Image Sensor 1/2.9” 720p Megapixel CMOS
Video Format NTSC
Effective Pixels H: 1280 V: 720
Horizontal Resolution 900 TVL
Scan System Progressive
Sync System Internal
S / N Ratio 50dB (AGC Off)
Iris AES
AES Shutter Speed 1/60 ~ 1/100,000 sec.
Min. Illumination 0.01 LUX (IR Off)
0 LUX (IR LEDs On)
Video Output Composite 1.0Vpp @ 75ohm
Lens Focal Length / Type 3.6mm F1.2 / Fixed
FOV (Diagonal) 90°
Termination BNC Type
IR Range / Qty. 90ft / 28m; 12 IR LED’s
Power Requirement 12V DC ± 10%
Power Consumption 200mA MAX with IR LED
Operating Temp. Range –22° ~ 140°F / –30° ~ 60°C
Environmental Rating IP66
Dimensions Diameter: 3.7” (94mm)
Height: 3.9” (98mm)
Weight (including stand) 0.7lbs / 0.3kg
Dimensions
Camera Specifications
94mm / 3.7”
98mm / 3.9”
To install the camera:
1. Use the included Allen key to loosen the screws on the
dome cover.
2. Rotate the camera base counterclockwise to separate
it from the ball camera and dome cover.
3. Feed the BNC / power cable through the camera
base. If you are running the cables against a wall
or ceiling, make sure to pass the cable through the
cable notch as shown above.
4. Connect the video and power cable as shown in the
section ‘Connecting the Camera’.
5. Mount the camera base to the mouting surface using
the included screws and drywall anchors (optional).
6. Position the dome cover over the camera and screw it
clockwise halfway onto the camera base
7. Move the ball camera to the desired position. While
holding the ball camera firmly in place, screw the
dome cover the rest of the way to secure it to the
camera base. Holding the camera prevents it from
moving while installing the dome cover.
8. Use the included Allen key to tighten the screws on
the dome cover.
Installing the Camera
ATTENTION - Test the camera prior to selecting a permanent
mounting location by temporarily connecting the camera(s) and
cables to the DVR.
Installation Diagram
Setting up the Camera
1. Connect the BNC connector of the camera
to the video cable.
2. DC Power—Power Adapter: Connect a
12V DC Power Adapter (not included) to
the camera. Plug the Power Adapter into a
local power outlet.
• DC Power—Power Pigtail (not included):
Connect a Power Pigtail to the camera.
Connect the terminating wires of the cable
directly to the DC power source.
NOTE: For pigtail connection with 12V DC, make sure to
check polarity specifications on the power adapter.
WARNING - A REGULATED UL / CSA APPROVED 12V DC power
supply is REQUIRED for use with this camera. Use of a non-regulated,
non-conforming power supply can damage this product and voids the
warranty.
ME313L_SERIES_TRIFOLDQSG_EN_R2.indd 2 2/23/2015 9:51:09 AM
