Fisher-Price Shake 'n Go Flyers K7363 User manual

Please keep this instruction sheet for future reference,
as it contains important information.
Requires three "AA" batteries (included).
Adult assembly is required (for battery replacement).
Tool required for battery replacement:
Phillips screwdriver (not included).
Each sold separately and subject to availability.
www.fisher-price.com
™
K7362
K7363

• Locate the battery compartment door
on the side of the launcher.
• Loosen the screw in the battery
compartment door with a Phillips
screwdriver. Remove the battery
compartment door.
• Remove the exhausted batteries and
throw them away.
• Insert three, new "AA" (LR6)
alkaline batteries.
Hint: We recommend using alkaline
batteries for longer battery life.
• Replace the battery compartment
door and tighten the screw with
a Phillips screwdriver. Do not
over-tighten.
• When sounds or lights become
faint or stop, it’s time for an adult to
change the batteries!
For best performance, we recommend
replacing the batteries that came with
this toy with three, new alkaline “AA”
(LR6) batteries.
Battery Safety Information
In exceptional circumstances,
batteries may leak fluids that can
cause a chemical burn injury or ruin
your toy. To avoid battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or recharge-
able (nickel-cadmium).
• Insert batteries as indicated inside
the battery compartment.
• Remove batteries during long
periods of non-use. Always remove
exhausted batteries from the toy.
Dispose of batteries safely. Do not
dispose of the product in a fire.
The batteries inside may explode
or leak.
• Never short-circuit the battery
terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable
batteries.
• Remove rechargeable batteries from
the toy before charging.
• If removable, rechargeable batteries
are used, they are only to be
charged under adult supervision.
1.5V x 3
"AA" (LR6)
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).
Battery Replacement
Before First-Time Use
CAUTION
Please keep small parts such as
plastic tabs out of children’s reach.
Throw the plastic tab away.
Note: A plastic tab was attached to the toy
for in-store demonstration purposes. While
the tab may have already been removed,
check the toy to be sure. If the plastic tab
is still attached, pull and remove the tab
from the toy. Throw the plastic tab away.

Shake It, Then Launch It!
• Locate the power switch on the side
of the launcher.
• Slide the switch to to turn the
launcher on. • Shake the launcher for lights and
sound effects.
• As you shake the launcher, the
plane moves back to prepare for
launch. The more you shake, the
further the plane will fly.
Hint: Shake 4 or 5 times for
maximum distance and the light on
the back of the launcher glows.
Shaking more than this does not
increase the distance.
• Gently slide the plane into the groove
on the end of the launcher until you
feel a click.
• The launcher starts up and automati-
cally locks the plane in place.
IMPORTANT! Do not pull the plane back
all the way.
• Squeeze the trigger to launch
the plane.
• Only use projectiles supplied with
this toy. Do not launch at people or
animals or at point blank range.
Tip: You can make minor repairs to
your airplane using adhesive tape.
Do not use glue.
2
3
4
1

Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2007 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
PRINTED IN CHINA K7362a-0920
Consumer Information
United States Only
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer
responsible for compliance could void the user’s authority to operate the equipment.
FCC Statement
• Wipe this toy with a clean cloth dampened with a mild soap and water solution.
Do not immerse this toy.
• This toy has no consumer serviceable parts. Do not take this toy apart.
Care
Visit us on line at www.service.fisher-price.com
Call Fisher-Price®Consumer Relations, toll-free at 1-800-432-5437, 9 AM - 7 PM EST
Monday through Friday and 11 AM - 5 PM EST Saturday. Hearing-impaired consumers
using TTY/TDD equipment, please call 1-800-382-7470. Write to us at: Fisher-Price®
Consumer Relations, 636 Girard Avenue, East Aurora, New York 14052.
For countries outside the United States:
CANADA: Questions? 1-800-432-5437. Mattel Canada Inc., 6155 Freemont Blvd., Mississauga, Ontario L5R 3W2;
www.service.mattel.com.
GREAT BRITAIN: Mattel UK Ltd, Vanwall Business Park, Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
AUSTRALIA: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond, Victoria 3121 Australia.
Consumer Advisory Service 1300 135 312.
NEW ZEALAND: 16-18 William Pickering Drive, Albany 1331, Auckland.
ASIA: Mattel East Asia Ltd, Room 1106, South Tower, World Finance Centre, Harbour City, Tsimshatsui, HK, China.