GeoVision Surveillance System V8.4 User manual

Before attempting to connect or operate this product,
please read these instructions carefully and save this manual for future use.
Installation Guide V8.4
Installation Guide V8.4

© 2010 GeoVision, Inc. All rights reserved.
Under the copyright laws, this manual may not be copied, in whole or in part,
without the written consent of GeoVision.
Every effort has been made to ensure that the information in this manual is
accurate. GeoVision, Inc. makes no expressed or implied warranty of any kind
and assumes no responsibility for errors or omissions. No liability is assumed
for incidental or consequential damages arising from the use of the information
or products contained herein. Features and specifications are subject to
change without notice.
GeoVision, Inc.
9F, No. 246, Sec. 1, Neihu Rd.,
Neihu District, Taipei, Taiwan
Tel: [phone]
Fax: [phone]
http://www.geovision.com.tw
Trademarks used in this manual: GeoVision, the GeoVision logo and GV
series products are trademarks of GeoVision, Inc. Windows and Windows XP
are registered trademarks of Microsoft Corporation.
October 2010

Contents
Important Notice before Using GV-Video Capture Card .....................1
Chapter 1 Video Capture Cards .........................................................4
1.1 GV-4008 .................................................................................................................5
1.2 GV-3008 ...............................................................................................................13
1.3 GV-1120A, 1240A, 1480A ....................................................................................19
1.4 GV-1008 ...............................................................................................................27
1.5 GV-650A, GV-800A ..............................................................................................32
1.6 GV-600A ...............................................................................................................37
1.7 Installing Two Cards .............................................................................................42
1.8 Installing Drivers ...................................................................................................46
1.9 Connecting Hardware Watchdog..........................................................................48
1.10 Comparison Chart (H/W Compression)................................................................49
1.11 Comparison Chart (S/W Compression: Single Card) ...........................................50
1.12 Comparison Chart (S/W Compression: Two Cards).............................................52
Chapter 2 Hardware Accessories ....................................................54
2.1 GV-Multi Quad Card .............................................................................................55
2.2 GV-Loop Through Card ........................................................................................59
2.3 GV-NET Card V3.1 ...............................................................................................62
2.4 GV-NET/IO Card V3.1 ..........................................................................................65
2.5 GV-Hub V2 ...........................................................................................................75
2.6 GV-COM V2..........................................................................................................79
2.7 GV-I/O 12-In Card V3 ...........................................................................................82
2.8 GV-I/O 12-Out Card V3 ........................................................................................85
2.9 GV-I/O Box (16 Ports)...........................................................................................88
2.10 GV-I/O Box (8 Ports) ............................................................................................95
2.11 GV-I/O Box (4 Ports) ..........................................................................................102
2.12 Accessing GV-I/O Box over Networks................................................................108
2.13 Installing USB Driver ..........................................................................................119
Chapter 3 Software Installation .....................................................120
3.1 Before You Start .................................................................................................121
i

3.2 Installing the System...........................................................................................122
3.3 Program List .......................................................................................................124
Chapter 4 Screen Overview............................................................126
4.1 Main System .......................................................................................................127
4.2 ViewLog ..............................................................................................................129
4.3 Remote Playback Client .....................................................................................130
4.4 SingleView Viewer ..............................................................................................134
4.5 MultiView Viewer ................................................................................................135
4.6 Center V2............................................................................................................137
4.7 Control Center Toolbar .......................................................................................139
Troubleshooting .................................................................................140
ii

Important Notice before Using GV-Video Capture Card
1. Exclusions:
•Currently GV-Video Capture Cards are not compatible with VIA-series, ATI-series
chipset motherboards.
If your GV-Video Capture Card or GV-System works in conjunction with the following GV
accessories, note the limitation that these accessories do not support 64-bit Windows
versions currently.
GV-Multi Quad Card GV-NET/IO Card (USB port connection)
GV-COM Box GV-NET Card (USB port connection)
GV-Hub Box GV-Keyboard
2. Hard Disk Requirements:
•It is strongly recommended to use two separate hard disks. One is for installing Windows
operating system and GV-System software, and the other is for storing recorded files.
•The total of recording frame rates that you can assign to a single hard disk is listed as
below:
Frame rate limit in a single hard disk when connecting to analog cameras
Software Compression
MPEG4-ASP
Video Resolution NTSC PAL
CIF 480 fps 400 fps
VGA/D1 240 fps 200 fps
Turbo VGA 416 fps 400 fps
Turbo D1 352 fps 320 fps
Hardware Compression
H.264
Video Resolution NTSC PAL
D1 240 fps 200 fps
1

