Franklin Electric SubDrive15 Connect N3R User manual

SubDrive/MonoDrive Connect
SubDrive15, SubDrive20, SubDrive30, MonoDrive, MonoDriveXT
Fan Replacement Install Guide

If the fan does not perform as stated above, note the error and consult your local Franklin Electric representative or call the Franklin
Electric Technical Service Hotline at 1-800-348-2420.
Fan Test
1. The fan can be unplugged from the drive and tested with a 9 V
battery to show functionality.
- Connect the red (+) lead from the battery to the red fan
connector, and the black (-) lead from the battery to the black
fan connector.
- Connect the battery clip to the 9 V battery. The fan should spin
freely and quietly.
2. Test that the fan power supply works properly.
- Cycle power to the drive.
- Verify that the fan runs for 3–5 seconds during the
power-up initialization.
SUBDRIVE/MONODRIVE CONNECT
FAN REPLACEMENT INSTALL GUIDE
s WARNING
!
Serious or fatal electrical shock may result from contact with the internal electrical components. DO NOT, under any
circumstances, ATTEMPT TO CHANGE THE FAN until the power has been removed from the drive, capacitors are discharged, and
five minutes have passed for internal voltages to discharge! Before replacing the fan, make sure the fan is not working properly
by performing the simple test below:

STEP 1:
Verify the fan replacement kit.
STEP 2:
Remove the rivets from the bottom of the enclosure.
SubDrive/MonoDrive Size Fan Kit No. Fan Cover
SubDrive15 and MonoDrive 80 mm (3.15”) 226545904 Integrated
SubDrive20/30 and MonoDriveXT 80 mm (3.15”) 226545905 Integrated
Integrated Enclosure Fan Cover
SUBDRIVE/MONODRIVE CONNECT
FAN REPLACEMENT INSTALL GUIDE
s WARNING
!
REMOVE ALL INCOMING ELECTRICAL POWER TO THE DRIVE. THIS IS A NON-POWERED ELECTRIC PROCEDURE.

STEP 3:
Disconnect the power connection from the main board.
STEP 4:
Remove the fan from the enclosure.
STEP 5:
Locate the airflow indication arrow on the side of the fan. Position the fan so that the air is directed into the enclosure.
MonoDrive and SubDrive15 MonoDriveXT and SubDrive20/30
SUBDRIVE/MONODRIVE CONNECT
FAN REPLACEMENT INSTALL GUIDE

STEP 6:
Install the replacement fan into the enclosure.
STEP 7:
While holding the fan in place with one hand, secure it to the enclosure using the supplied plastic rivets. To install the rivet, first insert the
outer plug and then insert the plunger to secure.
SUBDRIVE/MONODRIVE CONNECT
FAN REPLACEMENT INSTALL GUIDE

STEP 8:
Reconnect power connection.
STEP 9:
Fan installation is complete. Verify that fan turns on and is working properly.
If you experience any diculty in performing these steps, consult your local Franklin Electric representative or call the Franklin Electric
Technical Service Hotline at 1-800-348-2420.
SUBDRIVE/MONODRIVE CONNECT
FAN REPLACEMENT INSTALL GUIDE

9255 Coverdale Rd., Fort Wayne, Indiana 46809
Tel: [phone] • Fax: [phone]
franklinwater.com
TOLL-FREE HELP FROM A FRIEND
Franklin Electric
Technical Service Hotline
800-348-2420
226546102
Rev. 0
05-16