FONESTAR MSH-206, MSH-209 User manual

MSH-206, MSH-209
WIRELESS VHF HAND-HELD
MICROPHONE SYSTEMS
INSTRUCTION MANUAL
160928_MSH-206_MSH-209_MANUAL_(EN)_Maqu tación 1 28/9/16 11:00 Página 1

EN
- 2-
We take this opportunity to thank you for buying this product.
We recommend you read the instruction manual before switching on the machine and follow the instructions
that are given. Keep the manual for future reference.
SECURITY AND THE ENVIRON ENT
E ECTRICA SECURITY
Check that the current in the mains connection where the machine is to be installed corresponds to the
power supply of the machine.
To avoid damaging the equipment, electrical shocks, fire or physical injury when you connect or disconnect
the equipment from the power supply, pull the plug firmly out of the mains socket holding the plug, never the
cable.
Always do this with dry hands.
Keep the power supply cable far from sources of heat. Do not put heavy objects on top of it or change it.
Clean dust and dirt off the power supply cable regularly.
Do not open the machine; you could get an electric shock.
CAUTION
While installing the machine, make sure it is switched off and unplugged.
Do not open the machine. Touching the internal parts is dangerous and you could receive an electric shock.
The machine must not be splashed or dripped on. Never place recipients with liquid inside on the machine.
Do not place anything inside the machine.
OCATION
Place the equipment on a horizontal surface with enough space around it to allow ventilation.
Avoid direct sunlight, heat sources and excessive dust.
Do not place the machine near magnetic fields or static electricity.
Do not use surfaces which vibrate or receive impact.
Do not pile machines on top of one another.
VENTI ATION
Never block or cover the ventilation slits on the machine.
Do not expose it to direct sunlight or place it near sources of heat.
PERIODS OF INACTIVITY
When the machine is not going to be used for a long period of time, disconnect it from the mains.
If you are using an adapter, take into account that it will continue using electricity even if the machine is
switched off. If it is not going to be used for a long period of time, disconnect it from the mains.
THE ENVIRONMENT
To save energy, switch the machine off when you are not going to use it for a long time. The machine could
contain substances that are harmful to the environment or human health. To minimize the effect of these
substances the machine must be correctly managed and recycled when you decide to dispose of it.
When you dispose of it remember: it cannot be thrown into a conventional rubbish bin.
If it contains or uses batteries, these must be disposed of separately.
The machine (without batteries) must be disposed of correctly. Put it in a container specially intended for the
collection of electronic and electrical appliances, at the dump or hand it over to the dealer when you purchase
similar equipment, so that the dealer can dispose of it correctly (at no added cost).
160928_MSH-206_MSH-209_MANUAL_(EN)_Maqu tación 1 28/9/16 11:00 Página 2

EN
- 3-
SIGNIFICANCE OF THE SY BOLS ON THE ACHINE*
The symbol formed by the expression “Class 1 laser product” written in a rectangle
indicates that visible or invisible laser radiation could be produced. Avoid direct expose to
the laser.
The symbol formed by a ray of lightening inside a triangle shows that the machine has
connection terminals or a circuit with areas with a current which could cause an electric
shock, even in normal working conditions.
The symbol formed by an exclamation mark in a triangle shows that the instruction manual
must be referred to for information on how the machine works and its use.
The symbol formed by one square inside another square shows that the machine has
double electrical insulation.
The European Community symbol shows that the machine complies with the current
European Union legislation, as well as its transposition to local legislation.
The symbol of a rubbish bin crossed out and over a horizontal line shows that when the
product is disposed of it must be done properly, placing it in a special selective electronic
and electrical equipment container or through a dealer when purchasing a similar product,
at no additional cost. It also shows that the machine was put on the market after 13th
August 2005 (European Community Directive 2002/96/CE of Electrical and Electronic
recycling, and its Spanish equivalent R.D.208/2005).
In accordance with what is set out in the aforementioned decree, FONESTAR is registered
in the RAEE (Registro de Aparatos Eléctricos y Electrónicos) in a special section REI
(Registro de establecimientos Industriales), with the entry number 001851.
*It is possible that some of these symbols do not appear on the machine.
EXE PTION OF LIABILITY
The characteristics of the equipment and the content of the manual can change without forewarning.
FONESTAR, S.A. does not assume responsibilities regarding the inappropriate use of the equipment or the
information supplied in this instruction manual, and specifically disclaims any implied liability for marketability
or fitness for any other use.
All rights reserved by FONESTAR, S.A.
160928_MSH-206_MSH-209_MANUAL_(EN)_Maqu tación 1 28/9/16 11:00 Página 3

