Fisher-Price Roll-a-Rounds Jungle Friends Treehouse User manual

M4188
Please keep this instruction sheet for future reference,
as it contains important information.
Requires three “C” (LR14) alkaline batteries (not included).
Adult assembly is required.
Tool required for battery installation: Phillips screwdriver (not included).
www.fisher-price.com

#4 x 1
/
2"Screw - 3
Shown Actual Size
Bridge
Tree House
3 Balls
Short Tree
Base
Parts
CAUTION
Note: Tighten and loosen all screws
with a Phillip screwdriver. Do not over
tighten the screws.
This package contains small parts. For adult assembly only.

• “Snap” the treehouse into the base.
•“Snap” the short tree into the base.
• Fit the bridge onto the posts on the treehouse and the branch on the short tree,
as shown.
• Insert three screws into the bridge. Tighten the screws.
1
2
Assembly

Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. PRINTED IN CHINA
©2007 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. M4188pr-0920
In exceptional circumstances, batteries
may leak fluids that can cause a chemical
burn injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the product. Dispose of
batteries safely. Do not dispose of this
product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from
the product before charging.
• If removable, rechargeable batteries
are used, they are only to be charged
under adult supervision.
Battery Safety
Information
• Locate the battery compartment on
the bottom of the base.
• Loosen the screws in the battery
compartment door. Remove the battery
compartment door.
• Insert three “C” (LR14) alkaline batteries.
Hint: We recommend using alkaline
batteries for longer battery life.
• Replace the battery compartment door
and tighten the screws.
• When sounds or motions from this toy
become faint or stop, it’s time for an
adult to change the batteries!
1.5V x 3
“C” (LR14)
Battery
Installation
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).

Fun Music and Motion
• Locate the power/volume switch on the bottom of the toy.
• Slide the switch to the desired position: Off ; on with low volume ; or on with
high volume .
• Press the big button to start fun motions and music. Press again to stop.
• Drop the balls down the treehouse, waterfall or small tree to activate music and
motions too!
• Wipe the surface with a clean cloth dampened with a mild soap and water
solution. Do not immerse the toy.
PRESS
Power Switch
(On Bottom)

Consumer Information
United States Only
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer
responsible for compliance could void the user’s authority to operate the equipment.
FCC Statement