FWE COLD-TEMP URS-10 User manual

REFRIGERATED "COLD-TEMP" SERIES
OPERATING
INSTRUCTIONS
"PTST-HR"
"UHRS"
"URS" SERIES MODELS
Caution: Read the
instructions before
using the machine.

2FWE Operating Instructions | Refrigerated "Cold-Temp" Series
FWE REFRIGERATED "COLD-TEMP" SERIES
CONGRATULATIONS...
...and thank you for purchasing a FWE Refrigerated Transport Cabinet.
Your unit has been designed and manufactured as a heavy duty cabinet
intended for use in transporting cold food from a centralized kitchen to satellite
locations.
Please take a moment to read through this booklet of important information
pertaining to your cabinet. By following a routine of proper use and care
described on the following pages, your cabinet will last for many years.
IMPORTANT: Your Manufacturer Registration Card must be returned
within 30 days after initial delivery to activate the warranty.
URS-10
Model Shown URS-7
Model Shown
UHRS-7-7
Model Shown

WARNINGS & INFORMATION
3
FWE REFRIGERATED "COLD-TEMP" SERIES
IN THE EVENT OF ACCIDENT OR
BREAKDOWN - UNPLUG UNIT.
FOR SERVICE INQUIRIES PLEASE CALL
FWE SERVICE • 800-222-4393
1. DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR
REMOVE THE GROUNDING PRONG FROM THE CORD PLUG.
2. ONLY A QUALIFIED ELECTRICIAN OR SERVICE TECHNICIAN
SHOULD ATTEMPT TO REPAIR OR
REPLACE ELECTRICAL COMPONENTS OR WIRING.
3. To Avoid Electric Shock Disconnect power before
servicing, moving or cleaning unit.
4. Improper use of this machine can result in injury
and/or death.
A schedule should be put in place for inspections and preventative
maintenance.
New users should be properly trained in the use of this equipment.
No special protective equipment is required to operate this unit.
WARNINGS
INFORMATION

INSTALLATION
4FWE Operating Instructions | Refrigerated "Cold-Temp" Series
FWE REFRIGERATED "COLD-TEMP" SERIES
FWE "Cold-Temp" models operate on 120 VAC, 60 Hz, 1 ph, and
are equipped with a grounded NEMA Plug for your protection against
possible shock hazards. Be sure to plug only into a properly grounded
three prong wall receptacle. If you have any questions with regard to
adequate wiring or grounding in your building, a qualified electrician
should be contacted before using your cabinet. The electrical specs of
your cabinet are printed on the serial tag attached to the unit.
• Minimum 6" clearance around cabinet
• Unit should be installed on a level surface
• Unit should not be installed in an area where adverse
environmental conditions are present
ELECTRICAL REQUIREMENTS AND GROUNDING
ADDITIONAL INSTALLATION REQUIREMENTS

FWE REFRIGERATED "COLD-TEMP" SERIES
5
1. PLUG CABINET INTO A PROPERLY GROUNDED POWER
RECEPTACLE.
2. CONDENSER CLEARANCE. Keep a minimum of 6"clearance all
around unit to allow condenser to vent warm air.
3. SELECT A TEMPERATURE SETTING.
PRE-SET at 38°F (3.3°C) for REFRIGERATOR:
Temperature Range: 33°F to 40°F (1°C to 4.4°C)
Press ▲ to raise the temperature of the cabinet and scroll to desired
temperature. Press ▼ to lower the temperature of the cabinet and
scroll to desired temperature.
4. PRE-CONDITION CABINET FOR 30-60 MINUTES.
Your cabinet should be pre-cooled 30-60 minutes before loading at your
desired set temperature.
AVOID PUTTING HOT FOODS INTO A COLD CABINET!
PREPARING THE CABINET BEFORE LOADING FOOD
1. LOAD THE CABINET. During the loading procedure, keep the doors
closed as much as possible. After loading is completed, do not open
doors again until you are ready to serve.
2. TRANSPORTING COLD FOODS - Your cabinet is equipped with a
paddle latch to assure safety during transportation. After loading the
cabinet, keep it plugged in with the door closed and wait 15-20 minutes
before moving it. Transport cabinet to the serving area, and plug into an
electrical outlet (if available), so that the compressor will turn on and
automatically hold at the pre-selected temperature.
3. OPERATION: See 'Quick Start Guide & Information' on Page 6 and 7 for
operation instructions.
GENERAL OPERATING INSTRUCTIONS
LOAD COLD FOOD INTO COOLED CABINET

FWE REFRIGERATED "COLD-TEMP" SERIES
6FWE Operating Instructions | Refrigerated "Cold-Temp" Series
POWER ON/OFF - Turns cabinet ON and OFF.
Also Changes Display to °Celsius or °Fahrenheit
Scale: You may change the digital thermometer scale to
either °C or °F as follows: While unit is OFF, press and
hold the “ON/OFF” key for five (5) seconds. The display
will then switch from “dE9F” to “dE9C”. Repeat to change
scale again.
Power Indicator Light - Indicates that the power is on.
Arrow up ▲ increases temperature and arrow down ▼
decreases temperature.
REFRIGERATOR MODE:
Temperature Range: 33°F to 40°F (1°C to 4.4°C)
Temp Display - Digital temperature display shows the
temperature of the cabinet.
REFRIGERATOR MODE:
Temperature Range: 33°F to 40°F (1°C to 4.4°C)
“dE9F” = Degrees Fahrenheit
“dE9C” = Degrees Celsius
Cycling Indicator Light -
When light is “ON”, this indicates that the cabinet is
cooling down to desired temperature (compressor is
activated) and will go “OFF” when unit has reached
desired temperature.
QUICK START GUIDE & INFORMATION
ON
CYCLE