Frame rate limit in a single hard disk when connecting to IP cameras
MJPEG H.264 MPEG4
Video
Resolution Frame Rate Bit Rate Frame Rate Bit Rate Frame Rate Bit Rate
2560x1920 (5M) 30 fps 102.26 Mbit/s 240 fps 21.24 Mbit/s
2560x1600 (4M) 60 fps 73.49 Mbit/s 240 fps 15.28 Mbit/s
2048x1536 (3M) 60 fps 64.73 Mbit/s 480 fps 10.52 Mbit/s
1600x1200 (2M) 120 fps 41.16 Mbit/s 480 fps 9.16 Mbit/s
1280x960 (1.3M) 200 fps 30.04 Mbit/s 480 fps 5.77 Mbit/s 480 fps 6.30 Mbit/s
640x480 (VGA) 480 fps 11.42 Mbit/s 640 fps 2.54 Mbit/s 640 fps 3.27 Mbit/s
320x240 (CIF) 480 fps 5.16 Mbit/s 640 fps 0.75 Mbit/s 640 fps 1.03 Mbit/s
Note: The above data was determined using the bit rate listed above and hard disks with
average R/W speed above 80MB/s.
The frame rate limit is based on the resolution of video sources. The higher video
resolutions, the lower frame rates you can assign to a single hard disk. In other words,
the higher frame rates you wish to record, the more hard disks you need to install. For the
information of recording frame rates, you may consult the user’s manual of the GV-
System or the IP camera that you wish to connect to.
•The hard disk space required to install GV-System must be at least 1 GB.
•To use Advance Video Analysis, at least 1 GB of memory is required.
•To use two or more of the following functions simultaneously, at least 2 GB of memory is
required: Advance Video Analysis, Video Analysis, IP Camera and Pre-Record by
Memory.
3. IP Camera with H.264 Codec
•To connect the IP cameras with H.264 codec and GV-IP Speed Dome (no matter which
codec you select), the CPU of Core 2 Quad can only support up to 8 channels. With
CPU of Core i7 or higher, you can record up to 32 channels but note the following limit
for live viewing:
¾For live viewing of 32 channels, you need to lower the resolution and change the
codec to MPEG 4 or MJPEG.
2

4. CPU Requirements:
•For recording resolution of 640 x 480 or above, Pentium 4 processor with Hyper
Threading is required.
5. Default Settings:
•For software recording rates, all GV Cards are set to CIF. For hardware recording rates,
GV-4008 Card is set to D1.
6. The Card with PCI-E Interface:
•All GV-Video Capture Cards with PCI-E Interfaces have x1 interface which can be
inserted into the PCI Express x1, x4, x8 or x16 slot.
7. GV-600A, GV-650A and GV-800A:
•Starting from V8.3.2, GV-600 (V4), GV-650 (V4) and GV-800 (V4) are renamed to GV-
600A, GV-650A and GV-800A. These V4 Cards and A Cards are the same video capture
cards.
8. End of Support:
•Starting from V8.3, GV-System will not support GV-250 Card, GV-Hybrid DVR (MPEG2)
Card and GV-DSP Card.
•Starting from V8.3.2, GV-System will not support GV-2004 Card.
•Starting from V8.3.2, GV-System will not support MPEG2 codec.
3

Chapter 1 Video Capture Cards
This chapter includes the following information:
•Minimum system requirements
•Packing list
•Connection diagrams
•Specifications
•Driver installation
•Comparison chart

Video Capture Cards
1
1.1 GV-4008
The GV-4008 Card provides up to 8 video and 8 audio channels, recording up to 240/200
fps (NTSC/PAL) in total with H.264 hardware compression. The new technology of
resolution is employed to enhance the live image of D1 without DSP Overlay. Even in
screen divisions, the largest division can remain at the high-quality D1 resolution.
Minimum System Requirements
32-bit Windows XP / Windows Vista / Windows 7 / Windows Server 2008
OS
64-bit Windows 7 / Windows Server 2008
GV-4008 Core 2 Duo, 2.33 G
CPU
GV-4008 x 2 Core 2 Quad, 2.4 G
GV-4008
RAM
GV-4008 x 2
2 x 1 GB Dual Channels
GV-4008 250 GB
HDD
GV-4008 x 2 500 GB
VGA ATI Radeon X1300 PCI-E / NVIDIA GeForce 7300 PCI-E
DirectX 9.0c
Power Supply 400 Watts
Packing List
1. GV-4008 Card x 1
2. 1-8 Cam Audio BNC Cable with BNC
Male to RCA Female Adaptors x 1
3. 1-8 Cam Video BNC Cable x 1
4. Hardware Watchdog Jumper Wire x1
5. SATA Power Converter Cable x 1
6. USB Dongle x 1
7. Software DVD x 1
8. Feature Guide x 1
9. Installation Guide x 1
5

Connecting One GV-4008 Card
•Connect the video and audio cables to the GV-4008 Card.
•Using the supplied SATA Power Converter Cable, connect the GV-4008 Card to power
supply. The Power LED in the top right corner should be lit in green and the 4 status
LEDs (D3, D9, D14, D18) in the left corner should be lit in green to indicate the normal
functionality.
Figure 1-1
Note:
1. The GV-4008 Card only works when the supplied USB Dongle is inserted to PC.
2. The GV-4008 Card cannot work with microphones which acquire power from the PC.
Use microphones which have external power supply.
6