GE WNCD2050 User manual

Parts Included
• Washer and Dryer Overlays
• Braille Reference Keys (2 washer, 2 dryer)
• Use and Care Audio Tape
Tools Needed
•Tape-tipped putty knife (optional)
Braille Reference Keys
The Braille reference keys included in the kit explain
the operation of the washer and dryer. Place the Left
key on the left side and the Rightkey on the right
side of the control panel.
NOTE: Make sure the protective film is removed
from the washer or dryer control panel before
applying the reference keys.
Removingthe OldButtonOverlay
1. Unplug the washer or dryer.
2. Carefully peel the old button overlay from the
control panel, using a tape-tipped putty knife if
necessary. Make sure that excess adhesive is
removed from the control panel. Keep the old
overlay handy as a reference.
Printed in the United States 175D1807P392 49-90129 02-02JR

Applying the Braille Overlay
1. Plug the washer or dryer back in.
2. For washers: Using the old overlay as a reference,
press and hold the White Cottonsbutton in the
upper left corner and the Startbutton in the upper
right corner of the control panel. After 3 seconds,
all lights on the control panel will light up.
For dryers: Using the old overlay as a reference,
press and hold the AirOrybutton in the lower left
and the High heat button in the upper right of the
control panel. After 3 seconds, all lights on the
control panel will light up.
3. Peel the paper backing from the Braille overlay.
Starting on one side of the panel, apply the Braille
overlay over the buttons, using the lights for
alignment. If the overlay does not line up properly
so all lights are visible through the overlay, peel it
off and reapply. Once the overlay is properly
aligned, press firmly around the border to secure
it in place.
4. Once the overlay is applied, press STOP/CANCEL
to turn off the control panel lights.