Furniture of America CM3319L-SC-2PK User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
Allen Wrench (Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-05-08Page 1 of 5
DIFFICULT
ASSEMBLY RATING
CM3319L-SC-2PK

Page 2 of 5

Parts List Hardware List
#1 x 1 pc x 2
Backrest w/Legs
#2 x 1 pc x 2
Seat
#3 x 2 pcs x 2
Front Leg
#A x 4 pcs x 2
Bolt 5/16”x3”
#B x 4 pcs x 2
Bolt 5/16”x2-3/4”
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
#C x 1 pc x 2
Bolt 5/16”x1-3/8”
MD
#D x 9 pcs x 2
Lock Washer
Page 3 of 5
#E x 9 pcs x 2
Flat Washer
#F x 1 pc
Allen Wrench
Note: The above parts and hardware are shown for a
complete assembly of ONE chair. However, the actual
parts and hardware (with an exception of the Allen wrench)
in the box will be twice the quantities listed to include the
assembly of the second chair.
X 2

Turn right (clockwise) to tighten
Turn right (clockwise) to tighten
Page 4 of 5
#A x 4 pcs
#D x 4 pcs
#E x 4 pcs
#C x 1 pc
#D x 1 pc
#E x 1 pc
I. Align the seat (#2) with the
pre-drilled holes of the
backrest with legs (#1).
II. Prepare 4 bolt assemblies by
inserting FIRST the lock
washer (#D) onto the bolt (#A)
and then the flat washer (#E)
onto the SAME bolt (#A), in
that order.
III. Insert the bolt assemblies
through the pre-drilled holes in
the corners of the seat (#2)
and secure those bolts using
the Allen wrench (#F) to lock
them in with the backrest with
legs (#1).
I. Prepare a bolt assembly by inserting FIRST the lock washer (#D)
onto the bolt (#C) and then the flat washer (#E) onto the SAME
bolt (#C), in that order.
II. Insert the bolt assemblies through the center hole of the seat (#2)
and secure that bolt using the Allen wrench (#F) to lock it in with
the backrest with legs (#1).

Turn right (clockwise) to tighten
Page 5 of 5
#B x 4 pcs
#D x 4 pcs
#E x 4 pcs
I. Align the front legs (#3) with
the pre-drilled holes on the
corners of the seat (#2).
II. Prepare 4 bolt assemblies by
inserting FIRST the lock
washer (#D) onto the bolt
(#B) and then the flat washer
(#E) onto the SAME bolt
(#B), in that order.
III. Insert the bolt assemblies
through the pre-drilled holes
in the corners of the seat (#2)
and secure those bolts using
the Allen wrench (#F) to lock
them in with the front legs
(#3).
Carefully turn the completed chair upright. Make sure the chair
is rested on a flat surface and it does not feel loose or wobbly.
If it does, double check that the bolts are secured and properly
tighten.
ASSEMBLE EVERYTHING EXACTLY THE SAME FOR THE SECOND CHAIR.