Fisher-Price StarStation On-the-Go Micriphone J0222 User manual

Please keep this instruction sheet for future
reference, as it contains important information.
Requires three “AAA” (LR03) alkaline
batteries (not included).
Adult assembly is required for
battery installation.
Tool required for battery installation:
Phillips screwdriver (not included).
Today’s most popular songs
sung by kids for kids™
F
e
a
t
u
r
i
n
g
h
i
t
m
u
s
i
c
f
r
o
m
On-the-Go
Microphone™
www.fisher-price.com
J0222
Instructions

Battery Installation
• Locate the battery compartment on the back of the toy.
• Loosen the screw in the battery compartment door with a Phillips screwdriver.
Remove the battery compartment door.
• Insert three “AAA” (LR03) alkaline batteries, as indicated inside the
battery compartment.
Hint: We recommend using alkaline batteries for longer battery life.
• Replace the battery compartment door and tighten the screw with a Phillips screw-
driver. Do not over-tighten.
• When sounds become faint or stop, it's time for an adult to change the batteries!
1.5V x 3
“AAA” (LR03)
Shown Actual Size
Battery Compartment Door

Battery Safety Information
In exceptional circumstances, batteries may leak fluids that can cause a chemical
burn injury or ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove exhausted
batteries from the product. Dispose of batteries safely. Do not dispose of the product
in a fire. The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they are only to be charged under
adult supervision.
FCC Statement (United States Only)
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer
responsible for compliance could void the user's authority to operate the equipment.

P& © 2005 Razor & Tie Direct, L.L.C. “Kidz Bop,” “Razor & Tie” and the Razor & Tie Logo
are registered trademarks of Razor & Tie Direct, L.L.C. and “Kid Friendly,” “Kidz Bop Kids” and
“Sung By Kids For Kids” are trademarks of Razor & Tie Direct, L.L.C.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2005 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
PRINTED IN CHINA J0222pr-0920
• Insert the ROM cartridge into the slot
in the microphone.
Take the Show on the Road!
• Locate the voice volume switch on the
back of the toy.
• Slide the voice volume switch on the
back of the toy to either on with low
volume or on with high volume .
Hints:
- This switch controls the volume of your
voice. Set to the off position to
listen to music only.
- If you hear feedback or distortion, slide
the voice volume switch to low volume.
1
3
Voice Volume Switch
BACK VIEW

• Rotate the power/volume dial to turn
the microphone on.
Hint: This dial controls the volume of
the music. Turn the dial off when you
are finished playing with this toy.
2
4
Track Forward
• Press the play/pause button to start
the music and start singing. Press
again to pause.
• Press the track forward button to move
ahead to the next song on the ROM
cartridge.
• Use the volume/power dial to adjust
the music volume.
Hint: You can also sing without music by
removing the ROM cartridge.
Play/Pause
Power/Volume
Dial