EN
-4-
DESCRIPTION
Wireless microphone system for audio signal transmission on the VHF band 174-194 MHz. Composed of a
double receiver and two wireless hand-held microphones or one tie-clip microphone with wireless belt-pack
transmitter and one wireless hand-held microphone depending on the model.
The system has 4 transmission channels on the VHF band 174-194 MHz, with fixed to quartz frequency
control and volume control.
CONTROLS AND FUNCTIONS
RECEIVER
FRONT PANEL
1.- Receiver on/off switch.
2.- VOL: controls to regulate each channel’s audio output volume.
3.- RF: ED radio frequency signal indicators per channel.
4.- AF: ED audio signal indicators per channel.
REAR CHANNEL
5.- IXED OUT: mixed unbalanced audio output, 6.3 mm jack connector.
6.- 12-18 V DC: power supply input. Use the mains adapter provided.
7.- Telescopic aerials.
160928_MSH-206_MSH-209_MANUAL_(EN)_Maqu tación 1 28/9/16 11:00 Página 4

EN
-5-
HAND-HELD ICROPHONE
1.- Battery compartment cover. Unscrew this cover to access the battery compartment. Use two batteries
type R-6AA, preferably alkaline. When inserting the batteries, make sure that the polarity is correct.
2.- Power switch. It has 3 positions, ON , STANDBY (central position) and OFF . Place it in the ON position
to operate. Place the switch in the central position (STANDBY) to save battery power and the
microphone will switch on immediately when moved to the ON position. Before switching the
microphone on or off, be sure to set the amplifier’s and receiver’s volume to their minimum to avoid
damage to the loudspeakers caused by excessive volume peaks.
BELT-PACK ICROPHONE
1.- Battery compartment. Use two batteries type R-6AA, preferably alkaline. When inserting the batteries,
make sure that the polarity is correct.
2.- GAIN ADJUST: audio input sensitivity adjustment.
3.- ED low battery indicator. When the switch is placed in the ON position or the central (STANDBY)
position, the red ED indicator will light up and then go out. When the batteries have only a little charge,
the ED indictor will remain permanently lit in red. Then replace the batteries with new ones.
4.- INPUT: microphone input, 3.5 mm jack connector.
5.- Power switch. It has 3 positions, ON , MUTE (central position) and OFF. Place it in the ON position to
operate. Place the switch in the central position (MUTE) to cut off the audio and the microphone will
switch on immediately when moved to the ON position. Before switching the microphone on or off, be
sure to set the amplifier’s and receiver’s volume to its minimum to avoid damage to the loudspeakers
caused by excessive volume peaks.
160928_MSH-206_MSH-209_MANUAL_(EN)_Maqu tación 1 28/9/16 11:00 Página 5

EN
-6-
INSTRUCTIONS FOR USE
1.- Connect the receiver to 12-18 V DC using the mains adapter supplied with the device.
2.- Place the extendable aerials in a vertical position and extend them fully for better reception.
3.- Connect the receiver’s unbalanced audio output MIXED OUT to the input of an amplifier, mixer, etc.,
using, if you wish, the 6.3 mm jack audio cable provided.
4.- Switch the receiver on using the switch located on the front panel. The ED indicator on the switch itself
will light up.
5.- Switch on the microphones. The ED RF will light up on the receiver.
6.- The ED AF indicators will flash in green if the microphone signal is correctly received when the
microphones are spoken through.
7.- Frequency: the frequency transmission is fixed and is shown on the lower part of the receiver and in the
microphone battery compartment.
Notes: The receiver and the transmitter microphones are adjusted to the same transmission frequency by
default. The transmission frequency cannot be changed by the user.
2 microphones with the same frequency cannot be used simultaneously. If 2 wireless systems are
used simultaneously make sure that all of them operate on different frequencies. Otherwise, there
will be interference problems among them.
160928_MSH-206_MSH-209_MANUAL_(EN)_Maqu tación 1 28/9/16 11:00 Página 6

