GE Monogram ZDWT240 User manual

Design Guide with
installation
Instr
Wine Reserve
ZDWT240
Gnd
Beverage Center
ZDBT240
monogram.com

Safet Information
BEFORE YOU BEGIN:
Read these instructions completelg and carefullg.
IM PORTANT - Sovetheseinstructions
for Iocol inspector's use.
IM PORTANT -Observeoligoverningcodes
ond ordinonces.
Note to Installer - Besure to leove these
instructions with the Consumer.
Note to Consumer - Keepthese instructions with
gour Owner's Monuol for future reference.
WARNING - Thisopplionce mustbe
properly grounded. See "Grounding", poge 5.
_AVERTISSEMENT -
Cet opporeil doit @trecorrectement mise 5 Ioterre.
Consulter <<Mise _ Ioterre >>,poge 5.
If gou received o domoged wine reserve or beveroge
center, gou should immediotelg contoct gour deoler
or builder.
Skill Level - Instollotion requires bosic mechonicol
skills. Proper instollotion isthe responsibilitg of the
instoller. Product foilure due to improper instollotion
is not covered under the GEApplionce Worrontg.
_WARNINGS:
• Usethis opplionce onlg for its intended purpose.
• Immediatelg repair or replace electrical service cords
that become fraged or damaged.
Unplug the unit before cleaning or making repairs.
Repairs should be made bg a qualified service
technician.
-AAVERTISSEMENT:
• IIne fout utiliser cet opporeil que pour I'usoge pour
lequel il o @t@construit.
IIfout r_porer ou remplocer imm@diotement tout
cordon d'olimentotion @lectriqueeffiloch@ou
endommog&
D@broncherlebor ou le r@frig@roteuro vin ovont
le nettogoge ou toute intervention.
Lesr_porotions doivent @trefoites por un technicien
quolifi&
For Monogram local service in gour area,
call 1.800.444.1845
For Monogram service in Canada, call
1.800.561.3344
For Monogram Parts and Accessories, call
1.800.626.2002.
www. monogram.com
CONTENTS
Design Guide
The Instollotion Spoce..............................3
Side-bg-Side Instollotions .......................4
Product Clearances .................................../4
Installation Instructions
Tools Required ..............................................5
Grounding the Product ...........................5
Staining Wood Drawer Fronts .............5
Step 1, Remove Packaging ....................5
Step 2, Leveling ............................................6
Step 3, Connect Power.............................6
Step 4, Slide Product into Cutout .........6
Step 5, Change the Toekick....................6
Step 6, SetTemperature Controls .......6

Desi n Guide
THE INSTALLATION SPACE
24"Min.
NOTE:
Handle and handle
standoff depth is 1-3/4"
34-1/4"
tI
34- /4"
25-1/2" __i ..........
Including ....
Handle ........23-5/8"
*For a standard installation: The product must be installed
sothat the front face will project 1-3/4" forward of adjacent
cabinets. This position will allow afull door swing and prevent
interference with adjacent cabinetrg. The opening between
cabinets must be 23-3/4" minimum.
**For a flush installation: Install a 1/2"-wide filler strip on the
hinge side.Thefiller strip will act as aspacer between the
door case and adjacent cabinets and will prevent interference
with the cabinet door swing. Recessthe filler strip 1-3/4" back
from the front face of the unit, or even with the front edge
of the product case (behind the gasket).The width of the
opening must be 24-1/4" (including the 1/2" filler strip).
• Thewine reserve end beverage center can be installed
freestanding.
Additional Specifications
• A 120 volt 60Hz., 15 or 20 amp power supplg is
required. An individual properlg grounded branch
circuit or circuit breaker is recommended. Install a
properlg grounded 3-prong electrical receptacle
recessed into the back wall as shown. Electrical must
be located on rear well as shown. NOTE:GFI(ground
fault interrupter)is not recommended.
THE INSTALLATION SPACE (cont.)
........................................................................................................
Installation 1/2" !
Fillerpanelorcleat
tobesetbackeven
withfrontofcase.
Frontedge of productcase CABINET
IFrontface
\
These products will fit flush \
to adjacent cabinets when
installed with a 1/2" filler panel
or cleat. Thefiller panel should
be recessed or set back behind
the door and even with the front
edge of the product case.
Standard
Installation
Frontedgeof productcase
1-3/4" Frontface
In a standard installation,
the product will project 1-3/4"
forward of adjacent cabinets.
CABINET

Desi n Guide
SIDE-BY-SIDE INSTALLATIONS
Increase storage capacitg by installing two Monogram
beverage centers or wine reserves together. Or,for a
complete refreshment center, install ang two of these
units together.
• A side-bg-side installation requires at least a 47-!/2"
wide minimum opening for standard installation and
48-!/2" wide minimum opening for flush installation.
No trim kits required.
• Products must operate from separate, properlg
grounded receptacles.
PRODUCT CLEARANCES
The wine reserve and beverage center isfactorg set
for a 110° door swing.
When installed in a corner:
• Allow 4" min. clearance on the hinge side for the 90°
door swing and to allow racks to slide out.
• Allow 10"minimum clearance on the hinge side
for a full 110°door swing.
10"Minimum
to Wall
10o. iiii' :,
Choose the location:
90° DoorSwin(
-5IS"
DE. 1
23-5/8"
"90Y ,j J
" " h
4"Minimum
toWall
• These products mag be closed in on the top and
three sides as long as the front is unobstructed for
air circulation and proper access to the door.
• Donot install these products where the temperature
will go below 55°F(!3°C) or above 90°F (52°C).
Donot install where it will be subject to direct sunlight,
heat or moisture.
These products are not designed to be stacked one
over the other.
Black or Stainless Steel Toekick Options
• These products are shipped with a black toekick
installed. An optional stainless steel toekick is also
supplied with each product. Forshipping purposes,
the stainless steel toekick is secured to the back
or inside the unit.

