Flexco MSRT User manual

Replacement Anvil Instructions for
Steel MSRT and MSRT8 Tools
Instructions
1A. Place Clamp Bar nut block under the
anvil. Make sure to line up the bolt holes
in the anvil with the holes in the clamp bar
locator block.
1B. Make sure that the nut block is on the
outside edge of the tool. When attaching
the anvil on the le side of the tool, the nut
block should be secured to the le side of
the anvil.
1C. If the anvil is going on the right side of
the tool, the nut block should be secured to
the right side of the anvil.
2. Using the enclosed allen wrench, secure
the clamp bar nut block to the anvil with the
two enclosed bolts.
3. Turn tool over to access the bottom of the
tool. Using pliers, remove cotter pin from
the gauge pin guide. en remove spring.
4. If the gauge pin guide does not fall out
on its own, turn the tool to its side and
remove it.
Note: Steps 1-2 cover end anvils. If you are replacing an interior (middle) anvil, skip to Step 3.
A. Cotter Pin, Spring,
and Gauge Pin Guide
B. Guide Block Locator Bolts
C. 3/4” (19 mm) anvil bolts
D. 7/8” (22 mm) anvil bolts
A
C
D
B
FINAL
061311

2525 Wisconsin Avenue • Downers Grove, IL 60515-4200 U.S.A.
Tel: [phone] • Fax: [phone] • E-mail: info@exco.com
Visit www.flexco.com for other Flexco locations and products.
©2011 Flexible Steel Lacing Company. 12-13. For Reorder: X2468
5. Using a 1/2” or 13 mm wrench, loosen
the two guide block locator bolts.
6. Turn the tool on its side and remove both
guide block locators.
7. Using a 7/16” or 11 mm wrench, remove
the four bolts in the center of the anvil
plate. ese bolts measure 3/4” or 19 mm
in length.
8. Using a 7/16” or 11 mm wrench, remove
the four bolts on the end of the anvil plate.
ese bolts measure 7/8” or 22 mm in length.
9. Remove existing anvil Plate from the tool
and place new anvil plate on the tool.
10. Re-insert all bolts into the tool and
hand tighten them. e four anvil bolts
that measure 3/4”(19 mm) should be in the
middle and the four anvil bolts that measure
7/8” (22 mm) should be on the outside edge.
11. Using a 7/16” or 11 mm wrench, tighten
the eight anvil bolts. Tighten the shorter
bolts-3/4” (19 mm) rst.
12. Place the guide block locators back on
the tool and using a 1/2” or 13 mm wrench,
tighten the two guide block locator bolts.
13. Replace the gauge pin guide into its place.
14. Place spring over the bottom
of the gauge pin guide. Insert
the cotter pin into the gauge pin
guide making sure the spring is
contained between the cotter pin
and the tool.
15. Bend cotter pin to ensure that
it stays in place.