Fisher-Price PowerMax Rescue Heroes Ultimate Robotic Vehicle... User manual

w
w
w
.r
e
s
cu
e
h
e
r
o
e
s
.
c
o
m
Model Number: 78362
Please keep this instruction sheet for future reference, as it contains important information.
Requires four “C” (LR14) and three “AAA” (LR03) alkaline batteries (not included).
Adult assembly is required for battery installation.
Tool required for battery installation: Phillips screwdriver (not included).
Ultimate Robotic Vehicle™
“URV” with Remote Control
Figures sold separately.

BATTERY INSTALLATION
1.5V x 4
”C” (LR14)
SHOWN ACTUAL SIZE
For best results, use only alkaline batteries.
2
•Locate the battery compartment door on the bottom
of each foot.
• Loosen the screw in each battery compartment door
with a Phillips screwdriver. Open the battery
compartment doors.
• Insert two “C” (LR14) alkaline batteries as indicated
in each battery compartment.
Hint: We recommend using alkaline batteries for
longer battery life.
• Close each battery compartment door and tighten
each screw with a Phillips screwdriver.
Do not over-tighten.
Battery
Compartment
Doors
Bottom View

3
Battery Tips
•Do not mix old and new batteries.
•Do not mix different types of batteries: alkaline, stan-
dard (carbon-zinc) or rechargeable (nickel-cadmium).
•Remove the batteries during long periods of non-use.
Always remove exhausted batteries from the toy. Battery
leakage and corrosion can damage this toy. Dispose of
batteries safely.
•Do not dispose of batteries in a fire. The batteries may
explode or leak.
•Never short circuit the battery terminals.
•Non-rechargeable batteries are not to be recharged.
•Only batteries of the same or equivalent type as recom-
mended in the “Battery Installation” instructions are to
be used.
•If removable rechargeable batteries are used, they are
only to be charged under adult supervision.
•Rechargeable batteries are to be removed from the toy
before they are charged.
•If you use a battery charger, it should be examined reg-
ularly for damage to the cord, plug, enclosure and other
parts. Do not use a damaged battery charger until it has
been properly repaired.
• Locate the battery compartment on the back of the
remote control.
• Loosen the screws in the battery compartment door
with a Phillips screwdriver. Remove the battery
compartment door.
• Insert three "AAA" (LR03) alkaline batteries, as indicated
inside the battery compartment.
• Replace the battery compartment door and tighten the
screws with a Phillips screwdriver. Do not over-tighten.
Hints:
• The "AAA" (LR03) batteries in the remote control have a
longer life than the "C" (LR14) batteries in URV's feet.
You may need to change the "C" batteries more often
than the "AAA" batteries.
• The "C" batteries in URV's feet only power his movement
(walking and motorized arm). When movement begins to
slow or stop, but speech and sound effects work normally,
replace the "C" batteries in URV's feet.
• The "AAA" batteries in the remote control power URV's
speech, spotlight and sound effects. If URV does not
function at all (no movement, speech or sound effects) ,
replace the "AAA" batteries in the remote control.
Remote Control Back View
1.5V x 3
”AAA” (LR03)
SHOWN ACTUAL SIZE
For best results, use only alkaline batteries.
BATTERY INSTALLATION

LET’S POWER UP
4
• Lower the platform on URV’s back to access the
power switch.
• Slide the power switch on URV’s back to the on •
position.
• When turned on, URV does a “system check” testing
his motors and sounds.
• When you are finished playing with URV, slide the
power switch to the off position.
Hint: When URV hasn’t been played with for a while,
he goes into “standby mode” awaiting further "com-
mands" from the remote control. Press any button on
the remote control to continue playing. If no buttons
are pressed, URV shuts down. URV’s lights go out and
his motorized arm returns to a resting position.
Platform
Power Switch
• Press the arrows on the remote control - URV walks
forward, backward, left and right.
LET'S MOVE OUT
CAUTION
To prevent entanglement, keep hair away
from wheels.
Backward
Right
Left
Forward
Back View

5
• Press the lever on the gripping hand to open it. URV
can carry equipment or other Rescue Heroes™ figures
in his hand.
• Press the joystick on the
remote control to move
URV’s motorized arm:
up, down, in and out.
MOTORIZED ARM GRIPPING HAND
Joystick

