Forever Redwood CHERRY HILL OUTDOOR PERGOLA User manual

ASSEMBLY INSTRUCTIONS FOR
CHERRY HILL OUTDOOR PERGOLA
866.332.2403 (TOLL FREE); 7am –7pm Pacific Time, Monday-Saturday

P| 1
CHERRY HILL OUTDOOR PERGOLA
www.ForeverRedwood.com
CONTENT OF BOXES
No.
1
2
3
4
5
6
7
8
9
10
Drawing
Hurricane
Gale Wind
Standard
Description
Posts
Long Single Supports
Long Supports with
In-Between Blocking
Short Single Supports
Short Supports with
In-Between Blocking
Knee Braces
Long Rafters
Short Rafters
Boots
If ordered
Standard, Gale Wind or
Hurricane Anchor Bases
If ordered
Qty.
Will
Vary
Note: Part numbers in the Content of Boxes Table are for reference only. These do not match to the numbers marked on the parts sent.

P| 2
CHERRY HILL OUTDOOR PERGOLA
www.ForeverRedwood.com
HARDWARE LIST
No.
A
B
C
D
E
Drawing
Description
½” x 4”Anchor Bolts
(To attach the anchor bases to the ground).
3/8”x 3”Lag Bolts
(To attach the anchor bases to the posts).
3/8”x 7 ½” Bolts
(To attach the supports to the posts. / To
attach the supports together. / To attach the
knee braces the supports).
3/8”x 10” Bolts
(To attach the knee braces to the posts).
3”Deck Screws
(To attach the rafters to the supports. / To
attach the rafters together. / To attach the bots
to the posts).

P| 3
CHERRY HILL OUTDOOR PERGOLA
www.ForeverRedwood.com
No
1
2
3
4
5
6
7
8
9
10
DESCRIPTION
Posts
Long Single Supports
Long Supports with
In-Between Blocking
Short Single Supports
Short Supports with
In-Between Blocking
Knee Braces
Long Rafters
Short Rafters
Boots
Anchor Bases
Note: Part numbers in the
Drawing are for reference only.
These do not match to the numbers
marked on the parts sent.

P| 4
CHERRY HILL OUTDOOR PERGOLA
www.ForeverRedwood.com
NOTE: In order to know where the post needs to be placed, check the numbers on them. If the post is not marked, then place
the single Supports on the ground to locate the markings for each post position and clearly set your bearings. (“Don´t attach yet,
only place them on the ground to begin with”).
Step 1: Install the anchor bases (100) to the ground with ½´´ x 4´´ Anchor bolts (A). Please see the “How to anchor your pergola
document” for all details. Set your post (1) in the saddle of the anchor bases. Drill a ø 7/16´´ hole in the post prior to anchoring
to facilitate the ratcheting of the hardware. After that, use a 3/8´´ X 3´´ lag bolts (B) to attach each post to its respective anchor
base.
l
Step 2: Attach the long single supports (2) to the posts with 3/8´´ X 7 ½´´ bolts (C). Each part has a series ofnumbers that indicate
where to attach the part with the corresponding number.
3/8´´ X 3´´ Lag Bolts
1
1
1
2
3/8´´ x 7 ½´´ Bolts
1
10
2

P| 5
CHERRY HILL OUTDOOR PERGOLA
www.ForeverRedwood.com
Step 3: Put up the long supports with in-between blocking (3), into the post notches as shown and attach to the posts with the
single support bolts. Each part has a series of numbers that indicate where to attach the part with the corresponding number.
Step 4: Attach the long single supports to the long supports with in-between blocking, use 3/8´´ X 7 ½´´ bolts (C).
3/8´´ X 7 ½´´ Bolts
3
3

P| 6
CHERRY HILL OUTDOOR PERGOLA
www.ForeverRedwood.com
Step 5: To attach the short supports (4,5) repeat the steps 2 to 4 above. Make sure that the supports fit correctly. Each part has a
series of numbers that indicate where to attach the part with the corresponding number.
Step 6: Attach the knee braces (6) to the supports with 3/8´´x 7 ½´´ bolts (C), and to the posts with 3/8´´ x 10´´ bolts (D). Each
part has a series of numbers that indicate where to attach the part with the corresponding number.
5
4
6
6
6
6
3/8” x 7 ½” Bolts
3/8” x 10” Bolts

P| 7
CHERRY HILL OUTDOOR PERGOLA
www.ForeverRedwood.com
Step 6: Use 3´´ deck screws (E) to attach the long rafters (7)to the short supports. Each part has a series of numbers that indicate
where to attach the part with the corresponding number.
Step 7: Attach the short rafters (8) to the long supportsand to the long rafters with 3´´ deck screws (E) . Make sure that the rafters
fit correctly. Each part has a series of numbers that indicate where to attach the part with the corresponding number
3´´ Deck Screws
7
8
3´´ Deck Screws
3´´ Deck Screws

P| 8
CHERRY HILL OUTDOOR PERGOLA
www.ForeverRedwood.com
Step 8: Finally, use 3’’ deck screws (E) to attach the boots (9) to the posts. Each part has a series of numbers that indicate
where to attach the part with the corresponding number.
This completes the Pavilion assembly. Hope you enjoy your set for many decades. If you ever have a problem or a question,
don't hesitate to call us (866 332 2403) or email us. We are here to support you.
3’’ Deck Screws
9