TECHNICAL SPECIFICATIONS
SH-206 SH-209
CHARACTERISTICS Compact VHF receiver 174 to 194 MHz.
Fixed to quartz frequency control.
Volume control.
Unbalanced output.
2 wireless hand-held microphones
with high quality unidirectional
dynamic capsule.
Compact VHF receiver 174 to 194 MHz.
Fixed to quartz frequency control.
Volume control.
Unbalanced output.
1 hand-held microphone and 1 tie-clip
microphone with unidirectional
dynamic capsule and wireless belt-
pack transmitter.
RECEIVER/
ICROPHONE
Fixed frequency channel
4 channels available
RESPONSE 80-12,000 Hz
OUTPUTS 1 unbalanced line, 6.3 mm jack 10,000 Ω 150 mV
POWER SUPPLY Receiver: 12-18 V DC, 250 mA with adapter included
Transmitters: 2 R6-AA batteries
DI ENSIONS Receiver: 210 x 48 x 140 mm depth
ACCESSORIES 6.3 mm mono jack cable
Batteries
EN
-7-
160928_MSH-206_MSH-209_MANUAL_(EN)_Maqu tación 1 28/9/16 11:00 Página 7

DECLARATION OF CONFOR ITY
FONESTAR declares, under its responsibility that the wireless microphone models
SH-206 and SH-209 comply with that shown in the European Parliament and Council directive
1999/5/EC of 9th March1999, transposed to Spanish legislation through the Real Decreto 1890/2000, on
20th November.
This is class 1 equipment and has no use restrictions
List of standards applied
Standard Area Compliance with the 1999/5/CE
essential directive requirements
EN 60950-1:2006+A11:2009+A1:2010+A12:2011+A2:2013 E ECTRICA SAFETY Section 3.1a 1999/5/CE directive
EN 62479:2010
EN 301 489-1 V1.9.2:2011 EMC Section 3.1b 1999/5/CE directive
EN 301 489-9 V1.4.1:2007
EN 300 422-1 V1.4.2 (2011-08) RADIO Section 3.2 1999/5/CE directive
EN 300 422-2 V1.3.1 (2011-08)
Santander, 24th May 2016
Juan Vallejo
Technical Engineer, Sales Department
WARRANTY
This product has been tested and has passed the corresponding quality control prior to being put on the market.
FONESTAR guarantees the suitability of the product for its specified use during a period of 2 years from the
delivery date and commits itself to repair or substitute the goods as expressed in the Spanish law ‘ a ey General
para la Defensa de los Consumidores y Usuarios, Real Decreto egislativo 1/2007 16 Noviembre.
The lack of conformity in the first six months after purchase, due to a manufacturing defect, will be rectified with
no more than showing the proof of purchase. After six months FONESTAR reserves the right to demand proof
of the product being sold with that problem.
This warranty does not include damage produced by: inappropriate use or negligence, accidents, worn out parts
due to use, breakages, burns, spilt liquids or other substances, excessive humidity, battery deterioration and
internal manipulation of the device, the software or its components by unauthorized persons, and in general any
use that is unrelated to the nature and purpose of the product.
If any service is needed during the warranty period because of lack of conformity, please contact the business
or distributor where the product was purchased in no more than 2 months after being conscious of the problem.
It is only necessary to contact FONESTAR if it is impossible or imposes an undue burden for them to solve it.
To benefit from this warranty it is necessary to show the proof of purchase with the date clearly visible, with no
corrections or crossing out.
This document adds information, and never decreases the consumers’ rights, which in all cases are protected
by the Spanish law ‘ a ey General para la Defensa de los Consumidores y Usuarios, Real Decreto egislativo
1/2007 16 Noviembre’.
FONESTAR is a member of ECOEMBA AJES ESPAÑA, S.A. “ECOEMBES”, with number 03497 and all our products
carry the symbol, backed by our membership and subscription to the above mentioned organization with the recycling
and subsequent management of our packaging.
FONESTAR, S.A. - NIF: A28780443 - Poligono Trascueto - 39600 - Revilla de Camargo, Cantabria (SPAIN)
www.fonestar.com
160928_MSH-206_MSH-209_MANUAL_(EN)_Maqu tación 1 28/9/16 11:00 Página 8