Fisher-Price Bounce and Spin Unicorn User manual

1
ASSEMBLY GUIDE
GGD19

2
UNITED STATES: 1-800-432-5437. Fisher-Price, Inc., 636 Girard Avenue,
East Aurora, NY 14052.
GREAT BRITAIN: Mattel UK Ltd, Vanwall Business Park, Maidenhead
SL6 4UB. Helpline: 01628 500303; www.service.mattel.com/uk.
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
CANADA: 1-800-432-5437. Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2.
AUSTRALIA: Mattel Australia Pty. Ltd., 658 Church Street, Locked
Bag #870, Richmond, Victoria 3121 Australia. Consumer Advisory
Service 1300 135 312.
NEW ZEALAND: 16-18 William Pickering Drive, Albany 1331, Auckland.
ASIA: Mattel East Asia Ltd., Room 503-09, North Tower, World Finance
Centre, Harbour City, Tsimshatsui, HK, China. Tel.: [phone].
MALAYSIA: Diimport & Diedarkan Oleh: Mattel Southeast Asia Pte. Ltd.,
No 19-1, Tower 3 Avenue 7, Bangsar South City, No 8, Jalan Kerinchi,
59200 Kuala Lumpur, Malaysia. Tel: [phone].
SOUTH AFRICA: Mattel South Africa (PTY) LTD, Oce 102 I3,
30 Melrose Boulevard, Johannesburg 2196.
©2018 Mattel.
PRINTED IN CHINA
GGD19-0970
1102061717-DOM

3
BEFORE YOU BEGIN
Three AA (LR6) alkaline
batteries are required
(not included).
For longer life, use
alkaline batteries.
Adult assembly
is required. You’ll need
a Phillips screwdriver
(not included) for
assembly and battery
installation. Do not
over-tighten screws.
Keep these
instructions for future
reference as they
contain important
information.
Clean with
a damp cloth.
Do not immerse.
Set aside 30 minutes
for assembly. Assembly
instructions are on the
back side of this sheet.
30
CAUTION
This package contains small
parts. For adult assembly only.
x3
1,5V
AA
(LR6)
NOTE
Adult supervision required.
For children able to get on and
off unassisted.
This product is intended for use
indoors on carpeted surfaces.
This product spins only when
a child is sitting on the seat.
Maximum weight: 55 lb (25 kg).
This toy has no consumer
serviceable parts. Do not take
this toy apart.
Check the plastic parts regularly
and if broken or cracked,
dispose of them properly.
Actual product may vary
from images.
INSTALL BATTERIES
Locate the battery compartment on the back
of the handlebar.
Loosen the screw in the battery door and
remove the door.
Insert three AA (LR6) alkaline batteries.
Replace the battery door and tighten the screw.
When lights or sounds from this toy become
faint or stop, it’s time for an adult to change
the batteries.

4
READY TO BOUNCE AND LEARN
Protect the environment by not disposing of this product or any
batteries with household waste. This symbol indicates that this
product shall not be treated as household waste. Check your local
authority for recycling advice and facilities.
Spin the roller for colorful lights, phrases, and a song. Press the
ABC or 123 buttons to hear learning songs, phrases, and sounds.
Slide to for fun phrases that teach baby
letters, numbers, and colors as they
bounce along.
Slide to and start bouncing to hear songs
that encourage baby to bounce to the beat.
Slide to turn power ON with low volume ,
ON with high volume or OFF when
finished playing.
If this product begins to operate erratically,
you may need to reset the electronics. Slide
the power-volume switch off and back on.

5
CONSUMER INFORMATION
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that can cause
a chemical burn injury or ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types:
alkaline, standard (carbon-zinc) or rechargeable.
• Insert batteries as indicated inside the battery compartment (+ and -).
• Remove batteries during long periods of non-use. Always remove
exhausted batteries from the product. Dispose of batteries safely. Do not
dispose of this product in a fire. The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they are only to be
charged under adult supervision.
CAN ICES-3 (B)/NMB-3 (B)
Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
L’utilisation de ce dispositif est autorisée seulement aux conditions
suivantes : (1) il ne doit pas produire de brouillage et (2) il doit pouvoir
tolérer tout brouillage radioélectrique reçu, même si ce brouillage est
susceptible de compromettre son fonctionnement.
FCC STATEMENT (UNITED STATES ONLY)
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
NOTE: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user’s authority
to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.

6
ASSEMBLED PARTS
M5 x 2,2 cm
x 10

7 8 9
ASSEMBLY
1
4x 3
x
ASSEMBLY
2
5x 3
x
3
ASSEMBLY
6Turn the assembly
upright.
upr
igh
t.

10 11 12
ASSEMBLY
10
7 8
11 x 2
ASSEMBLY
9
12
ASSEMBLY
x 2