6
• Press the body extension lever on URV’s back. URV
springs up.
• To return URV's body to his standard position, press URV's
shoulders down until the body clicks back into place.
• Press the ultra spotlight button on URV’s back.
URV’s head pops up and the ultra spotlight turns on.
• To turn the ultra spotlight off and to return URV's head
to his standard position, press URV's head down until
it clicks back into place.
ACTIVATING THE ULTRA SPOTLIGHT ACTIVATING MAXIMUM
BODY EXTENSION
Ultra
Spotlight
Button
Body
Extension
Lever

• Lift the shield.
• Slide the connector on the back of a Rescue Heroes™
figure up into the slot in URV’s cockpit.
Hints
- For proper function, make sure the connector is com-
pletely inserted into the slot.
- Voice feature only works only with Voice Tech™ Rescue
Heroes™ figures.
• URV recognizes that a figure is on-board and if it’s a
Voice Tech™ figure, URV identifies the figure by name.
• Place the figure’s hands on the handles.
• Lower the shield.
USING RESCUE HEROES™
FIGURES WITH URV
Connector
Slot
Handle
You can use any Rescue Heroes™ figure with URV, but only
Voice Tech™ Rescue Heroes™ figures “talk” with URV.
7
Shield
(Figure not included.)
OTHER RESCUE HEROES™FIGURES
• Press the mission
button on URV’s
back. URV assigns a
mission to the Rescue Heroes™.
• Press the mission button to hear the Voice Tech™
figure “talk” with URV.
• Press the speech button on URV’s remote control
again and again. URV and the Voice Tech™ figure “talk”
to each other.
• Press the sound effects button on the remote con-
trol to hear robotic sounds.
USING URV WITH
VOICE TECH™FIGURES
• Press the mission button on URV’s back. URV assigns
a mission to the Rescue Heroes™.
• Continue pressing the mission button to hear other
phrases and missions from URV.
• Press the speech button on URV’s remote control to
hear URV say different phrases.
• Press the sound effects button on the remote con-
trol to hear robotic sounds.
Mission
Button
Back View

8
• Other figures can ride along on URV’s back.
• Lower the platform on URV’s back. Place a figure on the
platform. Fit the figure’s hands to the handles.
Platform
Handle
OPERATING THE WINCH
CAUTION
• Do not launch the claw at close range.
• Only use the projectile (claw) supplied
with this toy.
• Do not fire at people or animals.
RIDE ALONG
OPERATING THE WINCH
• Press the release button on URV’s arm. Hold the grasp-
ing claw and pull out the cord.
Hint: This will require some force and you will hear will
hear a loud “click.”
PULL OUT THE CLAW
1
1
Release
Button
• Insert the peg on the claw into the hole in the arm.
Press the claw until it locks in place.
Peg
2
2
LOAD
Release
Button
LAUNCH
• Press the release button to launch the grasping claw.
3
3
• Move the rewind lever back and forth to reel the claw
back in.
Rewind Lever
REWIND
4
4

STORAGE
9
• Slide the tab on the tool arm into the slot in URV’s
motorized arm.
• Fit the handle on the tool into the hole in URV’s hand.
USING POWERMAX™TOOLS
• Insert the plug from the tool into the PowerMax™ socket
in URV’s back.
PowerMax™ Socket
Plug
• Press the PowerMax™ tool button on the remote
control to activate the tool.
• To store the remote control, slide it on to the connec-
tor on URV’s back as shown.
Connector
PowerMax™
Tool Button
Back View
Tab
Slot
PowerMax™Tool
Hole
USING POWERMAX™TOOLS
Motorized Arm

• Wipe this toy with a clean cloth dampened with a mild
soap and water solution. Do not immerse this toy.
• This toy has no consumer serviceable parts. Do not take
this toy apart.
• Do not drop this toy on a hard surface.
CARE HELPFUL HINTS
10
• The "AAA" (LR03) batteries in the remote control have a
longer life than the "C" (LR14) batteries in URV's feet.
You may need to change the "C" batteries more often
than the "AAA" batteries.
• The "C" batteries in URV's feet only power his movement
(walking and motorized arm). When movement begins to
slow or stop, but speech and sound effects work normally,
replace the "C" batteries in URV's feet.
• The "AAA" batteries in the remote control power URV's
speech, spotlight and sound effects. If URV does not
function at all (no movement, speech or sound effects) ,
replace the "AAA" batteries in the remote control.