Fisher-Price B6312 User manual

Keep this instruction sheet for future reference,
as it contains important information.
Adult assembly is required.
Tool needed for assembly: Phillips screwdriver (not included).
Requires four D (LR20) alkaline batteries (not included) for operation.
DTM20
B6312
L5803
Y0895
BMM05
fisher-price.com

3
Assembled Parts
• Insert and snap the tabs into the slots in
the ball chute pieces.
Ball Chute
(2 Pieces)
Motor
Cover
Base
SHOWN ACTUAL SIZE
Note: Tighten and loosen all screws
with a Phillips screwdriver. Do not
over-tighten the screws.
#6 x 15 mm Screws - 4
• Insert two screws into the pegs at the top
of the ball chute and tighten.
Tabs
Slots
Assembly
1
2

4
Assembly
Motor
• At an angle, insert the closed peg on the
motor into the hole in the base.
• Align the tabs at the bottom of the ball
chute with the grooves in the opening of
the motor.
• Turn the ball chute clockwise to lock it into
position. Pull up on the ball chute to be
sure it is secure.
Base Hole
Closed Peg
• Lower the motor so that the open peg fits
into the groove in the base.
• Insert the battery plug into the socket in the
motor, as shown.
Hint: If there isn’t a socket inside the peg, the
motor/chute assembly is backwards in the
base. Remove the motor/chute assembly and
turn it around. Repeat assembly step 4.
• Fit the cover over the peg and plug and into
the base.
• Insert two screws into the cover and tighten.
Socket
Plug
Groove
Cover
Peg
Plug
Ball Chute
3
4
5
6

5
Battery Safety
Information
Battery
Installation
• Loosen the screws in the battery
compartment door and remove the door.
• Insert four D (LR20) alkaline batteries.
Hint: We recommend using alkaline batteries
for longer battery life.
• Replace the battery compartment door and
tighten the screws.
• If this product begins to operate erratically,
you may need to reset the electronics. Slide
the power switch off and then back on.
• When ball release distance is greatly
reduced or if the time between ball releases
is long, it’s time for an adult to replace the
batteries.
Protect the environment by not
disposing of this product with
household waste (2012/19/EU).
Check your local authority for
recycling advice and facilities.
1,5V x 4
D (LR20)
In exceptional circumstances, batteries may
leak fluids that can cause a chemical burn
injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the product. Dispose of
batteries safely. Do not dispose of this
product in a fire. The batteries inside may
explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent
type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
product before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.

6
• We recommend using this toy outdoors, on
a non-paved surface, such as grass or sand.
Do not use outdoors when it is raining or
there is wet grass. The balls will not
launch properly.
• When your child is batting, be sure there
are no other children in or around the
batting area, including directly in front of
the unit.
• This toy is designed for use with foam
balls and plastic bat (both included). It is
not designed for use with wooden or metal
bats, or regulation baseballs or softballs.
Use of these balls and bats may damage
this toy.
• Hold the bat with hands together, about one
or two inches (2,5 - 5 cm) from the knob at
the end of the bat.
- Right handed batters should have the right
hand on top of the left hand.
- Left handed batters should have the left
hand on top of the right hand.
• Stand with feet about shoulder width apart.
• When hitting from the tee or pop-up, stand
close enough to hit the ball comfortably.
Look at the ball and swing with a smooth
and level motion.
• When hitting a pitched ball, stand no further
than 10 feet (three meters) from the unit.
• Keep your eyes on the ball as it pops up or
as it is being pitched.
• Swing with a smooth and level motion.
Hit from the tee!
• Position the ball chute completely upright.
• Place the ball on top of the ball chute.
• Your little player can hit the ball off the tee.
BeginnerBatting
Practice Tips

7
Balls pop up automatically to hit.
• Push the ball chute all the way back.
• Load the balls into the side of the ball chute.
• Locate the power switch on the top of the
motor. Slide the power switch ON .
• Press the automatic ball button and
get ready.
• Stand about two feet (0,6 meters) to the side
of the base.
• Hit the ball when it pops up!
Hit the pitched ball from up to 10 feet (three
meters) away!
• Position the ball chute completely upright.
• Load the balls into the side of the ball chute.
• Locate the power switch on the top of the
motor. Slide the power switch ON .
• Press the automatic ball button and
get ready.
• Stand up to 10 feet (three meters) away
from the front of the base.
• Watch the pitch and hit a home run!
Rookie Pro
Power
Switch
Automatic
Ball Button
A
A
A
A
A
A
A
A
A
A
A
A
A
Hint: After pressing the automatic ball button, the motor
shoots three balls and automatically turns off. Load the balls
into the side of the ball chute and press the automatic ball
button to shoot the balls again!
P
P
P
P
P

8
Consumer Information
Storage
• Load the balls into the side of the ball chute.
• Fit the bat in the circular opening in the base.
Care
• Do not leave this product outdoors. Store this
product indoors when not in use.
• This product may be wiped clean using a
mild cleaning solution and a damp cloth. Do
not use bleach. Do not use harsh or abrasive
cleaners. Rinse clean with water to remove
residue. Do not immerse this product.
• Periodically inspect this product for wear and
damage and replace any cracked parts.
CAN ICES-3 (B)/NMB-3 (B)
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must accept
any interference, including interference that may
cause undesired operation of the device.
L’utilisation de ce dispositif est autorisée
seulement aux conditions suivantes : (1) il ne doit
pas produire de brouillage et (2) il doit pouvoir
tolérer tout brouillage radioélectrique reçu, même
si ce brouillage est susceptible de compromettre
son fonctionnement.
FCC STATEMENT (UNITED STATES ONLY)
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation.This equipment generates
uses and can radiate radio frequency energy
and, if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communications.However, there is
no guarantee that interference will not occur
in a particular installation.If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
NOTE: Changes or modifications not expressly
approved by the manufacturer responsible for
compliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired operation.

2
WARNING
• To prevent injury from balls and moving parts:
- Keep face, head and hands away from the ball release.
- Use only the balls included.
- Never put other objects in the ball chute.
• Do not aim at eyes or face. Only use projectiles supplied with this toy.
Do not re at point blank range.
Consumer Information
CONSUMER ASSISTANC
E
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
©2016 Mattel. All Rights Reserved.
PRINTED IN CHINA
DTM20-0970
1101148709-DOM