Franke SD6000 User manual

KITCHEN
SYSTEMS
INSTALLATION GUIDE
Soap Dispenser - SD6000, SD7000
Rev 1 - 12/11/2015
MAKE IT WONDERFUL

INSTALLATION INSTRUCTIONS
Remove all contents from the package and check for completeness.
1
NOTE:
Call immediately if you see inconsistencies.
(1-800-626-5771)
or visit
www.frankeksd.com
Package Contents:
1 - Dispensing Head
(Pre assembled with pump)
2 - Fill Tube
3 - Mounting Shank Assembly
4 - Base Flange with Washer
5 - Mounting Nut
6 - Bottle
Installation Tools:
None
1
6
1
2
3
4
5

2
Installation
Ensure proper hole is in place for the
Dispenser. This Dispenser is designed
to mount into a 1-3/8” (35mm)
mounting hole.
3Product will arrive with dispensing
head already mounted in base flange.
Remove the dispensing head
assembly from the base flange
assembly. Insert the fill tube into the
pump at the bottom of the dispensing
head assembly and set this aside.
4Unscrew the mounting nut from the
base flange assembly. Insert the
base flange into the mounting hole.
Be sure the mounting washer is in
place between the flange and
mounting surface.
2
5From underneath the mounting
surface, install the mounting nut
onto the base flange firmly by hand
and install the bottle into the base
flange hand tight.
Dispensing
head
Pump
Fill tube
6Fill bottle with soap or lotion.
Note: For Most efficient use
with soaps, it is recommended
to fill the bottle 1/3 with water
and 2/3 with soap and mix well
using the fill tube to minimize
clogging.
Soap or lotion
Mounting
nut
Bottle

7
Installation
Insert the dispensing head assembly
with assembled fill tube into the base
flange and bottle and point the
discharge of the dispensing head
towards the front of the sink, or to
the desired location.
3
8Pump dispensing head several times
until soap/lotion is discharged
through the head.

1
Usage
With the bottle full, press the
Dispensing Head to discharge soap/
lotion. Remove pressure from the
Dispensing Head, and it will return
to the original position, and it can be
pumped again.
2Continue pumping until desired
amount of soap/lotion is discharged.
4

MAINTENANCE
5
1With normal use, maintenance should not be necessary. Should there
be an extended period where the dispenser is not used, it is possible the
soap/lotion could harden and prevent proper discharge. In this event,
submerge the entire Dispensing Head with Pump into hot water for
several minutes. Next pump hot water through the assembly. Repeat as
necessary to remove the obstruction.
2To clean the dispenser, use a soft cloth or sponge with soap and water
only. Do not use any abrasive cleaners or pads. Dry with a cloth or paper
towel.
2
1
Replacement Parts
3
1 - SD2401 Pump
2 - SD2402 Bottle
3 - SD2403 Fill Tube
3

PRODUCT WARRANTY
Congratulations on the purchase of this Franke product! Franke is one of
the world’s largest manufacturers of kitchen systems. Our products are
manufactured using the highest degree of technology, quality, and design.
As a result, we are proud to offer the following warranty.
Franke warrants the quality of its soap/lotion dispensers to be free from
manufacturing defects for a period of five years from the date of purchase.
This warranty applies only to the original owner, providing the product has
been installed in accordance with these installation instructions, used as
recommended, and in normal residential application. In the event of a
warranty claim, the owner will be required to provide proof of purchase
- SAVE ORIGINAL SALES RECEIPT! This warranty covers all components
which make the product operational. Franke reserves the right to inspect
the installation prior to the replacement of the product or component part.
This warranty does not cover misuse or abuse, accidental damage, scuffs, or
scratches, abnormal usage, negligence or damage caused by improper main-
tenance or cleaning. Normal wear of parts is excluded from the warranty.
Damage caused by impurities or acts beyond Franke’s control are not cov-
ered. Any product or part which has been repaired or altered in any man-
ner outside of Franke’s factory, unless previously authorized in writing by
Franke, will void the warranty. Any replacement excludes transportation
and any labor reinstallation costs. This warranty doesn’t allow recovery
of incidental or consequential damages such as loss of use, delay, property
damage, or other consequential damage, and Franke accepts no liability for
such damages.
The Franke warranty is limited to the above conditions and to the war-
ranty period specified herein and is exclusive. Franke DISCLAIMS all other
warranties, expressed or implied, including the IMPLIED WARRANTIES OF
MERCHANTABILITY AND/OR FITNESS FOR A PARTICULAR PURPOSE. This
warranty gives you specific legal rights which may vary from state to state.
Further Information
For any further information about Franke products, about the installation of
them, or about the guarantee, please contact our Customer Service Depart-
ment:
Franke Consumer Products Inc.,
Kitchen Systems Division
800 Aviation Parkway
Smyrna, TN 37167
Phone: [phone]
Fax: [phone]
www.frankeksd.com
6

Franke Consumer Products Inc.,
Kitchen Systems Division
800 Aviation Parkway
Smyrna, TN 37167
Phone: [phone]
Fax: [phone]
www.frankeksd.com