Fisher-Price SUPERSIZE SANDBOX 75967 User manual

Supersize Sandbox
Instructions
Model 75967
• Please save these instructions for future reference.
• Adult assembly is required.
• No tools are needed for assembly.
• If you experience a problem with this product, or are missing a
part, please call us at 1-800-432-KIDS, rather than return this
product to the store.
• This product holds up to 500 lbs. of sand (not included).
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, New York 14052, U.S.A.
©1999 Mattel, Inc. All Rights Reserved. Printed in U.S.A.
® and ™ designate U.S. trademarks of Mattel, Inc. 75967 A 0920
• Check the plastic parts regularly and if broken or cracked, dispose of them properly.
• Use a mild soap and water solution and clean cloth to clean this product. Rinse with
clean water to remove soap residue.
• Remove sand from the sandbox.
• Turn the sandbox upside-down.
• Push the tabs outward on the bottom of the base to remove the cap.
Separate the panels.
• Store all parts indoors when the outdoor temperature drops below freezing.
Base
Tabs
Tabs
Care
Storage
Bottom View of Sandbox
• Cover the sandbox to help keep water and dirt out of the sandbox.
• Spread the cover over the top of the sandbox.
• Fasten the elastic loops on the cover to the pegs on the side of the sandbox.
Helpful Hint: Place a sand pail upside-down (or similar object) in the center of the sandbox
before putting on the cover. This will help to keep water off of the top of the cover.
Clean-up
Elastic Loop
Peg

• Fill the sandbox with up to 500 lbs. of sand.
Let’s Play
Parts
Base
Cover
Cap
8 Panels
• Place the base on the surface in which you intend to use
the sandbox.
Note:
Assemble the panels to the base going in a clock-
wise direction.
• Fit the grooves on one of the panels to the ribs on the
base, as shown.
• Fit another panel onto the base. Snap both tabs on the
first panel into the slots on the second panel.
• Insert and snap the cap to the base and panels.
Assembly is now complete.
13
Tab
Tabs
Slots
Grooves
2nd Panel
Clockwise
1st Panel Base
Ribs
Cap
Base
Assembly Assembly
Helpful Hint: You may have difficulty snapping the panel
tab closest to the base. Lift the assembly up slightly.
While pushing up from the underside of the assembly
(directly below the tab), push down on the topside of the
assembly (directly above the tab).
• Insert and snap the tab on the outside edge of the first
panel into the slot in the outside edge of the second
panel.
•Repeat this procedure to assemble the remaining six
panels to the base.
Tabs
Push Down
Push Up
2