Garmin AMPS Rugged Mount User manual

Instructions
AMPSRuggedMount
MONTANA™600Series

AMPSRuggedMountInstructions
 
See the Important Safety and Product Information in the Montana product box
before installing the rugged mount.
notice
Incorrectly wiring the power/audio cable with bare wire leads can result in damage
to the vehicle or the battery. Garmin strongly recommends having an experienced
installer with the proper knowledge of electrical systems install the mount.

• AMPS Rugged Mount
• Anti-glare screen protector with applicator card and instructions
• 4 nuts and 4 washers (for AMPS mount)
• 4 screws (for AMPS mount)
• Security screw tool
NOTE: Installation of the rugged mount to all vehicles requires an AMPS mount
(not included).

Garmin’s standard limited warranty applies to this accessory. For more
information, see the Important Safety and Product Information in the Montana
product box.

AMPSRuggedMountInstructions

notice
If any wire is left unconnected, insulate the wire and safely secure it on your
vehicle.
1. Select a location to mount the Montana on your vehicle, based on available
power sources, safe cable routing, and that the driver view is not obstructed.
2. Connect the red ➊ and black ➋ wires to your vehicle’s main power (10 to 50
Volts).
➏
➋
➊
➌
➍
➎
3. If necessary, connect the serial data wires to your vehicle.
• Yellow ➌ is the serial data input wire.
• Blue ➍ is the serial data output wire.
• Green ➎ is the serial ground wire.
4. If necessary, connect the audio jack ➏ .

AMPSRuggedMountInstructions

The AMPS mount is not included with the rugged mount.
1. Thread the screws ➊ through the washers ➋ , mount ➌ , and AMPS mount base
plate ➍ (not included).
➊
➋➌
➍
➎
2. Tighten the nuts ➎ to secure the base plate.
The recommended torque is 15–20 lbf-in (1.7 to 2.25 Nm).

notice
Before placing the device in the mount, ensure that the metal contacts on the
device and the mount are dry to avoid equipment damage. Use the weather cap to
keep the mount cradle dry.

1. Place the weather cap ➊ in the storage area on the mount.
➋
➊
➌
2. Fit the bottom of your device into the cradle ➋ .
3. Tilt the device back until it snaps into place.
4. Using the security screw tool, tighten the security screw ➌ on the top of the
mount.
NOTE: If reected light or glare makes the device display difcult to see, apply
an anti-glare screen protector to the screen.

1. Loosen the security screw.
2. Press the button on the side of the mount to release
the device.
3. Lift out the device.
4. Place the weather cap ➊ on the cradle.
➊
Shop for other gadgets & electronics on our website.