Fisher-Price GeoTrax W6843 User manual

1
www.fisher-price.com
Each sold separately and subject to availability.
Vehicles shown in illustrations may be different
than the vehicle included with your toy.
W6843
W6845
W6844
W6846

2
Battery Installation
• Protect the environment by not disposing of this product with household waste
(2002/96/EC). Check your local authority for recycling advice and facilities.
Remote Controller
• Locate the battery compartment on
the back of the remote controller.
• Loosen the screw in the battery
compartment door with a Phillips
screwdriver. Remove the battery
compartment door and insert three
“AAA” (LR03) alkaline batteries.
• Replace the battery compartment door
and tighten the screw with a Phillips
screwdriver. Do not over-tighten.
• If the remote controller begins to operate
erratically, you may need to reset
the electronics. Remove the batteries
and reinstall.
1,5V x 6
“AAA” (LR03)
We recommend the use of alkaline
batteries for longer battery life.
IMPORTANT! Under normal use conditions, the batteries in the vehicle will require
replacement more often than the batteries in the remote controller. For additional
information, refer to the troubleshooting section on the last page of this sheet.
Vehicle
• Loosen the screws in the battery
compartment door with a Phillips
screwdriver. Open the battery
compartment door. Insert three
“AAA” (LR03) alkaline batteries.
• Replace the battery compartment door
and tighten the screws with a Phillips
screwdriver. Do not over-tighten.
• If the vehicle begins to operate
erratically, you may need to reset
the electronics. Remove the batteries
and reinstall.
• Please keep this instruction sheet for future
reference, as it contains important information.
• Requires six “AAA” (LR03) alkaline batteries
(not included) for operation.
• Adult assembly is required for battery installation.
• Tool required for battery installation: Phillips
screwdriver (not included).

3
Battery Safety Information
ICES-003
NMB-003
In exceptional circumstances, batteries may leak fluids that can cause a chemical burn
injury or ruin your toy. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove exhausted batteries from
the toy. Dispose of batteries safely. Do not dispose of this product in a fire. The batteries
inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging.
• If removable, rechargeable batteries are used, they are only to be charged under
adult supervision.
• This Class B digital apparatus complies with Canadian ICES-003.
• Operation is subject to the following two conditions: (1) this device may not cause harmful
interference and (2) this device must accept any interference received, including interference that
may cause undesired operation.
• Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
• L’utilisation de ce dispositif est autorisée seulement aux conditions suivantes : (1) il ne doit pas
produire de brouillage et (2) l’utilisateur du dispositif doit être prêt à accepter tout brouillage
radioélectrique reçu, même si ce brouillage est susceptible de compromettre le fonctionnement
du dispositif.

4
Consumer Information
FCC Statement (United States Only)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer responsible for
compliance could void the user’s authority to operate the equipment. This device complies with
Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause harmful
interference and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Care
• Wipe this toy with a clean cloth dampened with a mild soap and water solution. Do not
immerse this toy.
• This toy has no consumer serviceable parts. Do not take this toy apart.
PRINTED IN CHINA W6843pr-0920
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa, B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
Fisher Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2011 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.

5
Let's Go!
Hint: We do not recommend using the vehicle on carpets. For best performance, use on hard,
flat surfaces.
• Hold the remote controller with the stick facing you. Point the remote controller toward the
vehicle and push the stick forward. The vehicle moves forward.
• Pull back and release the stick to stop the vehicle.
• Pull the stick all the way back and the vehicle travels in reverse. Release the stick to stop.
1
2
3
FORWARD
OFF
REVERSE
2
3
1
• Press the power button on top of the vehicle. The ready light turns on.
POWER BUTTON READY LIGHT

6
Troubleshooting
PROBLEM SOLUTION
Vehicle drives slowly Battery power in the vehicle may be weak. Replace all three
batteries in the vehicle with new, alkaline batteries.
The wheels on the vehicle may be dirty. Wipe them with
a clean cloth.
Vehicle does not
respond to the
remote controller
Battery power in the remote controller may be weak. Replace all
three batteries in the remote controller with new, alkaline batteries.
You may be beyond the maximum range of the remote controller
which is about 12 feet (3,7 m).
You may not have a clear path between the remote controller
and the vehicle. This toy works best when there are no
obstructions between the vehicle and the remote controller.
Bright sunlight or fluorescent lights may affect the range of the
remote controller. Try dimming the room you are playing in.
The vehicle may have shut off. If you do not operate the remote
controller for a few minutes, the vehicle shuts off automatically
and the ready light turns off. Press the power button on the
vehicle, and operate the remote controller to restart.