Gainsborough Contemporary Series User manual

Fit here on door edge
FOLD HERE
TRILOCK DUMMY
FITTING INSTRUCTIONS
10mm
(3/8") hole
10mm
(3/8") hole
ORIGINATION CRM GSH 853 0711
PAIT 070
JUL ‘11
Installation template for Gainsborough Trilock
Traditional & Contemporary Series
– Fold template where indicated.
– Position template on door edge at
desired height.(Generally to line up
with operating Trilock on opposite door)
– Firmly hold template to door and mark
the four hole centres as indicated.
– Drill holes (suggest pilot holes first
3mm, 1/8") then the correct size
10mm, 3/8" from both sides of the
door.
Contemporary Series
– Install threaded posts to the outside
faceplate.
Traditional Series
– Install blind screws and brass posts to
Trilock external faceplate (this is the
faceplate without the rectangle snib
push-button).
– Insert dummy plug into the inside of
both plates before affixing faceplates to
door. (To help hold dummy plugs in
position, apply a strip of adhesive tape
if required.)
– Mount the outside faceplate to door.
– Align the inside faceplate to door and
fit mounting screws and tighten into
threaded posts.

FOLD HERE
PAIT 070
JUL ‘11
Fit here on door edge
TRILOCK DUMMY
FITTING INSTRUCTIONS
10mm
(3/8") hole
10mm
(3/8") hole
Installation template for Gainsborough Trilock
Traditional & Contemporary Series
– Fold template where indicated.
– Position template on door edge at
desired height.(Generally to line up
with operating Trilock on opposite door)
– Firmly hold template to door and mark
the four hole centres as indicated.
– Drill holes (suggest pilot holes first
3mm, 1/8") then the correct size
10mm, 3/8" from both sides of the
door.
Contemporary Series
– Install threaded posts to the outside
faceplate.
Traditional Series
– Install blind screws and brass posts to
Trilock external faceplate (this is the
faceplate without the rectangle snib
push-button).
– Insert dummy plug into the inside of
both plates before affixing faceplates to
door. (To help hold dummy plugs in
position, apply a strip of adhesive tape
if required.)
– Mount the outside faceplate to door.
– Align the inside faceplate to door and
fit mounting screws and tighten into
threaded posts.