Glide Gear G2H 100 User manual

G2H 100
USER MANUAL

For more informaon please visit our website: www.glidegear.net
What’s included?
Main Frame (A)
Camera Plate (E)
Camera Rails (B)
Vercal Rail x2 (C)
Rail Cap x2 (D)
Handle (F)

Assembly
Aach the Vercal Rails (C) to the ends of the Camera Rails (B) as shown in Fig. 1.
Make sure to insert the Vercal Rails (C) so that the measurements are in the cor-
rect orientaon.
1
Fig. 1
2
Fig. 2
Slide the Vercal Rails (C) onto the clamps located at the end of each arm
of the Main Frame (A).
Make sure that the Main Frame (A) wooden handles are facing away from
the frame’s arms as pictured in Fig. 2.
3
You can now mount your camera onto the Camera Plate (E).
Fig. 3
For more informaon please visit our website: www.glidegear.net
4
Screw the Rail Caps (D) at the
end of each Vercal Rails (C) as
shown in Fig. 3.

Adjustments
Move the Camera Plate (E) along the Camera
Rails (B) to balance the camera’s roll axis
Move the Main Frame (A) along
the Vercal Rails (C) to balance
the camera’s lt axis
Lock Main Frame (A) into
posion using the thumb-
screws
For more informaon please visit our website: www.glidegear.net
Move the Camera
Plate (E) back and
forward to balance
the camera’s lt axis

Using the G2H 100 with a vest and arm system
For more informaon please visit our
website: www.glidegear.net
PLEASE NOTE that the G2H 100 needs to be used in combinaon with a
Vest and Arm system and is compable with any vest and arm system
with a pin diameter smaller than 7/8” or 22.5mm
To use the G2H 100 with your vest and arm system, simply slide the
arm’s pin inside the G2H 100 handle (F) as shown in Fig. 4
The G2G 1000 Vest can be used with the arm mounted to
the front of the vest as it is usually the case but can also be
used with the arm mounted to the back of the vest as it is
the case in Fig. 5 which also features the G2H 100.
Glide Gear recommends using The G2H 100 with the G2G 1000 Vest.
Fig. 4
Fig. 5