7
©2021 FOXTECH All Rights Reserved
Thor 210 Hybrid Hexacopter User Manual
no dislocation.
Check whether the exhaust funnel is loose. In case of shaking, be sure
to tighten the fixing bolts of the exhaust funnel.
Precautions for starting engine
Before starting the engine for the first time, the air in the oil inlet pipe
needs to be discharged to make the oil inlet pipe full of oil and free of
bubbles；
For the first using, the generator should be power on before adding
coolant. After power on, the electrical water pump will continue to run for
about 100s. If the water jacket is not full within 100s, the generator shall be
re-powered on. Repeat until the air in the pipe line is drained. The pipe lines
can be squeezed properly until there is no obvious bubble up welling in the
water jacket; Generally, this operation is not needed during subsequent
startup, just observe the liquid level of water jacket, and add coolant when it
is too low.
After each power on, the steering gear will execute the self-learning
program for about 8s. Operate the remote control to make the system
indicator light normally on (the remote control needs to be unlocked).
The engine must be idle for 30 seconds after starting, so that the
crankshaft, piston and connecting rod can be more fully lubricated.
Multiple start failures may cause the spark plug to be flooded. In this
case, replace or dry the spark plug and try to start again.
Launch and stop
1. Move the yaw stick to far right and minimum the throttle
2. Switch the SA Lever up and down to unlock the generator.
3. After 5s, switch to the middle to start the generator.
4. Push the stick up to trun off the generator
5. After continuous flight, Halo-6000 needs to be cooled. Therefore, after
