Fisher-Price V2760 User manual

V2760
Please keep this instruction sheet for future reference, as it contains important information.
Requires three “AA” batteries (included) for operation.
Adult assembly is required for battery replacement.
Tools required for battery replacement: Phillips screwdriver (not included).
www.fisher-price.com

Battery Replacement
13
2
For best performance, we recommend replacing the batteries that came with this toy
with three, new “AA” (LR6) alkaline batteries.
• Open the fasteners on the bottom of
the ball.
2
• Lift the fabric tab and remove the
sound box.
• Loosen the screws in the sound box
battery compartment door with a
Phillips screwdriver. Remove the door.
Remove the batteries and dispose of
them properly.
• Insert three, new “AA” (LR6) alkaline
batteries.
Hint: We recommend using alkaline
batteries for longer battery life.
• Replace the battery compartment
door and tighten the screws. Do not
over-tighten.
Sound
Box

4
IMPORTANT! To ensure proper function,
follow this step carefully.
• Align the face on the sound box with
the face on the front of the ball. Fit the
sound box back inside the ball.
• Fold the fabric tab over the bottom
of the sound box Aand secure the
fasteners B.
• If this toy begins to operate erratically,
you may need to reset the electronics.
Slide the power/volume switch off and
then back on.
• When sounds from this toy become
faint or stop, it’s time for an adult to
change the batteries.
Battery Replacement
• Protect the environment by not
disposing of this product with
household waste (2002/96/
EC). Check your local authority
for recycling advice and
facilities (Europe only).
5
3
A
B
Faces

Power/Volume Switch
• Open the fasteners on the bottom of
the ball.
• Pull the sound box out and slide the
power/volume switch to ON
with low volume or ON with
high volume .
• Replace the sound box back inside
the ball.
Note: Make sure the face on the sound
box is aligned with the face on the front
of the ball.
4
Battery Safety
Information
In exceptional circumstances, batteries
may leak fluids that can cause a chemical
burn injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the product. Dispose of
batteries safely. Do not dispose of this
product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery
terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable
batteries.
• Remove rechargeable batteries from
the product before charging.
• If removable, rechargeable batteries
are used, they are only to be charged
under adult supervision.
1,5V x 3
“AA” (LR6)
Care
• The soccer ball is machine washable.
First remove the sound box inside the
soccer ball. Machine was the ball in
cold water on the gentle cycle. Do not
use bleach. Tumble dry on low heat.
• Do not immerse the sound box.
• After washing and drying is complete,
replace the sound box inside the ball.
Be sure that the sound box is replace
properly.

3 Interactive Modes!
• Press the nose on the front of the ball
to choose a mode: Learning,Music or
Imagination.
Learning Mode
• Roll the ball for counting fun!
Music
• Roll the ball to hear fun songs and
silly sounds.
Imagination
• Roll the ball for realistic soccer sounds!
IMPORTANT! If the mode (Learning or
Music or Imagination) does not switch
after pressing the nose on the ball, try
removing and replacing the sound box
inside the ball. Be sure the face and
speaker on the sound box are aligned
with the face on the ball.
Press
5
Hint: The soccer ball goes into sleep
mode after approximately 5 minutes of
inactivity. Press the nose on the ball to
wake it up.
• When you are finished playing with the
toy, open the fasteners and sllide the
power switch OFF .

This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency
energy and, if not installed and used
in accordance with the instructions,
may cause harmful interference to
radio communications. However, there
is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
Note: Changes or modifications not
expressly approved by the manufacturer
responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) this device
may not cause harmful interference
and (2) this device must accept any
interference received, including
interference that may cause
undesired operation.
FCC StatementConsumer Information
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa, B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
ICES-003
• This Class B digital apparatus complies
with Canadian ICES-003.
• Operation is subject to the following
two conditions: (1) this device may not
cause harmful interference and (2) this
device must accept any interference
received, including interference that
may cause undesired operation.
NMB-003
• Cet appareil numérique de la classe B
est conforme à la norme NMB-003
du Canada.
• L’utilisation de ce dispositif est
autorisée seulement aux conditions
suivantes : (1) il ne doit pas produire
de brouillage et (2) l’utilisateur du
dispositif doit être prêt à accepter tout
brouillage radioélectrique reçu, même
si ce brouillage est susceptible de
compromettre le fonctionnement
du dispositif.
Fisher-Price, Inc., a subsidiary of Mattel, Inc. East Aurora, New York 14052, U.S.A.
©2010 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
PRINTED IN CHINA V2760pr-0920