Installation Instructions
TOOLS REQUIRED
• #2 Phillips screwdriver
• Adjustable wrench
PARTS SUPPLIED
• Optional stainless steel toekick with screws
and spacers
GROUNDING THE WINE CHILLER,
WINE RESERVE AND BEVERAGE
CENTER
IMPORTANT - Pleasereadcarefully.
FORPERSONALSAFETY,THISAPPLIANCEHUSTBE
PROPERLYGROUNDED.
The power cord of this appliance isequipped with
a three-prong (grounding) plug which mates with
a standard three-prong (grounding) wall receptacle
to minimize the possibility of electric shock hazard
from this appliance.
Have the wall outlet and circuit checked by a qualified
electrician to make sure the outlet is properly grounded.
Where a standard 2-prong wall outlet isencountered, it
is your personal responsibility and obligation to have it
replaced with a properly grounded 3-prong wall outlet.
DO NOT, UNDER ANY
CIRCUMSTANCES, CUT
OR REMOVETHE THIRD
(GROUND) PRONG
FROM THE POWER CORD.
L ::R
i(,¸,,,i
i ii _L'£ i'
DO NOT USE AN ADAPTER PLUG TO CONNECTTHE
REFRIGERATORTO A 2-PRONG OUTLET.
DO NOT USEAN EXTENSION CORD WITH THIS
APPLIANCE.
STAINING WOOD DRAWER FRONTS
The drawer fronts are unfinished cherry wood.
During use, oil from hands may accumulate and stain
the wood.
The drawer fronts may be stained and sealed to
match adjacent cabinetry. The tinted glass will make
the stained wood appear darker. A true color match
can be seen only when the door isopened.
Apply the stain and sealer according to the
manufacturer's instructions. Toavoid unpleasant
odor, keep the door open to ventilate and allow
the stain/sealer to dry completely before using
the product.
j STEP 1 j REMOVE PACKAGING
• Remove corner blocks and foam drawer stops.
• Remove all packing material, tape and protective
plastic coverings.
Remove stainless steel toekick taped to the back
or inside of the unit.
-ACAUTION: Smallobjectsarea choke
hazardforchildren.Remove and discordany ports
notused.
-&MISE EN GARDE :Lespetits
objets peuvent _trangler lesenfants. IIfautjeter
toutes les pi_ces qui ne sont pas utilis_es.

Installation Instructions
[STEP 2 j LEVEL
• Use an adjustable wrench to turn the leveling legs and
raise or lower the product.
• Adjust carefully; the product should be level and plumb
with cabinetry, and should align with adjacent toekick
height.
\\\\
TurnRighttoLower
/TurnLefttoRaise
/
[ STEP 3 j CONNECT POWER
,,Connect power cord plug to a properlg grounded
receptacle.
Check to make sure power is on bg opening the door
to see if interior light turns on.
i STEP 4 ] SLIDE PRODUCT INTO
THE CUTOUT
WARNING: Do not apply pressure or
push against the glass door when moving or installing
these products. Pressure against the glass door will
cause damage.
AVERTISSEIENT : Ne poussez
jamais et ne mettezjamais de pression sur la porte
en verre quand vous d@lacez ou installez ces
produits. Toute pression sur le verre occasionnera
des dommages.
Carefully slide the unit into the opening. Be careful
not to entangle power cord.
• Make certain that the door protrudes 1" beyond
the surrounding cabinets.
• Check again to be sure the unit is level.
[ STEP 5 j CHANGE THE TOEKICK
• The stainless steel toekick is secured to the back
of the product or inside.
• Thetoekick has a cutout
on the left and right
sides. Remove
the plug on
the left side
and reinstall
on the right MoveFill
side. If you i Plugto
choose to RightSide
install the _"-. _ z
stainless .....-_._::-.
steel toekick, _
reinstall the plug
on the right side
of that toekick.
•Install original screws and spacers or screws and
spacers supplied with the stainless steel toekick. Install
screws through the spacer standoff, toekick and into
the base as shown.
[ STEP 6 j SET TEMPERATURE
CONTROLS
• Thetemperature controls are preset. Refer to the
Owner's Hanual for more information. Allow 24 hours
for temperature to stabilize.

Notes

Note: While performing installations described in this book,
safety glasses or goggles should be worn.
For Monogram ®local service in gout area, call
1.800.444.1845.
Note: Product improvement is a continuing endeavor at
General Electric. Therefore, materials, appearance and
specifications are subject to change without notice.
Pub. No. 31-46065-2
Part No. !97D6374P001
09-09 JR
Printed in Slovenia
GE Consumer & Industrial
Appliances
General Electric Compang
Louisville, KY40225
GEAppliances.com