaces
during installation.
 Protect the hob surface below with cardboard, or the like, to prevent damage
occurring whilst the cooker hood is being installed above.
 Temporarily mark the height of the bottom of the cooker hood and the centre of the
hob on the wall according to the information given in the ‘Installation Instructions –
Height of cooker hood’ section.
 The wall used for mounting the cooker hood should have sufficient strength and a
flat surface.
2Attach chimney bracket and hood mounting screws
 Attach the chimney bracket and upper
chimney bracket (if using the upper chimney)
in the locations shown in Fig.2 and 3. Use
the 30mm screws and expansion plugs if
attaching to masonry.
 Attach the upper hood mounting screws
in the locations shown in Fig.2 and 3. Use
the 60mm screws and expansion plugs if
attaching to masonry. Ensure that there is a
2mm gap between the screw head and the
wall – see Fig.1
2 mm
Fig.1

15
INSTALLATION INSTRUCTIONS
20 mm
155 mm
365 mm
501 mm
773 mm
250 mm
235 mm
240 mm
270 mm
250 mm
Upper chimney bracket
attachment points
Chimney bracket
attachment points
Upper hood
attachment points
Internal hood
attachment points
Fig.2

16
INSTALLATION INSTRUCTIONS
Fig.3

17
INSTALLATION INSTRUCTIONS
3Attach hood to wall
 Open the front panel on the hood and remove the filter as shown in figures 4 – 6.
Fig.4 Fig.5 Fig.6
 Hang hood off upper hood mounting screw with 2mm gap. Hang off the keyhole
attachment points on the back of the hood (see Fig.7). Tighten screws.
Fig.7
 Attach internal hood mounting screws to fix hood to wall. Use the 60mm screws.
 Reattach filter and close front panel.
4Attach ducting
 Attach ducting and vent outside
5Attach chimney
 Place chimney around the chassis, align the tabs with the slots and attach to the
chimney bracket.
 Extend the upper chimney and attach to the upper chimney bracket with 10mm
screws (if using upper chimney).

18
ABOUT YOUR COOKER HOOD – ENERGY EFFICIENCY
Product Fiche
EN61591
MODEL HT90GHB2
Annual Energy Consumption (kWh/annum) 32.2
Time Increase Factor 1
Energy Efficiency Index 52.8
Energy Efficiency Class A
Fluid Dynamic Efficiency 28.5
Fluid Dynamic Efficiency Class A
Lighting Efficiency 28.7
Lighting Efficiency Class A
Grease Filtering Efficiency 91.2
Grease Filtering Efficiency Class B
Airflow at Min. Speed (m³/hr) 200
Airflow at Max. Speed (m³/hr) 525
Airflow at Boost Speed (m³/hr) 710
Airborne noise at minimum (dB) 40
Airborne noise at maximum (dB) 64
Airborne noise at Boost (dB) 67
Airflow At Best Efficiency Point (m³/hr) 348.4
Electrical Power Input At Best Efficiency Point (W) 76.1
Lighting Nominal Power (W) 7
Lighting Average Illumination (lux) 201
Power consumption in Off mode (W) 0.41
Power consumption in Standby mode (W) 0.41