7
FWE REFRIGERATED "COLD-TEMP" SERIES FWE REFRIGERATED "COLD-TEMP" SERIES
QUICK START GUIDE & INFORMATION
TEMPERATURE RECALL
Press to display either “Actual Internal Cabinet” actual
temperature, or desired “Set Point” temperature.
Set Point: The factory default setting shows the "Set Point"
temperature. A momentary touch of the “Temp Recall” key will display
actual temperature. The display will then automatically return to the
set point temperature.
Actual: To have temperature read-out display the “Actual”
temperature press and hold the “Temperature Recall” Key for five
(5) seconds. The fourth (4th) digit on the display will flash either “S”
(Set), or “A” (Actual) to indicate which mode is active. To switch back
again, repeat this step holding the “Temperature Recall” key for five
(5) seconds.
COLD-TEMP CONTROL PANEL
Activated red light indicates DEFROST is in progress.
DEFROST CYCLE - “ON DEMAND” DEFROST
Press to Activate DEFROST at any time.
Press to Cancel Defrost in progress (Defrost Override).
Note: A 60 second count down will begin on display
before defrost cycle cancels.

8FWE Operating Instructions | Refrigerated "Cold-Temp" Series
CLEANING GUIDE
FWE REFRIGERATED "COLD-TEMP" SERIES
CLEANING
Keep your cabinet clean by simply wiping the interior and exterior, as needed,
with a damp cloth or sponge and a mild soapy solution.
NEVER USE ABRASIVES, ACIDS, OR STRONG CLEANERS.
Do not flood or allow electrical parts to become wet. The interior tray slide
assemblies are removable for easy cleaning.
A stainless steel cleaner/polish is recommended for the exterior to maintain a
“like-new” appearance.
DO NOT USE WAX OR STRONG CLEANERS ON DOOR GASKETS OR
VINYL TRIM.
The most important thing you can do to insure a long, reliable service life
for your FWE Refrigerator or Freezer is to regularly clean the condenser
(compressor) coil. The condensing unit requires regularly scheduled cleaning
to keep the finned condenser clean of lint and dust accumulation.
Keeping the condenser clean allows the cabinet to operate efficiently, use less
energy, and achieve top performance values.
To clean the condenser, first disconnect electrical power to the cabinet. Remove
condenser cover and vented panel in front of condenser coil. Vacuum any
dirt, lint, or dust from the finned condenser coil, compressor and other cooling
system parts. If significant dirt is clogging the condenser fins, use brush or
compressed air to blow this clear.
NOTE: Care should be taken not to bend any of the condenser fins, as
this will reduce performance and compressor life. Replace vented panel,
condenser cover and screw which hold them in place.
CLEANING THE CONDENSER:
YES!
USE THESE
PRODUCTS
DO NOT
USE THESE
PRODUCTS

FWE REFRIGERATED "COLD-TEMP" SERIES
9
TROUBLE-SHOOTING CHART
PROBLEM
Control panel will not light up.
Cabinet will not reach
desired temperature.
Display reads “dE9F”
Display reads “dE9C”
REMEDY
• Cabinet not plugged into outlet or check
breaker to power outlet.
• Plug cabinet into properly grounded
electrical outlet.
• Press “ON”Button
• Clean the Condenser; See Page 8 for
Instructions
• Opening door unnecessarily. Keep door closed
and latched shut after loading. Set temperature
to Display to °Celsius or °Fahrenheit Scale:
You may change the digital thermometer scale
to either C or F as follows: While unit is OFF,
press and hold the Power Button
until “dE9F”to “dE9C”. Repeat to
change scale again.
• Temperature is set to Fahrenheit scale
• Temperature is set to Celsius Scale
1. It is possible that the unit will self-initiate a defrost if excessive ice is on coil. NOTE:
If the coil is not defrosted, temperatures will rise and reduced performance will
be noticeable. During the defrost cycle or the “Off Cycle” of the compressor, the
evaporator coil will defrost. The condensation from the evaporator coil flows from the
top of the unit down a drain in the back to a condensate pan. Vapor escapes through
the back grill. The vapor can sometimes be visible and should be considered a normal
operating condition
2. If the temperature zone is too high and cabinet will not chill to desired temperature:
Dirt, lint, and/or dust are on the condenser (compressor) coil. Check condenser coil
and clean if necessary. See "Cleaning The Condenser" section on Page 8 for proper
cleaning instructions.

10 FWE Operating Instructions | Refrigerated "Cold-Temp" Series
FWE REFRIGERATED "COLD-TEMP" SERIES
SERVICE RECORD
Model Number ______________________
Serial Number ______________________
Date of Purchase ____________________
Notes:
___________________________________________________
___________________________________________________
___________________________________________________
___________________________________________________
___________________________________________________
___________________________________________________
___________________________________________________
___________________________________________________
___________________________________________________
___________________________________________________
___________________________________________________
___________________________________________________
___________________________________________________
___________________________________________________
___________________________________________________
___________________________________________________
___________________________________________________
___________________________________________________
___________________________________________________
___________________________________________________
___________________________________________________
___________________________________________________
CAUTION:
HOLDING FOOD AT TEMPERATURES MORE THAN 40°F(4.4°C) MAY BE DANGEROUS.
TEMPERATURES MORE THAN 40°F (4.4°C) PROMOTE THE GROWTH OF HARMFUL
BACTERIA AND TOXINS IN SOME FOODS.