Fisher-Price Little People M7948 User manual

www.fisher-price.com
Please keep this instruction sheet for future reference, as it contains
important information.
Requires four “C” (LR14) alkaline batteries (not included).
Adult assembly is required.
Tool required for battery installation: Phillips screwdriver (not included).
M7948

Assembled Parts
Grandstand
Flags
Shifter
Trophy
Track

Battery Installation
• Locate the battery compartment on the bottom of the toy.
• Loosen the screws in the battery compartment door with a Phillips screwdriver. Remove the
battery compartment door.
• Insert four “C” (LR14) alkaline batteries.
Hint: We recommend using alkaline batteries for longer battery life.
• Replace the battery compartment door and tighten the screws with a Phillips screwdriver.
• If the toy begins to operate erratically, you may need to reset the electronics. Turn the key on the
toy off and then back on.
• When sounds or motion from this toy become faint or stop, it’s time for an adult to change
the batteries.
• Protect the environment by not disposing of this product with household waste
(2002/96/EC). Check your local authority for recycling advice and facilities (Europe only).
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury
or ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-
zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove exhausted batteries from
the product. Dispose of batteries safely. Do not dispose of this product in a fire. The batteries
inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they are only to be charged under
adult supervision.
1.5V x 4
“C” (LR14)

Assembly
Fisher-Price, Inc., a subsidiary of Mattel, Inc. East Aurora, New York 14052, U.S.A. M7948a-0920
©2008 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. PRINTED IN CHINA
• “Snap” the grandstand onto the track.
1
1
Grandstand
Track
Flags
Shifter
• “Snap” the shifter into the slot as shown.
1
2
• Insert the flags into the flag posts around the track.
1
3

Start Your Engines!
• Slide the power switch on the bottom of the track to the on position .
• Drive the cars onto the track.
• Turn the key to start your engines!
Note: When you turn the key the track will stay on for 30 seconds. To restart the track, turn the
key off and then back on again.
• Use the shifter to drive faster.
• Pull over to the pit stop for a tune-up. Lift the ramp to roll the car onto the track.
Power Switch
Grandstand
Key
Shifter
Ramp
• After the race, open the off-ramp gate to drive off.
• Cars can be stored behind the grandstand when not in use.
Off-Ramp Gate

Consumer Information
Care
• Wipe the toy with a clean cloth dampened with a mild soap and water solution.
• Do not immerse the toy.
FCC Statement (United States Only)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and (2) this device must accept
any interference received, including interference that may cause undesired operation.