Ger Detect Gold Hunter User manual

English User Manual


English User Manual

GOLD HUNTER
GOLD AND METAL DETECTOR
Overview
➢
Dear customer, thank you for choosing GOLD HUNTER
DEVICE.
➢
This product enables you to detect the presence of gold &
diamond & gemstones.
➢
GOLD HUNTER designed to help you discover GOLD,
DIAMOND, GEMSTONES
➢
In addition, it can confirm your target and identify the type
underground with the depth.
Critical Warning
•••
Please be sure that all precautions are
taken against risks
Do not use your device while it is raining
or on an extremely wet floor
Turn on your device after you make sure
that all parts are in place
Make sure that the device battery is fully
charged before searching
If the battery starts to give a beep sound,
close the device and recharge the battery
It is recommended to read the user
manual before starting working on the
device to understand everything and to
avoid mistakes while doing the search
After the device starts make sound and
turn off automatically put the battery on
charge and do not try to start the device
without charging the battery
Be aware of high voltage resources, and
do not use any charger other than the
original charger that comes with the
device.
Main unit of the device is under warranty
against all electronic breakdowns for two
(2) years
Any damages caused by user errors
(laying open the main unit, hits, harms
etc.) are not within this warranty
Battery and antenna are also not within
this warranty
You should follow the instructions in this
user manual strictly to minimize the
faults and to use your device correctly

English User Manual

THE DEVICE SYSTEM AND WORK STEPS
THE LONG-RANGE SYSTEM
1
CONNECT THE LONG RANGE PARTS TO THE DEVICE
CONNECT THE HANDLE TO THE DEVICE
This system specializes to cover vast areas and locate the target within
1
meter
Square and depths up to 35 meters below the surface of the ground and Front
Range up to 2,000 meters.
Super antenna
Dispatcher Antenna
Recipient antenna

English User Manual

CONNECT THE SIGNAL TRANSMITTER
CONNECT THE SUPPER ANTENNA
CONNECT THE SIGNAL RECIPIENT

English User Manual

SWITCH (ON / OFF) BUTTON
THE DEVICE WORKS IN FOUR LANGUAGES
(GERMAN-ENGLISH-FRENCH-ARABIC)
The explorer must stand facing from north to south, which is the best way to search
for gold and hidden treasures underground.
If no signal is obtained, change the direction from east to west and from west to
east and from south to north.
Upon obtaining a signal, the antenna will circumvent the target directly
SWITCH ON THE DEVICE THROUGH THE (ON/OFF)
THE BATTERY LED: THIS LED WILL TURN ON
WHEN THE BATTERY CHARGE RUN OUT
"

English User Manual

After selecting the language (English for example).
You have to select TARGET TYPE (GOLD NATURAL for example)
Choose the Front Range according to the area you want to reach you can select
between
(0500-1000 -1500 -2000)M

English User Manual


English User Manual

After selecting the Front Range, the search screen will appear which contain an
indicator, which will start to move, and the device will start to issue a peep sound,
which is the signal.
Transmitter conforming means that the device works correctly.
When you reach the target, the device will turn back.
That means you just pass the target; you will stop and point the target in 1 M
square.

English User Manual

Increase the length of the signal recipient antennas to enable the device to detect the
target even to 2000 meters.
NORTH TO SOUTH
SOUTH TO NORTH
EAST TO WEST
WEST TO EAST
After detecting the target, confirm the target from four directions.

English User Manual

To determine the depth of the discovered target, stand above the target
and turn
45 degrees angle to the right or left.
Walk straight ahead until the antenna reverses back.

English User Manual

Measure the distance between the antennas reversing back and the target
center point.
The distance between the antennas reversing back and the center point is
equal to the target depth for example, if the distance is
10 m the depth of
the target is
10 m.
Note: The target must be buried underground for many years so that by the time and
interaction with the soil’s composition, an ionic field will be formed which will help prospectors
to detect the target.
Therefore, testing the device on metals laid on the ground or newly buried under the ground
will not show the real capacity and functionality of this device to detect the target or to reach
larger depths.
The reason for that is that the ionic fields are radiations from gold and other metals that have
been in the ground for a long time and have intersected and interacted with the soil and the
nature of the earth as well as having been regulated with magnetic fields north and south –
These features do not actualize in gold and other metals when they exist on the ground or
newly buried.

English User Manual

Warning
If you want the device to work well without errors you have to follow the next steps.
When using the device please do not wear the watch
When using the device please do not wear the jewelry
Please take off the belt
The shoes should not contain any metal
Stay away from the car
We wish you the best
of luck in your
searching
Thanks for choosing
our products
When using the device please get away from metal, lighter and mobile phone
Stay away from electrical ground power lines or any surfacing electric