Furuno TZT2BB User manual

Accessing the Secondary
Display on a Single Monitor
TZT2BB Installation

Accessing and Operating the Secondary
Display Output on a Single Monitor
TZT2BB Installation
Take full advantage of both video outputs when using only a single monitor TZT2BB installation.
Examples ofwhy this installation may be useful:
1. Assist with performing software updates when having only one display connected
2. Use of two different radars or sounders onone monitor
3. Allows for “Quarter” page weather
4. Up tofive panels of data possible (fit more information onscreen)
5. Look at two composite video signals atonce (normally only one composite allowed per display)
Example of dual range with one radar and single range of second radar on same display

Example of secondary video (as three-way screen) displaying in quarter selection of primary display
Items need for this install configuration:
1. USB A toMicro B cable
2. HDMI cable
Very short cables are best suited for this purpose to reduce signal loss and prevent induction of
noise.

Installation instructions:
Simple! Connect the secondary display in the same manner that you would an external touch device.
1. Connect HDMI Out 2 to the HDMI Input
2. Connect USB Touch Control for HDMI 2 into USB 2
a. USB 2 has the Micro B connection
Setup:
Once the TZT2BB is booted, setup your HDMI input.
1. Touch the Home icon
2. Touch the Settings icon
3. Scroll down and select Camera
4. HDMI is the top section here
a. Turn “On” HDMI Input and acknowledge the warning
b.
c. Turn “On” Touch Output and acknowledge the notification

d. HDCP is for use with devices requiring copyright protection. This has no purpose in this
configuration, so leave that setting off.
5. Setup a page with full or quarter screen video
6. Select “HDMI” as the video source
Operation notes:
It can be tricky in full screen video mode to remember which display output of the TZT2BB you are
operating. Consider the following tips and tricks.
1. If you see the 3-bar icon to the top right, you are on the video page (secondary TZT2BB display)
2. On full page video, forthe first nine seconds, the home key that is displayed at the top left isthe
primary home key. After nine seconds you will see the secondary home key.
a. Other than the time, there is a subtle difference shown on the left edge that can be seen
with an astute eye. The primary display home key will goall the way to the monitor
edge, while the secondary will have a slight inset/border.

Example of Secondary Home Key
3. To gain access tothe primary home key, press the 3-bar icon, then tap outside of the pop-upbox
to make it go away, and then touch the “Home” icon within the nine second time-period.
Example of Primary Home Key

NOTE: In some menus the 3-bar icon may make touching the X in the top right difficult. This can
be fixed by pressing and holding the 3-bar icon until gold arrows appear on it. You can then drag
the icon and place it where ever you find to be convenient or appealing.
REVISION 4/18/19