Gama Sonic BAYTOWN II User manual

1
Visit our website or download the latest version of your instruction manual:
www.gamasonic.com or www.gamasonic.com/user-guides
BAYTOWN II
SOLAR LAMP POST
US Patent # 7172307
Patent Pending DIY Installation
For Solar Lamp Post
Instruction Manual
Model: GS-105SG

2
Introduction
Thank you for your purchase. GAMA SONIC®solar charged accent lighting
eliminates the problems associated with most solar lighting available today.
GAMA SONIC®solar charged lights are brighter and last all night with a typical
solar charge. Unique design, superior light output and numerous installation
options confirm the outstanding value of our product.
GAMA SONIC®has been recognized as a worldwide leader in the lighting
industry for over 20 years. The company also offers unique multi-purpose
rechargeable products that range from party lights to emergency lighting
products.
For technical assistance and more information call our Toll Free number:
800-835-4113 (only within the US) or visit our website at:
www.gamasonic.com.
Please read the instruction manual carefully to obtain the best results from
your purchase.
Solar Lamp Post Location
For optimum light duration throughout the night, it is very important to place
your solar lamp in a spot where it will receive the maximum amount of direct
sunlight throughout the day.
NOTE: For best results, the solar lamp post must be charged for two sunny
days on the “ON” position,
Operation Instructions
1. Remove the top (A) by unscrewing the 2
screw caps. Turn the operation switch to
“summer” (for greater brightness) or
“winter” (for longer duration) position. The
Solar Lamp will automatically operate at
dusk.
2. Reattach top (A) and secure with the 2
screw caps.

3
1. Attach the body(B) to the stem(D)
with the four supplied screws,
as shown.
Assembly Instructions:
2. Place the lens and
cone(C) in the body(B).
3. Turn on switch to desired
setting.
4. Attach top(A) to the body(B) with
the two supplied screw caps.
5. Attach Side handles provided.
6. Screw on top Ornament.
B
D
C
D
B
D
B
A
D
A
A
D

4
Four easy ways for installation:
Flat mount (8.1 - 8.2)
EZ Anchor (9.1 - 9.7)
Flat installation (Installing the lamp post without anchor):
EZ Anchor Installation Instructions:
8.1Mark three holes with the base
plate as a template. With an
electric drill, drill the holes into
concrete. Assemble with the
hardware provided.
7. Assemble pole by screwing the
four pieces together.
8.2After assembling attach the three
decorative caps provided.
and screw the fixture to the base.
9.2 Insert the Turning bar (G) in
the hole through the anchor
stake (H) as shown.
9.1 Attach Part (E) to Part (F)
Using the four small screws from,
as shown.

5
Replacing the Batteries
(After several years of use, the battery may need replacing).
1. Unscrew the two screw caps and detach the top (A). Make sure
the ON/OFF switch is in the OFF(O) position.
2. Unscrew the battery compartment (Fig. 1) screw located on the
silver reflector and remove the compartment door.
3. Unclip the connector and remove the old battery. Make sure the
new battery is a Gama Sonic - 3.2V/1,500mAh, Li-ion
Rechargeable battery with connector.
4. Clip on new battery and install into the battery compartment.
Screw back battery compartment screw.
5. Reattach the top and secure with the 2 screw caps.
** Batteries are available at www.gamasonic.com
WARNING: Do not dispose of Li-Ion battery in the regular trash, municipal
waste stream or by fire as batteries may leak or explode. Do not open, short
circuit, or mutilate batteries as injury may occur. Preserve our environment by
recycling Li-Ion batteries or disposing of them in accordance with local, State
and federal regulations. Do not mix old and new batteries.
Maintenance
Clean the solar panels regularly with a damp towel to guarantee optimum
performance. Do not use any type of solvent for cleaning and be careful not to
put too much pressure on the solar panels while cleaning.
9.3 Place anchor in desired location and apply downward pressure while
turning the Turning bar clock wise.
9.4 Occasionally check the anchor Level Tool to ensure your digging is
straight.
I
G
H
9.5 Stop turning once Part (I) is flat with ground level.
9.6 Remove the Turning Bar(G).
9.7 Screw the fixture to the Anchor.

6
Trouble Shooting
If your solar charged light does not come on at dusk despite observance of all
the instructions, please try the following steps:
1. Make sure that the solar lamp is not being affected by any other
light source.
2. Ensure the solar lamp is not positioned in the shade during the
day.
3. Make sure the switch on the lamp head is in either the Low or
High position.
4. Check that the batteries are installed correctly.
NOTE: The performance of the solar lamp will vary with the time of year. It will
deliver more light when it has had a full day in the sun rather than a day in
overcast weather.
WINTERTIME TIPS: For optimal performance, be sure to remove any snow
or debris accumulation from solar panel(s). A solar panel free of debris will
charge the batteries much more efficiently.
WARNING: Please keep out of reach of children.