for Living 088-1610-4 User manual

Lakeside Gazebo
Product No. 088-1610-4
Toll-free: 1-877-483-6759
IMPORTANT: Please read this manual carefully before beginning assembly of this product.
Keep this manual for future reference.
Assembly Instructions

3
Caution! Always keep children under close supervision while they are playing around this product.
Never leave children unattended. Keep pets away while setting up the gazebo.
Caution! Check municipal by-laws prior to setting up the gazebo.
Table of ContentsImportant Safety Instructions
Table of Contents 3 Important Safety Instructions 3 Parts List 4 Assembly 5 Cleaning and Maintenance 12 Technical Specifications 12 Warranty 13
Warning! To reduce the riskof serious injury, read the following safety instructions before
assembling andusing the gazebo.
 This product is intended for domestic outdoor use only.  Always place and assemble the gazebo on flat horizontal ground.  Consult with your local governing authority/local municipal codes regarding installation of temporary structures
before assembly.
 Ensure there is enough clearance around the product. Before assembling the gazebo, make sure to leave
a distance of not less than 1.8 m (6') from any structures or obstructions, such as fences, garages, houses,
overhanging branches, laundry lines, or electrical wires.
 Anchor the gazebo to the ground with stakes for added safety. Stakes are provided to secure the gazebo to
the ground. If you wish to secure the gazebo to a concrete and wood surfaces, use anchors suited for these
surfaces (anchors not included). Do not assemble the gazebo on sandy, muddy or loose soil, as stakes are not
 If more than one gazebo is setup, keep a minimum distance of 3 m (10') between the gazebos.
 Any assembly or maintenance of the gazebo must be carried out by adults only.
 Make sure there is sufficient manpower when assembling or moving the gazebo.  Some parts may contain sharp edges. Wear protective gloves if necessary.  Check all nuts and bolts periodically for tightness. If required, tighten them.
 Repairing and replacing parts should be done by a qualified technician.  This gazebo is intended for decorative and sunshade purposes only, and is not designed to withstand harsh
weather, including high winds, rain, and snow.
 Always disassemble the gazebo in heavy wind conditions. If not, it might tip over and could cause injury to
bystanders.
 Always ensure that the canvas is taut, to avoid water accumulation on the roof. If water accumulates on the roof,
remove it immediately or disassemble the gazebo in order to avoid damages.
 Do not light any fires inside or near the gazebo.
 Do not panic if fire breaks out inside the gazebo. Search for the nearest exit. Do not return to the gazebo until the
firemen allow you to do so.
 Do not hang any weights on the roof frame.  Do not climb onto the roof of the gazebo. Doing so may cause the gazebo to fall down, thereby resulting in
serious injury.
 Retain the original packaging to store the gazebo.  If the gazebo will not be used for a long period of time (e.g. during winter time), disassemble and store it in a
clean, dry environment.
IMPORTANT: RETAIN FOR FUTURE REFERENCE, AND READ CAREFULLY
Imported by Trileaf Distribution Trifeuil Toronto, Canada M4S 2B8
Made in China
strong enough to anchor in these types of soil.
Anchor the gazebo to the ground with stakes for added safety. Stakes are provided to secure the gazebo to
gg yp g
the ground. If you wish to secure the gazebo to a concrete and wood surfaces, use anchors suited for these
gy
surfaces (anchors not included).

4 5
Product No. 088-1610-4
IMPORTANT: Please read and understand this manual before any assembly. Before beginning assembly of product,
make sure all parts are present. Compare parts with packaging contents list. If any part is missing, or if you have
any questions, contact the service centre at 1-877-483-6759 (toll-free).
Take all parts from the packaging box and position them on a clean floor. Remove all packing materials and place
them back into the box. Do not dispose of the packing materials until assembly is complete. Read each step
carefully before beginning any assembly and make sure you understand each step. If any part is missing, please
call our toll-free number for assistance: 1-877-483-6759.
Parts List
Assembly
Caution!
 Proper placement of your gazebo is essential. Do not place the gazebo underneath
electrical lines.
 Keep children away during the assembly procedures of the product. This product
contains small parts which can be swallowed by children.
 Keep fingers away from places where they can be pinched or trapped.  Do not attempt to assemble the gazebo if any part is missing.
Let us help you! DO NOT RETURN YOUR PRODUCT TO THE STORE. CALL US FIRST! 1-877-483-6759 If you have questions regarding your product, require warranty assistance, or have damaged or missing parts, please call our customer service toll-free helpline.
Contact us for assistance; we’re here to help.
Needed for assembly:
Hammer Ladder 4 people
Screen - 4 Bolt - 16 + 1 spare
Horizontal beam - 4 I6*180 Stake - 16
Shelf - 4
Middle bar connector - 4
Slanting bar connector - 4
Upper slanting bar - 4 Lower slanting bar - 4
Middle bar - 4
Connector - 1
Slanting bar connector base- 4
Hook- 1
Canopy - 1
A1 J1 B1 BB
C
D
E
F
G H
I
J
K
L
+ 1 spare

