Fisher-Price Link-a-doos C0128 User manual

WARNING
Please keep instruction sheet for future reference, as it contains important information.
Requires one 9 volt (6LR61) and three “AA” (LR6) alkaline batteries (not included).
Adult assembly is required for battery installation.
Tool required for battery installation: Phillips Screwdriver (not included).
To prevent strangulation, never place product in a crib or playpen where baby
could become entangled. NEVER add strings or ties to the product.
Car Seat Dashboard
Car Seat Dashboard
Car Seat Dashboard ™
with Remote Control
with Remote Control
with Remote Control
C0128
Instructions

Battery
Compartment
Door
Dashboard
Cover
Battery Installation Battery Safety Information
Hint: We recommend the use of alkaline batteries for
longer battery life.
9V
(6LR61)
1.5V x 3
“AA” (LR6)
SHOWN
ACTUAL SIZE
SHOWN ACTUAL SIZE
Battery
Compartment
Door
Remote
Control
Dashboard
• Turn the dashboard face down. Open the fasteners on the
cover to locate the battery compartment on the dashboard.
• Loosen the screws in the battery compartment door with a
Phillips screwdriver. Remove the battery compartment door.
• Insert three “AA” (LR6) alkaline batteries.
• Close the battery compartment door and tighten the screws
with a Phillips screwdriver. Do not over-tighten.
Remote Control
• Loosen the screws in the battery compartment door with a
Phillips screwdriver. Remove the battery compartment door.
• Snap the contacts of a 9V (6LR61) alkaline battery to the
contacts inside the battery compartment.
• Close the battery compartment door and tighten the screws
with a Phillips screwdriver. Do not over-tighten.
2
Setup
• Slide the power/volume control switch on to low volume .
The system is now active for approximately two hours.
• Press the lion to hear a short song. Adjust the volume to a
comfortable listening level for your child by either:
- keeping the switch on low volume .
- sliding the switch to high volume .
• Re-fasten the fasteners on the cover.
Hints:
- Although the system is active, unless the dashboard is
playing music or sound effects and lights are twinkling, only
a very small amount of battery power is being used.
- If the toy is not used for more than two hours, it turns off
automatically. To reactivate the toy, simply press the lion.
Power/
Volume
Control
Switch
Batteries may leak fluids that can cause a chemical burn injury
or ruin your toy. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different
types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated on the battery compartment door.
• Remove batteries during long periods of non-use. Always
remove exhausted batteries from the toy. Dispose of
batteries safely. Do not dispose of batteries in a fire.
The batteries may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type,
as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging.
• If removable, rechargeable batteries are used, they are only
to be charged under adult supervision.

Attaching the Dashboard to a Car Seat
IMPORTANT! This product is designed to attach to most car seats. If, after attaching this product to your car seat, you find
that you cannot properly tighten your car seat’s restraint system (as described in the car seat manufacturer’s instructions),
DO NOT use this product on the car seat.
3
• Position the dashboard upright with the smiley face
towards baby.
• Fasten the clips on the underside of the dashboard to
the car seat bolster fabric, as shown.
Clip
Car Seat
Bolster Fabric
Car Seat with Bolster
IMPORTANT! Before attaching the dashboard to your car
seat’s restraint system, check to be sure the car seat
restraint system is securing your child properly! Check
all restraint system belts (shoulder, lap, crotch, etc.) by
pulling on them. The straps should not pull more than
one inch (two fingers) away from your child.
• Position the dashboard with the smiley face towards baby.
• Wrap the dashboard straps around the crotch strap (of the
car seat restraint system) and fasten.
Smiley Face
Car Seat
Restraint System
Car Seat with 3-Point or
5-Point Restraint
Hint: This toy does not fit tightly to your car seat restraint
system, so it does not interfere with securing your child in the
car seat.
Hint: This toy is designed to be moveable on your child’s lap.
Smiley Face
Crotch
Strap

Adult Use with Remote Control
• Slide the power/volume control switch to high or low volume
to activate the system.
• Press the remote control button once for fun songs and a
light display. Music and lights plays for approximately
three minutes.
• To pause, press the remote control control button again.
• To switch to soothing songs, press the remote control button
a third time. A musical selection and light display plays for
approximately three minutes.
• To pause songs, press the remote control button again.
• To replay fun songs, press the remote control button again.
Hint: Each time the remote control button is pressed, the
dashboard will cycle between fun songs - pause - soothing
songs - pause, etc.
Attaching the Remote Control
to a Vehicle Visor
• Attach the remote control clip to the top of the vehicle visor,
as shown.
Hint: The remote control does not need to be in direct line
with dashboard.
Visor
Remote
Control
4
The Car Seat Dashboard can be used in two
ways: Adult activated by remote control or child
activated by pressing on the lion.

Child Use with Dashboard Only
• Each time your child presses the smiley face, you’ll hear
a sound effect and a short tune along with twinkling lights.
Care
Back View
Front View
Curved Edge
• Once cleaned and dried, unfasten the fasteners on the
underside of the cover.
• Position the plastic unit so that the curved edge is toward
the curved edge of the cover.
• Fit the plastic unit into the cover. Re-fasten the cover
fasteners closed.
• Turn the dashboard upright. Fit the two lenses on the
plastic unit through the two holes in the cover.
Back View
• Remove the plastic unit before washing the fabric
dashboard cover.
- Unfasten the fasteners on the back of the cover.
- Remove the plastic unit from the cover.
• Re-fasten the fasteners on the cover before washing. The
cover is machine washable. Wash the cover separately in
cold water on the gentle cycle. Do not use bleach.Tumble
dry on low heat.
• Do not immerse the plastic unit.
Plastic Unit
Cover
Fasteners
5
Remove the Plastic Unit for WashingCar Seat with Bolster
Replace the Plastic Unit for Use
Lenses
Holes
Dashboard Smiley Face

Consumer Information
FCC Note (United States Only)
Hints
Questions? We'd like to hear from you!
Call Fisher-Price®Consumer Relations, toll-free at 1-800-432-5437,
8 AM - 6 PM EST Monday through Friday. Hearing-impaired
consumers using TTY/TDD equipment, please call 1-800-382-7470.
Or, write to: Fisher-Price®Consumer Relations, 636 Girard Avenue,
East Aurora, New York 14052.
Car Seat Dashboard
Model Number: C0128
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference and (2) this device must accept
any interference received, including interference that may
cause undesired operation.
Car Seat Dashboard
Consumer Relations Department
636 Girard Avenue
East Aurora, New York 14052
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician
for help.
Note: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user's
authority to operate the equipment.
For countries outside the United States:
CANADA Questions? 1-800-567-7724. Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2.
GREAT BRITAIN Mattel UK Ltd, Vanwall Business Park, Maidenhead SL6 4UB.
Helpline: 01628 500302.
AUSTRALIA Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870,
Richmond, Victoria 3121 Australia. Consumer Advisory Service 1300 135 312.
NEW ZEALAND 16-18 William Pickering Drive, Albany 1331, Auckland.
ASIA Mattel East Asia Ltd, Room 1106, South Tower, World Finance Centre,
Harbour City, Tsimshatsui, HK, China.
• If you will not use this product for an extended period of
time, we recommend turning power completely off. Simply
slide the power/volume control switch on the back of the
dashboard to off . Be sure to follow the set-up
instructions, and turn power back on for future use.
• If sounds or lights from this toy become faint or stop, it’s
time for an adult to replace the batteries!
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2003 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
Printed in China C0128pr-0920