Fisher-Price P5332 User manual

www.fisher-price.com
Please keep this instruction sheet for future reference,
as it contains important information.
Requires four "C" batteries
(included) for operation.
Adult assembly is required for battery replacement.
Tool required for battery replacement:
Phillips screwdriver (not included).
P5332

2
WARNING
Prevent Entanglement Injury
• This product may not attach
to all crib designs. Do not
add additional strings or
straps to attach to a crib
or playpen.
• Use ONLY attached to a crib.
Consumer Information Before Use
Note: A plastic tab was attached to the
toy for in-store demonstration purposes.
While the tab may have already been
removed, check the back of the toy to
be sure. If the plastic tab is still attached,
pull and remove the tab from the toy.
Throw the plastic tab away.

3
IMPORTANT! Always attach all provided
fasteners (strings, straps, clamps, etc.)
tightly to a crib or playpen according to
the instructions. Do not add additional
strings or straps to attach to a crib.
Check frequently.
Slot Crib Rail
Attachment
Strap
IMPORTANT! If you are attaching this toy
to a crib side rail that can be lowered and
raised, make sure the crib side rail is in the
raised (locked) position whenever a child
is in the crib.
• Position the toy inside the crib.
• Wrap one of the toy’s attachment straps
around the crib rail.
• Slide the end of the attachment strap
under the tabs on the back of the toy.
• Fasten the attachment strap slot to the
peg on the back of the toy.
• Repeat this procedure to secure the
other attachment strap.
Note: This toy should be snug against the
crib rail and spindles. Use the strap slot
that provides the tightest fit.
• Make sure the distance between the
bottom of the product and the crib
mattress is at least 7 inches (18cm).
• If the distance is less than 7 inches (18cm):
readjust the attachment straps to lift the
product; or lower the crib mattress.
Crib Attachment
• Tie the toy’s strings to a crib spindle.
Note: It is better to tie the strings in
a knot than a bow, since a bow may be
easily untied.
Peg
Tabs
7" (18cm)
7" (18cm)

Soothing Sights and Sounds
4
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. P5332pr-0920
©2009 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. PRINTED IN CHINA
Power/Volume
Switch
Mode Switch
• Slide the mode switch to music or
music with lights and motion .
Plays up to approximately
18 minutes of music or
nature sounds.
Baby can watch gentle motion
and soothing light effects while
listening to music or nature sounds.
Mode Switch
Power/Volume Switch
• Slide the power/volume switch to on
with low volume , on with medium
volume or on with high volume .
• When finished using this toy, slide the
power/volume switch OFF .
Music and Sounds
• Press the sound select buttons on the
front of the soother to choose Nature,
Classical or Lullabies.
Sound Select
Buttons

5
For best results, we recommend
replacing the batteries that came
with this toy with four, new "C" (LR14)
alkaline batteries.
• Loosen the screws in the battery
compartment door with a Phillips
screwdriver. Remove the battery
compartment door.
• Insert four "C" (LR14) alkaline batteries.
Hint: We recommend using alkaline
batteries for longer battery life.
• Replace the battery compartment door
and tighten the screws with a Phillips
screwdriver. Do not over-tighten.
• If this product begins to operate
erratically, you may need to reset the
electronics. Slide the power/volume
switch off and then back on.
• If sounds, lights or motions from this
toy become faint or stop, it’s time for
an adult to change the batteries.
Battery Replacement Battery Safety
Information
In exceptional circumstances, batteries may
leak fluids that can cause a chemical burn
injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the product. Dispose of
batteries safely. Do not dispose of
product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery terminals.
•
Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
product before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).
1.5V x 4
"C" (LR14)

Care
• To clean, wipe the surface of this toy with
a damp cloth. Do not immerse this toy.
• Do not drop this toy on a hard surface.
• This toy has no consumer serviceable
parts. Please do not take this toy apart.
Consumer Information
6
ICES-003
• This Class B digital apparatus complies
with Canadian ICES-003.
• Operation is subject to the following two
conditions: (1) this device may not cause
harmful interference and (2) this device
must accept any interference received,
including interference that may cause
undesired operation.
NMB-003
• Cet appareil numérique de la classe
B est conforme à la norme NMB-003
du Canada.
• L’utilisation de ce dispositif est autorisée
seulement aux conditions suivantes :
(1) il ne doit pas produire de brouillage et
(2) l’utilisateur du dispositif doit être prêt
à accepter tout brouillage radioélectrique
reçu, même si ce brouillage est susceptible
de compromettre le fonctionnement
du dispositif.
FCC Statement (United States only)
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and
can radiate radio frequency energy and,
if not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
Note: Changes or modifications not
expressly approved by the manufacturer
responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.