6 7
Product No. 088-1610-4
Assembly
Assembly
Note: When using screws and nuts to assemble the product, always use a flat washer (not included) between the frames and the screw and/or nut. This will protect the parts from wear and tear.
Step 1 Requires A1, B1, J1
Step 2 Requires A1, C
Insert the horizontalbeam(B1) into the groove ofthe screen(A1) and secure the horizontalbeamwitha bolt (J1).
J1
A1
B1
CA1
Step 3 Requires A1, J
A1
J
Step 4 Requires B1, D, J1
D
B1
J1
Place the shelf (C) onthe rimofthe screen(A1).
Insert the slanting barconnectorbase (J) into the respective slots onthe topofeachscreen(A1).
Insert the middle topbarconnector(D) into the horizontalbeam(B1) and secure the middle topbarconnectorusing
a bolt (J1).
J1
J1

8 9
Product No. 088-1610-4
Assembly
Assembly
Step 5 Requires E, J, J1
Step 6 Requires F, G
Insert the slanting barconnector(E) into the slanting barconnectorbase (J) and secure the slanting bar
connectorusing a bolt (J1).
J1
E
J
F
G
J1
Connect the upperslanting bar(F) to the lowerslanting bar(G).
Step 7 Requires E, G
Insert one end ofthe lowerslanting bar(G) into the slanting barconnector(E).
E
G
Step 8 Requires F, I, K
Insert the otherend ofthe upperslanting bar(F) into the connector(I).Screwthe hook (K) into the connector.
F
K
I

10 11
Product No. 088-1610-4
L
G
Assembly
Assembly
Step 9 Requires D, H
D
H
Step 10 Requires H, I
H
I
Step 11 Requires L, G
Ifthe gazebo is being used onsoilorgrass, secure the gazebo into the ground using the stakes (BB).Repeat
this stepforevery post untilall four posts are anchored.
Insert one end ofthe middle bar(H) into the middle barconnector(D).
Insert the opposite end ofthe middle bar(H) into the connector(I) and tightenall the bolts.
Step 12 Requires BB
BB
• Place the canopy (L) ontopofthe frame and attachthe cornerofthe canopy to the end oflowerslanting
bar(G). • Attachthe sides ofthe canopy to the end ofmiddle bar.
BB

12 13
Product No. 088-1610-4
This ForLiving™product carries a one (1) yearwarrantyagainst defects inworkmanshipand materials.
TrileafDistributionagrees to replace the defective product free ofcharge withinthe stated warrantyperiod,
whenreturned bythe originalpurchaserwithproofofpurchase.This product is not guaranteed against wear
orbreakage due to misuse and/orabuse.
• To wash the fabric parts:
- Spread the fabric and use a soft bristle brush to clean.
- Neveruse detergent. - Watershould be cold to lukewarm, not more than25ºC (77ºF).
- Airdry only. Do not spininwashing machine orhand squeeze.
• Do not use bleach, acid, or other abrasive cleaners on the canopies or frame parts. • Steel components of garden accessories and furniture are coated with rust-inhibiting paint. However, due to
the nature of steel, surface oxidation (rusting) will occur if this protective coating is scratched. This is a natural process. To minimize this condition, it is recommended that care be taken when assembling and handling the product, in order to prevent the paint from being scratched. Surface rust can be removed easily by applying little common cooking oil. If surface oxidation (rusting) occurs and no measures are taken to correct it, the oxidation may start dripping onto the assembly surface, which may cause stains that could be difficult to remove.
Caution!
• Check all screws and nuts periodically for tightness, and tighten them if required. • Disassemble the gazebo in the reverse order of the assembly steps. Always disassemble
the gazebo completely. A partially disassembled gazebo is not stable enough to resist wind and bad weather, and therefore can be damaged and/or cause damage.
Cleaning and MaintenanceTechnical Specifications
Warranty
Dimensions (L x W x H) 3 x 3 x 2.7 m
10' x 10' x 8' 8"
Product weight 36 kg
79 lb