Fisher-Price BFT59 User manual

5
Consumer Information
FCC Statement (United States Only)
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in
a particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
Note: Changes or modifications not expressly
approved by the manufacturer responsible for
compliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Troubleshooting
• This toy will enter “sleep mode” after a few
minutes of inactivity. To turn this toy back on, press
a systems or mission button, slide the claw switch,
lift or lower the blaster or fire a disk.
• When movement/sound/lights from Batbot
become slow/faint/stop, it is time for an adult to
change the batteries.
• If Batbot does not respond to the remote control,
it is time for an adult to change the batteries.
• If the remote control or Batbot are accidentally
dropped in the water, remove the batteries
and allow them to air dry. Replace with fresh
batteries before operation.
• Protect the environment by not disposing of this
product with household waste (2002/96/EC).
Check your local authority for recycling advice
and facilities.

Consumer Information
CO
N
SU
MER
ASS
I
S
T
A
N
C
E
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
PRINTED IN CHINA BFT56a-0920
ICES-003
This Class B digital apparatus complies with Canadian ICES-003. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference and (2) this device must accept
any interference received, including interference that may cause undesired operation.
NMB-003
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. L’utilisation
de ce dispositif est autorisée seulement aux conditions suivantes : (1) il ne doit pas produire de
brouillage et (2) l’utilisateur du dispositif doit être prêt à accepter tout brouillage radioélectrique reçu,
même si ce brouillage est susceptible de compromettre le fonctionnement du dispositif.
©2014 Mattel. All Rights Reserved.
® and ™ designate U.S. trademarks of Mattel, except as noted.
DC SUPER FRIENDS: TM & © DC Comics.
WB SHIELD: TM & © Warner Bros. Entertainment Inc.
(s14)

1
BFT59
CKB84
fisher-price.com
Battery installation is required.
Only adults should install batteries.
Tool required for battery
installation: Phillips screwdriver
(not included).
Keep this instruction sheet for
future reference, as it contains
important information.
Requires two AAA batteries
for remote control (not
included) and six AA batteries
for Batbot (included).
1,5V x 6
AA (LR6)
1,5V x 2
AAA (LR03)
Wipe toy with a clean,
damp cloth. Do not immerse.
This toy has no consumer
serviceable parts.
Do not take apart.

2
Battery Installation
• Loosen the screw in the battery compartment.
Lift to remove the battery compartment.
• Remove the exhausted batteries and dispose of
them properly.
• Insert six, new AA (LR6) alkaline batteries.
• Replace the battery compartment and tighten
the screw.
• If Batbot begins to operate erratically, you may
need to reset the electronics. Slide the power
switch off and then back on again.
• Loosen the screw in the battery compartment
door and remove the door.
• Insert two, new AAA (LR03) alkaline batteries.
• Replace the battery compartment door and
tighten the screw.
• If the remote control begins to operate erratically,
you may need to reset the electronics. Remove
and reinstall the batteries.
1,5V x 6
AA (LR6)
Remote Control
Batbot
Battery Safety Information
In exceptional circumstances, batteries may leak
fluids that can cause a chemical burn injury or ruin
your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of
different types: alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods of non-
use. Always remove exhausted batteries from
the product. Dispose of batteries safely. Do not
dispose of this product in a fire. The batteries
inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent
type as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
product before charging.
• If removable, rechargeable batteries are used,
they are only to be charged under
adult supervision.
1,5V x 2
AAA (LR03)
For longer life, use alkaline batteries.

3
2-in-1 Transformation
• Slide the Batbot power switch ON or OFF .
• Press the TRANSFORM button to lower into
Bat-Tank or raise to Batbot.
• Press and hold the FORWARD button to
move forward.
• Press and hold the BACK-UP AND TURN
button to back-up and turn.
• You can transform this toy using the turn disk.
Place a figure (or your fingers!) in the disk and
turn to transform!
• We do not recommend using the Batbot on
carpets. For best performance, use on hard,
flat surfaces.
BATBOT
BATBOT
POWER SWITCH
Remote Control
2
-
in
-
1
Transformation
C
CH
r
o
r
ol

4
Let’s Fight Crime!
• Open the hatch and insert the disks.
• Push the lever to fire at villains!
• Slide the switch completely forward the claw
“chomping” action!
• Press the systems button or the mission button
for cool phrases and lights!
Do not aim at eyes or face. Only use
projectiles supplied with this toy.
Do not fire at point blank range.
WARNING
• Lift or lower the blaster to activate sounds
and lights!
•
•
Ope
Ope
• P
us
D
o
p